Re: [RESEND PATCH V4 4/8] arm64: dts: qcom: pm8350c: Add temp-alarm support

[skakit@codeaurora.org]

On 2021-05-18 17:18, Vinod Koul wrote:
> On 18-05-21, 11:50, satya priya wrote:
>> Add temp-alarm node for PM8350C pmic and also modify gpio
>> node to add gpio ranges and "qcom,spmi-gpio" compatible.
> 
> These should be two patches explaining why things are done like that
> 

Okay, will split them.

>> 
>> Signed-off-by: satya priya <skakit@codeaurora.org>
>> Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
>> ---
>> Changes in RESEND V4:
>>  - No Changes.
>> 
>>  arch/arm64/boot/dts/qcom/pm8350c.dtsi | 32 
>> +++++++++++++++++++++++++++++++-
>>  1 file changed, 31 insertions(+), 1 deletion(-)
>> 
>> diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi 
>> b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> index 2b9b75e..e1b75ae 100644
>> --- a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> +++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
>> @@ -13,13 +13,43 @@
>>  		#address-cells = <1>;
>>  		#size-cells = <0>;
>> 
>> +		pm8350c_temp_alarm: temp-alarm@a00 {
>> +			compatible = "qcom,spmi-temp-alarm";
>> +			reg = <0xa00>;
>> +			interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
>> +			#thermal-sensor-cells = <0>;
>> +		};
>> +
>>  		pm8350c_gpios: gpio@8800 {
>> -			compatible = "qcom,pm8350c-gpio";
>> +			compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
> 
> why is this changed?

As per the Documentation[1], either "qcom,spmi-gpio" or "qcom,ssbi-gpio" 
must be added based on whether the device is on an spmi bus or an ssbi 
bus respectively.

[1] 
https://github.com/torvalds/linux/blob/master/Documentation/devicetree/bindings/pinctrl/qcom%2Cpmic-gpio.txt#L41

> 
>>  			reg = <0x8800>;
>>  			gpio-controller;
>> +			gpio-ranges = <&pm8350c_gpios 0 0 9>;
>>  			#gpio-cells = <2>;
>>  			interrupt-controller;
>>  			#interrupt-cells = <2>;
>>  		};
>>  	};
>>  };
>> +
>> +&thermal_zones {
>> +	pm8350c_thermal: pm8350c-thermal {
>> +		polling-delay-passive = <100>;
>> +		polling-delay = <0>;
>> +		thermal-sensors = <&pm8350c_temp_alarm>;
>> +
>> +		trips {
>> +			pm8350c_trip0: trip0 {
>> +				temperature = <95000>;
>> +				hysteresis = <0>;
>> +				type = "passive";
>> +			};
>> +
>> +			pm8350c_crit: pm8350c-crit {
>> +				temperature = <115000>;
>> +				hysteresis = <0>;
>> +				type = "critical";
>> +			};
>> +		};
>> +	};
>> +};
>> --
>> QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a 
>> member
>> of Code Aurora Forum, hosted by The Linux Foundation