intel-gfx.lists.freedesktop.org archive mirror
 help / color / mirror / Atom feed
From: Chris Wilson <chris@chris-wilson.co.uk>
To: intel-gfx@lists.freedesktop.org
Subject: [PATCH 03/16] drm/i915: Fix detection of base of stolen memory
Date: Thu, 15 Nov 2012 11:32:18 +0000	[thread overview]
Message-ID: <1352979151-9934-4-git-send-email-chris@chris-wilson.co.uk> (raw)
In-Reply-To: <1352979151-9934-1-git-send-email-chris@chris-wilson.co.uk>

The routine to query the base of stolen memory was using the wrong
registers and the wrong encodings on virtually every platform.

It was not until the G33 refresh, that a PCI config register was
introduced that explicitly said where the stolen memory was. Prior to
865G there was not even a register that said where the end of usable
low memory was and where the stolen memory began (or ended depending
upon chipset). Before then, one has to look at the BIOS memory maps to
find the Top of Memory. Alas that is not exported by arch/x86 and so we
have to resort to disabling stolen memory on gen2 for the time being.

Then SandyBridge enlarged the PCI register to a full 32-bits and change
the encoding of the address, so even though we happened to be querying
the right register, we read the wrong bits and ended up using address 0
for our stolen data, i.e. notably FBC.

Signed-off-by: Chris Wilson <chris@chris-wilson.co.uk>
---
 drivers/gpu/drm/i915/i915_drv.h        |    1 +
 drivers/gpu/drm/i915/i915_gem_stolen.c |   81 ++++++++++++++++----------------
 2 files changed, 42 insertions(+), 40 deletions(-)

diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index db6d71c..500066a 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -765,6 +765,7 @@ typedef struct drm_i915_private {
 		unsigned long gtt_start;
 		unsigned long gtt_mappable_end;
 		unsigned long gtt_end;
+		unsigned long stolen_base; /* limited to low memory (32-bit) */
 
 		struct io_mapping *gtt_mapping;
 		phys_addr_t gtt_base_addr;
diff --git a/drivers/gpu/drm/i915/i915_gem_stolen.c b/drivers/gpu/drm/i915/i915_gem_stolen.c
index 8e91083..be24312 100644
--- a/drivers/gpu/drm/i915/i915_gem_stolen.c
+++ b/drivers/gpu/drm/i915/i915_gem_stolen.c
@@ -42,56 +42,50 @@
  * for is a boon.
  */
 
-#define PTE_ADDRESS_MASK		0xfffff000
-#define PTE_ADDRESS_MASK_HIGH		0x000000f0 /* i915+ */
-#define PTE_MAPPING_TYPE_UNCACHED	(0 << 1)
-#define PTE_MAPPING_TYPE_DCACHE		(1 << 1) /* i830 only */
-#define PTE_MAPPING_TYPE_CACHED		(3 << 1)
-#define PTE_MAPPING_TYPE_MASK		(3 << 1)
-#define PTE_VALID			(1 << 0)
-
-/**
- * i915_stolen_to_phys - take an offset into stolen memory and turn it into
- *                       a physical one
- * @dev: drm device
- * @offset: address to translate
- *
- * Some chip functions require allocations from stolen space and need the
- * physical address of the memory in question.
- */
-static unsigned long i915_stolen_to_phys(struct drm_device *dev, u32 offset)
+static unsigned long i915_stolen_to_physical(struct drm_device *dev)
 {
 	struct drm_i915_private *dev_priv = dev->dev_private;
 	struct pci_dev *pdev = dev_priv->bridge_dev;
 	u32 base;
 
-#if 0
 	/* On the machines I have tested the Graphics Base of Stolen Memory
-	 * is unreliable, so compute the base by subtracting the stolen memory
-	 * from the Top of Low Usable DRAM which is where the BIOS places
-	 * the graphics stolen memory.
+	 * is unreliable, so on those compute the base by subtracting the
+	 * stolen memory from the Top of Low Usable DRAM which is where the
+	 * BIOS places the graphics stolen memory.
+	 *
+	 * On gen2, the layout is slightly different with the Graphics Segment
+	 * immediately following Top of Memory (or Top of Usable DRAM). Note
+	 * it appears that TOUD is only reported by 865g, so we just use the
+	 * top of memory as determined by the e820 probe.
+	 *
+	 * XXX gen2 requires an unavailable symbol and 945gm fails with
+	 * its value of TOLUD.
 	 */
-	if (INTEL_INFO(dev)->gen > 3 || IS_G33(dev)) {
-		/* top 32bits are reserved = 0 */
+	base = 0;
+	if (INTEL_INFO(dev)->gen >= 6) {
+		/* Read Base Data of Stolen Memory Register (BDSM) directly.
+		 * Note that there is also a MCHBAR miror at 0x1080c0 or
+		 * we could use device 2:0x5c instead.
+		*/
+		pci_read_config_dword(pdev, 0xB0, &base);
+		base &= ~4095; /* lower bits used for locking register */
+	} else if (INTEL_INFO(dev)->gen > 3 || IS_G33(dev)) {
+		/* Read Graphics Base of Stolen Memory directly */
 		pci_read_config_dword(pdev, 0xA4, &base);
-	} else {
-		/* XXX presume 8xx is the same as i915 */
-		pci_bus_read_config_dword(pdev->bus, 2, 0x5C, &base);
-	}
-#else
-	if (INTEL_INFO(dev)->gen > 3 || IS_G33(dev)) {
-		u16 val;
-		pci_read_config_word(pdev, 0xb0, &val);
-		base = val >> 4 << 20;
-	} else {
+#if 0
+	} else if (IS_GEN3(dev)) {
 		u8 val;
+		/* Stolen is immediately below Top of Low Usable DRAM */
 		pci_read_config_byte(pdev, 0x9c, &val);
 		base = val >> 3 << 27;
-	}
-	base -= dev_priv->mm.gtt->stolen_size;
+		base -= dev_priv->mm.gtt->stolen_size;
+	} else {
+		/* Stolen is immediately above Top of Memory */
+		base = max_low_pfn_mapped << PAGE_SHIFT;
 #endif
+	}
 
