[ [PATCH v2] 05/13] virtio: change io_base datatype from uint32_t to uint64_type

[Santosh Shukla <sshukla@mvista.com>]

In x86 case io_base to store ioport address not more than 65535 ioports. i.e..0
to ffff but in non-x86 case in particular arm64 it need to store more than 32
bit address so changing io_base datatype from 32 to 64.

Signed-off-by: Santosh Shukla <sshukla@mvista.com>
---
 drivers/net/virtio/virtio_ethdev.c |    2 +-
 drivers/net/virtio/virtio_pci.h    |    4 ++--
 2 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/virtio/virtio_ethdev.c b/drivers/net/virtio/virtio_ethdev.c
index d928339..620e0d4 100644
--- a/drivers/net/virtio/virtio_ethdev.c
+++ b/drivers/net/virtio/virtio_ethdev.c
@@ -1291,7 +1291,7 @@ eth_virtio_dev_init(struct rte_eth_dev *eth_dev)
 		return -1;
 
 	hw->use_msix = virtio_has_msix(&pci_dev->addr);
-	hw->io_base = (uint32_t)(uintptr_t)pci_dev->mem_resource[0].addr;
+	hw->io_base = (uint64_t)(uintptr_t)pci_dev->mem_resource[0].addr;
 
 	/* Reset the device although not necessary at startup */
 	vtpci_reset(hw);
diff --git a/drivers/net/virtio/virtio_pci.h b/drivers/net/virtio/virtio_pci.h
index 3f4ff80..f3e4178 100644
--- a/drivers/net/virtio/virtio_pci.h
+++ b/drivers/net/virtio/virtio_pci.h
@@ -169,7 +169,7 @@ struct virtqueue;
 
 struct virtio_hw {
 	struct virtqueue *cvq;
-	uint32_t    io_base;
+	uint64_t    io_base;
 	uint32_t    guest_features;
 	uint32_t    max_tx_queues;
 	uint32_t    max_rx_queues;
@@ -231,7 +231,7 @@ outl_p(unsigned int data, unsigned int port)
 #endif
 
 #define VIRTIO_PCI_REG_ADDR(hw, reg) \
-	(unsigned short)((hw)->io_base + (reg))
+	(unsigned long)((hw)->io_base + (reg))
 
 #define VIRTIO_READ_REG_1(hw, reg) \
 	inb((VIRTIO_PCI_REG_ADDR((hw), (reg))))
-- 
1.7.9.5