From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Sasha Levin <sashal@kernel.org>,
devicetree@vger.kernel.org,
Andrey Smirnov <andrew.smirnov@gmail.com>,
Shawn Guo <shawnguo@kernel.org>, Chris Healy <cphealy@gmail.com>,
Fabio Estevam <festevam@gmail.com>,
linux-arm-kernel@lists.infradead.org,
Lucas Stach <l.stach@pengutronix.de>
Subject: [PATCH AUTOSEL 4.19 088/252] ARM: dts: imx6: rdu2: Disable WP for USDHC2 and USDHC3
Date: Fri, 14 Feb 2020 11:09:03 -0500 [thread overview]
Message-ID: <20200214161147.15842-88-sashal@kernel.org> (raw)
In-Reply-To: <20200214161147.15842-1-sashal@kernel.org>
From: Andrey Smirnov <andrew.smirnov@gmail.com>
[ Upstream commit cd58a174e58649426fb43d7456e5f7d7eab58af1 ]
RDU2 production units come with resistor connecting WP pin to
correpsonding GPIO DNPed for both SD card slots. Drop any WP related
configuration and mark both slots with "disable-wp".
Reported-by: Chris Healy <cphealy@gmail.com>
Reviewed-by: Chris Healy <cphealy@gmail.com>
Reviewed-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
Cc: Shawn Guo <shawnguo@kernel.org>
Cc: Fabio Estevam <festevam@gmail.com>
Cc: Lucas Stach <l.stach@pengutronix.de>
Cc: linux-arm-kernel@lists.infradead.org
Cc: linux-kernel@vger.kernel.org
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
index 315d0e7615f33..56d6e82b75337 100644
--- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
@@ -657,7 +657,7 @@
pinctrl-0 = <&pinctrl_usdhc2>;
bus-width = <4>;
cd-gpios = <&gpio2 2 GPIO_ACTIVE_LOW>;
- wp-gpios = <&gpio2 3 GPIO_ACTIVE_HIGH>;
+ disable-wp;
vmmc-supply = <®_3p3v_sd>;
vqmmc-supply = <®_3p3v>;
no-1-8-v;
@@ -670,7 +670,7 @@
pinctrl-0 = <&pinctrl_usdhc3>;
bus-width = <4>;
cd-gpios = <&gpio2 0 GPIO_ACTIVE_LOW>;
- wp-gpios = <&gpio2 1 GPIO_ACTIVE_HIGH>;
+ disable-wp;
vmmc-supply = <®_3p3v_sd>;
vqmmc-supply = <®_3p3v>;
no-1-8-v;
@@ -1081,7 +1081,6 @@
MX6QDL_PAD_SD2_DAT1__SD2_DATA1 0x17059
MX6QDL_PAD_SD2_DAT2__SD2_DATA2 0x17059
MX6QDL_PAD_SD2_DAT3__SD2_DATA3 0x17059
- MX6QDL_PAD_NANDF_D3__GPIO2_IO03 0x40010040
MX6QDL_PAD_NANDF_D2__GPIO2_IO02 0x40010040
>;
};
@@ -1094,7 +1093,6 @@
MX6QDL_PAD_SD3_DAT1__SD3_DATA1 0x17059
MX6QDL_PAD_SD3_DAT2__SD3_DATA2 0x17059
MX6QDL_PAD_SD3_DAT3__SD3_DATA3 0x17059
- MX6QDL_PAD_NANDF_D1__GPIO2_IO01 0x40010040
MX6QDL_PAD_NANDF_D0__GPIO2_IO00 0x40010040
>;
--
2.20.1
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2020-02-14 16:40 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <20200214161147.15842-1-sashal@kernel.org>
2020-02-14 16:07 ` [PATCH AUTOSEL 4.19 004/252] soc: fsl: qe: change return type of cpm_muram_alloc() to s32 Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 028/252] arm64: cpufeature: Fix the type of no FP/SIMD capability Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 032/252] clocksource/drivers/bcm2835_timer: Fix memory leak of timer Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 037/252] scsi: ufs: Fix ufshcd_probe_hba() reture value in case ufshcd_scsi_add_wlus() fails Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 044/252] ARM: 8952/1: Disable kmemleak on XIP kernels Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 081/252] arm64: dts: allwinner: H6: Add PMU mode Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 082/252] arm: dts: allwinner: H3: Add PMU node Sasha Levin
2020-02-14 16:08 ` [PATCH AUTOSEL 4.19 083/252] ARM: dts: at91: Reenable UART TX pull-ups Sasha Levin
2020-02-14 16:09 ` Sasha Levin [this message]
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 089/252] ARM: dts: imx6: rdu2: Limit USBH1 to Full Speed Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 091/252] PCI: iproc: Apply quirk_paxc_bridge() for module as well as built-in Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 102/252] Revert "tty/serial: atmel: fix out of range clock divider handling" Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 113/252] drm/mediatek: handle events when enabling/disabling crtc Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 118/252] dmaengine: imx-sdma: Fix memory leak Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 125/252] reset: uniphier: Add SCSSI reset control for each channel Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 127/252] clk: sunxi-ng: add mux and pll notifiers for A64 CPU clock Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 129/252] clk: uniphier: Add SCSSI clock gate for each channel Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 137/252] soc: fsl: qe: remove set but not used variable 'mm_gc' Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 139/252] crypto: atmel-sha - fix error handling when setting hmac key Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 140/252] ARM: dts: stm32: Add power-supply for DSI panel on stm32f469-disco Sasha Levin
2020-02-14 16:09 ` [PATCH AUTOSEL 4.19 143/252] iommu/arm-smmu-v3: Populate VMID field for CMDQ_OP_TLBI_NH_VA Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 148/252] ARM: dts: at91: sama5d3: fix maximum peripheral clock rates Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 149/252] ARM: dts: at91: sama5d3: define clock rate range for tcb1 Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 155/252] ASoC: atmel: fix build error with CONFIG_SND_ATMEL_SOC_DMA=m Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 165/252] arm64: ptrace: nofpsimd: Fail FP/SIMD regset operations Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 177/252] iommu/arm-smmu-v3: Use WRITE_ONCE() when changing validity of an STE Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 181/252] arm64: fix alternatives with LLVM's integrated assembler Sasha Levin
2020-02-14 16:10 ` [PATCH AUTOSEL 4.19 186/252] ACPI/IORT: Fix 'Number of IDs' handling in iort_id_map() Sasha Levin
2020-02-14 16:11 ` [PATCH AUTOSEL 4.19 218/252] ARM: 8951/1: Fix Kexec compilation issue Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200214161147.15842-88-sashal@kernel.org \
--to=sashal@kernel.org \
--cc=andrew.smirnov@gmail.com \
--cc=cphealy@gmail.com \
--cc=devicetree@vger.kernel.org \
--cc=festevam@gmail.com \
--cc=l.stach@pengutronix.de \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=shawnguo@kernel.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).