From: Jonathan Marek <jonathan@marek.ca>
To: linux-arm-msm@vger.kernel.org
Cc: robert.foss@linaro.org, andrey.konovalov@linaro.org,
Andy Gross <agross@kernel.org>,
Bjorn Andersson <bjorn.andersson@linaro.org>,
devicetree@vger.kernel.org (open list:OPEN FIRMWARE AND
FLATTENED DEVICE TREE BINDINGS),
Hans Verkuil <hverkuil-cisco@xs4all.nl>,
linux-kernel@vger.kernel.org (open list),
linux-media@vger.kernel.org (open list:QUALCOMM CAMERA SUBSYSTEM
DRIVER), Mauro Carvalho Chehab <mchehab@kernel.org>,
Rob Herring <robh+dt@kernel.org>,
Todor Tomov <todor.too@gmail.com>
Subject: [PATCH 00/17] CAMSS: SM8250 support (and some fixes)
Date: Tue, 11 May 2021 14:07:07 -0400 [thread overview]
Message-ID: <20210511180728.23781-1-jonathan@marek.ca> (raw)
This adds initial support for SM8250 and its 4 VFEs and 6 CSIPHYs.
The only big change is the added camss-vfe-480.c to support the
Titan 480 VFE.
Jonathan Marek (17):
media: camss: csiphy-3ph: don't print HW version as an error
media: camss: csiphy-3ph: disable interrupts
media: camss: csiphy-3ph: add support for SM8250 CSI DPHY
media: camss: csid-170: fix non-10bit formats
media: camss: csid-170: don't enable unused irqs
media: camss: csid-170: remove stray comment
media: camss: csid-170: support more than one lite vfe
media: camss: csid-170: set the right HALF_CMD when disabled
media: camss: csid: allow csid to work without a regulator
media: camss: remove vdda-csiN from sdm845 resources
media: camss: fix VFE irq name
media: camss: vfe-170: clean up some dead code
media: camss: vfe-170: fix "VFE halt timeout" error
media: camss: Add initial support for VFE hardware version Titan 480
media: camss: add support for V4L2_PIX_FMT_GREY for sdm845 HW
media: camss: add support for SM8250 camss
media: dt-bindings: media: camss: Add qcom,sm8250-camss binding
.../bindings/media/qcom,sm8250-camss.yaml | 398 +++++++++++++
drivers/media/platform/qcom/camss/Makefile | 1 +
.../platform/qcom/camss/camss-csid-170.c | 31 +-
.../media/platform/qcom/camss/camss-csid.c | 39 +-
.../qcom/camss/camss-csiphy-3ph-1-0.c | 181 ++++--
.../media/platform/qcom/camss/camss-csiphy.c | 9 +-
.../media/platform/qcom/camss/camss-vfe-170.c | 65 +-
.../media/platform/qcom/camss/camss-vfe-480.c | 554 ++++++++++++++++++
drivers/media/platform/qcom/camss/camss-vfe.c | 13 +-
drivers/media/platform/qcom/camss/camss-vfe.h | 1 +
.../media/platform/qcom/camss/camss-video.c | 5 +-
drivers/media/platform/qcom/camss/camss.c | 202 ++++++-
drivers/media/platform/qcom/camss/camss.h | 1 +
13 files changed, 1352 insertions(+), 148 deletions(-)
create mode 100644 Documentation/devicetree/bindings/media/qcom,sm8250-camss.yaml
create mode 100644 drivers/media/platform/qcom/camss/camss-vfe-480.c
--
2.26.1
next reply other threads:[~2021-05-11 18:08 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-05-11 18:07 Jonathan Marek [this message]
2021-05-11 18:07 ` [PATCH 01/17] media: camss: csiphy-3ph: don't print HW version as an error Jonathan Marek
