From: Rob Herring <robh@kernel.org>
To: Krzysztof Kozlowski <krzk@kernel.org>
Cc: Alexandre Belloni <alexandre.belloni@bootlin.com>,
Liam Girdwood <lgirdwood@gmail.com>,
Michael Turquette <mturquette@baylibre.com>,
Angus Ainslie <angus@akkea.ca>,
Sebastian Reichel <sre@kernel.org>,
Iskren Chernev <iskren.chernev@gmail.com>,
Lee Jones <lee.jones@linaro.org>,
linux-clk@vger.kernel.org, linux-rtc@vger.kernel.org,
linux-samsung-soc@vger.kernel.org,
Matheus Castello <matheus@castello.eng.br>,
Chanwoo Choi <cw00.choi@samsung.com>,
Andy Gross <agross@kernel.org>,
devicetree@vger.kernel.org,
Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>,
linux-arm-msm@vger.kernel.org,
Hans de Goede <hdegoede@redhat.com>,
Mark Brown <broonie@kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
linux-arm-kernel@lists.infradead.org,
Alessandro Zummo <a.zummo@towertech.it>,
Stephen Boyd <sboyd@kernel.org>,
linux-pm@vger.kernel.org, linux-kernel@vger.kernel.org,
Rob Herring <robh+dt@kernel.org>,
Sebastian Krzyszkowiak <sebastian.krzyszkowiak@puri.sm>
Subject: Re: [RFC 17/18] mfd: max14577: Do not enforce (incorrect) interrupt trigger type
Date: Mon, 21 Dec 2020 11:47:07 -0700 [thread overview]
Message-ID: <20201221184707.GA344409@robh.at.kernel.org> (raw)
In-Reply-To: <20201210212534.216197-17-krzk@kernel.org>
On Thu, 10 Dec 2020 22:25:33 +0100, Krzysztof Kozlowski wrote:
> Interrupt line can be configured on different hardware in different way,
> even inverted. Therefore driver should not enforce specific trigger
> type - edge falling - but instead rely on Devicetree to configure it.
>
> The Maxim 14577/77836 datasheets describe the interrupt line as active
> low with a requirement of acknowledge from the CPU therefore the edge
> falling is not correct.
>
> The interrupt line is shared between PMIC and charger driver, so using
> level sensitive interrupt is here especially important to avoid races.
> With an edge configuration in case if first PMIC signals interrupt
> followed shortly after by the RTC, the interrupt might not be yet
> cleared/acked thus the second one would not be noticed.
>
> Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
>
> ---
>
> This patch should wait till DTS changes are merged, as it relies on
> proper Devicetree.
> ---
> Documentation/devicetree/bindings/mfd/max14577.txt | 4 ++--
> drivers/mfd/max14577.c | 6 +++---
> 2 files changed, 5 insertions(+), 5 deletions(-)
>
Acked-by: Rob Herring <robh@kernel.org>
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2020-12-21 18:48 UTC|newest]
Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-12-10 21:25 [PATCH 01/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on GT-I9100 Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 02/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on P4 Note family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 03/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on Midas family Krzysztof Kozlowski
2020-12-29 15:43 ` Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 04/18] ARM: dts: exynos: correct MUIC " Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 05/18] ARM: dts: exynos: correct PMIC " Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 06/18] ARM: dts: exynos: correct PMIC interrupt trigger level on Odroid X/U3 family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 07/18] ARM: dts: exynos: correct PMIC interrupt trigger level on P4 Note family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 08/18] ARM: dts: exynos: correct PMIC interrupt trigger level on SMDK5250 Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 09/18] ARM: dts: exynos: correct PMIC interrupt trigger level on Snow Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 10/18] ARM: dts: s5pv210: correct fuel gauge interrupt trigger level on Fascinate family Krzysztof Kozlowski
2020-12-10 21:25 ` [PATCH 11/18] ARM: dts: qcom: msm8974-lge-nexus5: correct fuel gauge interrupt trigger level Krzysztof Kozlowski
2020-12-11 15:29 ` Iskren Chernev
2020-12-10 21:25 ` [PATCH 12/18] ARM: dts: qcom: msm8974-samsung-klte: " Krzysztof Kozlowski
2020-12-11 15:25 ` Iskren Chernev
2020-12-10 21:25 ` [RFC 13/18] mfd: max77686: Do not enforce (incorrect) interrupt trigger type Krzysztof Kozlowski
2020-12-21 18:45 ` Rob Herring
2020-12-10 21:25 ` [RFC 14/18] rtc: " Krzysztof Kozlowski
2020-12-10 21:25 ` [RFC 15/18] mfd: max77693: " Krzysztof Kozlowski
2020-12-21 18:46 ` Rob Herring
2020-12-10 21:25 ` [RFC 16/18] power: supply: max17042: " Krzysztof Kozlowski
2020-12-10 21:25 ` [RFC 17/18] mfd: max14577: " Krzysztof Kozlowski
2020-12-21 18:47 ` Rob Herring [this message]
2020-12-10 21:25 ` [RFC 18/18] power: supply: max17040: " Krzysztof Kozlowski
2020-12-11 7:47 ` Krzysztof Kozlowski
2020-12-11 15:44 ` Iskren Chernev
2020-12-11 15:51 ` Krzysztof Kozlowski
2021-03-03 18:19 ` [PATCH 01/18] ARM: dts: exynos: correct fuel gauge interrupt trigger level on GT-I9100 Krzysztof Kozlowski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20201221184707.GA344409@robh.at.kernel.org \
--to=robh@kernel.org \
--cc=a.zummo@towertech.it \
--cc=agross@kernel.org \
--cc=alexandre.belloni@bootlin.com \
--cc=angus@akkea.ca \
--cc=b.zolnierkie@samsung.com \
--cc=bjorn.andersson@linaro.org \
--cc=broonie@kernel.org \
--cc=cw00.choi@samsung.com \
--cc=devicetree@vger.kernel.org \
--cc=hdegoede@redhat.com \
--cc=iskren.chernev@gmail.com \
--cc=krzk@kernel.org \
--cc=lee.jones@linaro.org \
--cc=lgirdwood@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-rtc@vger.kernel.org \
--cc=linux-samsung-soc@vger.kernel.org \
--cc=matheus@castello.eng.br \
--cc=mturquette@baylibre.com \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
--cc=sebastian.krzyszkowiak@puri.sm \
--cc=sre@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).