> -----Original Message----- > From: Bastien Nocera [mailto:hadess@hadess.net] > Sent: 19 November, 2015 17:25 > To: Tirdea, Irina; Dmitry Torokhov; Aleksei Mamlin; Karsten Merker; linux-input@vger.kernel.org > Cc: Mark Rutland; Rob Herring; Purdila, Octavian; linux-kernel@vger.kernel.org; devicetree@vger.kernel.org > Subject: Re: [PATCH v11 2/8] Input: goodix - reset device at init > > On Thu, 2015-11-19 at 14:26 +0200, Irina Tirdea wrote: > > After power on, it is recommended that the driver resets the device. > > The reset procedure timing is described in the datasheet and is used > > at device init (before writing device configuration) and > > for power management. It is a sequence of setting the interrupt > > and reset pins high/low at specific timing intervals. This procedure > > also includes setting the slave address to the one specified in the > > ACPI/device tree. > > This fails on a 4.3 kernel with an ACPI device (WinBook TW100): > Goodix-TS: probe of i2c-GDIX1001:00 failed with error -16 > > Can you please document which upstream commit is necessary to make this > behave properly? > You need the patch that fixes the GPIO API [1] so that devm_gpiod_get_optional works properly (I mentioned that in the cover letter). This patch just got merged in the gpio tree, so it will take a while until it will be merged in the main kernel tree or input tree. Thanks, Irina [1] https://lkml.org/lkml/2015/11/11/465 > I'll test again with a newer kernel. > > Cheers {.n++%ݶw{.n+{G{ayʇڙ,jfhz_(階ݢj"mG?&~iOzv^m ?I