-	return base + offset;
+	return base;
 }
 
 static void i915_warn_stolen(struct drm_device *dev)
@@ -116,7 +110,7 @@ static void i915_setup_compression(struct drm_device *dev, int size)
 	if (!compressed_fb)
 		goto err;
 
-	cfb_base = i915_stolen_to_phys(dev, compressed_fb->start);
+	cfb_base = dev_priv->mm.stolen_base + compressed_fb->start;
 	if (!cfb_base)
 		goto err_fb;
 
@@ -129,7 +123,7 @@ static void i915_setup_compression(struct drm_device *dev, int size)
 		if (!compressed_llb)
 			goto err_fb;
 
-		ll_base = i915_stolen_to_phys(dev, compressed_llb->start);
+		ll_base = dev_priv->mm.stolen_base + compressed_llb->start;
 		if (!ll_base)
 			goto err_llb;
 	}
@@ -148,7 +142,7 @@ static void i915_setup_compression(struct drm_device *dev, int size)
 	}
 
 	DRM_DEBUG_KMS("FBC base 0x%08lx, ll base 0x%08lx, size %dM\n",
-		      cfb_base, ll_base, size >> 20);
+		      (long)cfb_base, (long)ll_base, size >> 20);
 	return;
 
 err_llb:
@@ -180,6 +174,13 @@ int i915_gem_init_stolen(struct drm_device *dev)
 	struct drm_i915_private *dev_priv = dev->dev_private;
 	unsigned long prealloc_size = dev_priv->mm.gtt->stolen_size;
 
+	dev_priv->mm.stolen_base = i915_stolen_to_physical(dev);
+	if (dev_priv->mm.stolen_base == 0)
+		return 0;
+
+	DRM_DEBUG_KMS("found %d bytes of stolen memory at %08lx\n",
+		      dev_priv->mm.gtt->stolen_size, dev_priv->mm.stolen_base);
+
 	/* Basic memrange allocator for stolen space */
 	drm_mm_init(&dev_priv->mm.stolen, 0, prealloc_size);
 
-- 
1.7.10.4

  parent reply	other threads:[~2012-11-15 11:33 UTC|newest]

Thread overview: 26+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2012-11-15 11:32 Hopefully the last round of stolen work Chris Wilson
2012-11-15 11:32 ` [PATCH 01/16] drm: Introduce drm_mm_create_block() Chris Wilson
2012-11-15 11:32 ` [PATCH 02/16] drm: Introduce an iterator over holes in the drm_mm range manager Chris Wilson
2012-11-15 11:32 ` Chris Wilson [this message]
2012-11-15 11:32 ` [PATCH 04/16] drm/i915: Avoid clearing preallocated regions from the GTT Chris Wilson
2012-11-15 11:32 ` [PATCH 05/16] drm/i915: Delay allocation of stolen space for FBC Chris Wilson
2012-11-15 11:32 ` [PATCH 06/16] drm/i915: Allow objects to be created with no backing pages, but stolen space Chris Wilson
2012-11-15 11:32 ` [PATCH 07/16] drm/i915: Differentiate between prime and stolen objects Chris Wilson
2012-11-15 11:32 ` [PATCH 08/16] drm/i915: Support readback of stolen objects upon error Chris Wilson
2012-11-15 11:32 ` [PATCH 09/16] drm/i915: Handle stolen objects in pwrite Chris Wilson
2012-11-15 11:32 ` [PATCH 10/16] drm/i915: Handle stolen objects for pread Chris Wilson
2012-11-30 22:33   ` Daniel Vetter
2012-11-30 23:46     ` Chris Wilson
2012-12-01  0:03       ` Daniel Vetter
2012-12-01  0:14         ` Chris Wilson
2012-11-15 11:32 ` [PATCH 11/16] drm/i915: Introduce i915_gem_object_create_stolen() Chris Wilson
2012-11-15 11:32 ` [PATCH 12/16] drm/i915: Allocate fbcon from stolen memory Chris Wilson
2012-11-15 11:32 ` [PATCH 13/16] drm/i915: Allocate ringbuffers " Chris Wilson
2012-11-15 11:32 ` [PATCH 14/16] drm/i915: Allocate overlay registers " Chris Wilson
2012-11-15 11:32 ` [PATCH 15/16] drm/i915: Use a slab for object allocation Chris Wilson
2012-11-30 22:45   ` Daniel Vetter
2012-11-15 11:32 ` [PATCH 16/16] drm/i915: Introduce mapping of user pages into video memory (userptr) ioctl Chris Wilson
2012-11-30 23:06   ` Daniel Vetter
2012-11-30 23:57     ` Chris Wilson
2012-12-01 11:25     ` Chris Wilson
2012-12-01 11:35       ` Daniel Vetter

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1352979151-9934-4-git-send-email-chris@chris-wilson.co.uk \
    --to=chris@chris-wilson.co.uk \
    --cc=intel-gfx@lists.freedesktop.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).