2021-05-19 10:16 ` Robert Foss
2021-05-11 18:07 ` [PATCH 02/17] media: camss: csiphy-3ph: disable interrupts Jonathan Marek
2021-05-19 15:52 ` Robert Foss
2021-05-11 18:07 ` [PATCH 03/17] media: camss: csiphy-3ph: add support for SM8250 CSI DPHY Jonathan Marek
2021-05-19 16:26 ` Robert Foss
2021-05-25 17:19 ` Andrey Konovalov
2021-05-25 17:35 ` Andrey Konovalov
2021-05-11 18:07 ` [PATCH 04/17] media: camss: csid-170: fix non-10bit formats Jonathan Marek
2021-05-20 10:31 ` Robert Foss
2021-05-25 18:15 ` Andrey Konovalov
2021-05-25 18:38 ` Jonathan Marek
2021-05-26 13:59 ` Andrey Konovalov
2021-05-11 18:07 ` [PATCH 05/17] media: camss: csid-170: don't enable unused irqs Jonathan Marek
2021-05-20 10:39 ` Robert Foss
2021-05-11 18:07 ` [PATCH 06/17] media: camss: csid-170: remove stray comment Jonathan Marek
2021-05-20 10:57 ` Robert Foss
2021-05-11 18:07 ` [PATCH 07/17] media: camss: csid-170: support more than one lite vfe Jonathan Marek
2021-05-20 11:54 ` Robert Foss
2021-05-11 18:07 ` [PATCH 08/17] media: camss: csid-170: set the right HALF_CMD when disabled Jonathan Marek
2021-05-20 11:10 ` Robert Foss
2021-05-11 18:07 ` [PATCH 09/17] media: camss: csid: allow csid to work without a regulator Jonathan Marek
2021-05-20 12:14 ` Robert Foss
2021-05-11 18:07 ` [PATCH 10/17] media: camss: remove vdda-csiN from sdm845 resources Jonathan Marek
2021-05-31 11:02 ` Robert Foss
2021-05-11 18:07 ` [PATCH 11/17] media: camss: fix VFE irq name Jonathan Marek
2021-05-31 11:03 ` Robert Foss
2021-05-11 18:07 ` [PATCH 12/17] media: camss: vfe-170: clean up some dead code Jonathan Marek
2021-05-31 11:11 ` Robert Foss
2021-05-11 18:07 ` [PATCH 13/17] media: camss: vfe-170: fix "VFE halt timeout" error Jonathan Marek
2021-05-31 11:13 ` Robert Foss
2021-05-11 18:07 ` [PATCH 14/17] media: camss: Add initial support for VFE hardware version Titan 480 Jonathan Marek
2021-05-31 12:13 ` Robert Foss
2021-06-08 23:08 ` Jonathan Marek
2021-06-09 15:06 ` Robert Foss
2021-05-11 18:07 ` [PATCH 15/17] media: camss: add support for V4L2_PIX_FMT_GREY for sdm845 HW Jonathan Marek
2021-05-31 12:14 ` Robert Foss
2021-05-11 18:07 ` [PATCH 16/17] media: camss: add support for SM8250 camss Jonathan Marek
2021-05-31 16:07 ` Robert Foss
2021-05-11 18:07 ` [PATCH 17/17] media: dt-bindings: media: camss: Add qcom,sm8250-camss binding Jonathan Marek
2021-05-12 18:35 ` Rob Herring
2021-06-08 22:34 [PATCH 00/17] CAMSS: SM8250 support (and some fixes) Jonathan Marek
2021-06-16 18:16 ` Andrey Konovalov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20210511180728.23781-1-jonathan@marek.ca \
--to=jonathan@marek.ca \
--cc=agross@kernel.org \
--cc=andrey.konovalov@linaro.org \
--cc=bjorn.andersson@linaro.org \
--cc=devicetree@vger.kernel.org \
--cc=hverkuil-cisco@xs4all.nl \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=mchehab@kernel.org \
--cc=robert.foss@linaro.org \
--cc=robh+dt@kernel.org \
--cc=todor.too@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).