From: Tony Lindgren <tony@atomide.com>
To: Sebastian Reichel <sre@kernel.org>
Cc: Mauro Carvalho Chehab <mchehab@kernel.org>,
Marcel Holtmann <marcel@holtmann.org>,
Rob Herring <robh@kernel.org>,
Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
Pavel Machek <pavel@ucw.cz>,
linux-bluetooth@vger.kernel.org, linux-media@vger.kernel.org,
linux-omap@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH 00/14] Add support for FM radio in hcill and kill TI_ST
Date: Fri, 21 Dec 2018 10:02:05 -0800 [thread overview]
Message-ID: <20181221180205.GH6707@atomide.com> (raw)
In-Reply-To: <20181221011752.25627-1-sre@kernel.org>
* Sebastian Reichel <sre@kernel.org> [181221 01:18]:
> The new code has been tested on the Motorola Droid 4. For testing the audio
> should be configured to route Ext to Speaker or Headphone. Then you need to
> plug headphone, since its cable is used as antenna. For testing there is a
> 'radio' utility packages in Debian. When you start the utility you need to
> specify a frequency, since initial get_frequency returns an error:
Nice, good to see that ti-st kim stuff gone :) I gave this a quick
try using fmtools.git and fmscan works just fine. No luck yet with
fm though, it gives VIDIOC_G_CTRL: Not a tty error somehow so
maybe I'm missing some options, patch below for omap2plus_defconfig.
Hmm so looks like nothing to configure for the clocks or
CPCAP_BIT_ST_L_TIMESLOT bits for cap for the EXT? So the
wl12xx audio is wired directly to cpcap EXT then and not a
TDM slot on the mcbsp huh?
> Merry Christmas!
Same to you!
Tony
8< --------------------------------
From tony Mon Sep 17 00:00:00 2001
From: Tony Lindgren <tony@atomide.com>
Date: Fri, 21 Dec 2018 07:57:09 -0800
Subject: [PATCH] ARM: omap2plus_defconfig: Add RADIO_WL128X as a loadable
module
This allows using the FM radio in the wl12xx chips after modprobe
fm_drv using radio from xawt, or fmtools.
Note that the firmware placed into /lib/firmware/ti-connectivity
directory:
fm_rx_ch8_1283.2.bts
fmc_ch8_1283.2.bts
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
arch/arm/configs/omap2plus_defconfig | 3 +++
1 file changed, 3 insertions(+)
diff --git a/arch/arm/configs/omap2plus_defconfig b/arch/arm/configs/omap2plus_defconfig
--- a/arch/arm/configs/omap2plus_defconfig
+++ b/arch/arm/configs/omap2plus_defconfig
@@ -126,6 +126,7 @@ CONFIG_AF_RXRPC=m
CONFIG_RXKAD=y
CONFIG_CFG80211=m
CONFIG_MAC80211=m
+CONFIG_RFKILL=m
CONFIG_DEVTMPFS=y
CONFIG_DEVTMPFS_MOUNT=y
CONFIG_DMA_CMA=y
@@ -343,12 +344,14 @@ CONFIG_IR_GPIO_TX=m
CONFIG_IR_PWM_TX=m
CONFIG_MEDIA_SUPPORT=m
CONFIG_MEDIA_CAMERA_SUPPORT=y
+CONFIG_MEDIA_RADIO_SUPPORT=y
CONFIG_MEDIA_CEC_SUPPORT=y
CONFIG_MEDIA_CONTROLLER=y
CONFIG_VIDEO_V4L2_SUBDEV_API=y
CONFIG_V4L_PLATFORM_DRIVERS=y
CONFIG_VIDEO_OMAP3=m
CONFIG_CEC_PLATFORM_DRIVERS=y
+CONFIG_RADIO_WL128X=m
# CONFIG_MEDIA_SUBDRV_AUTOSELECT is not set
CONFIG_VIDEO_TVP5150=m
CONFIG_DRM=m
--
2.19.2
next prev parent reply other threads:[~2018-12-21 18:02 UTC|newest]
Thread overview: 48+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-12-21 1:17 [PATCH 00/14] Add support for FM radio in hcill and kill TI_ST Sebastian Reichel
2018-12-21 1:17 ` [PATCH 01/14] ARM: dts: LogicPD Torpedo: Add WiLink UART node Sebastian Reichel
2018-12-21 20:05 ` Adam Ford
2018-12-21 1:17 ` [PATCH 02/14] ARM: dts: IGEP: " Sebastian Reichel
2019-02-18 22:04 ` Enric Balletbo Serra
2018-12-21 1:17 ` [PATCH 03/14] ARM: OMAP2+: pdata-quirks: drop TI_ST/KIM support Sebastian Reichel
2018-12-21 1:17 ` [PATCH 04/14] media: wl128x-radio: remove module version Sebastian Reichel
2018-12-21 1:17 ` [PATCH 05/14] media: wl128x-radio: remove global radio_disconnected Sebastian Reichel
2018-12-22 19:10 ` Pavel Machek
2018-12-21 1:17 ` [PATCH 06/14] media: wl128x-radio: remove global radio_dev Sebastian Reichel
2018-12-22 19:16 ` Pavel Machek
2018-12-21 1:17 ` [PATCH 07/14] media: wl128x-radio: convert to platform device Sebastian Reichel
2018-12-22 19:17 ` Pavel Machek
2018-12-21 1:17 ` [PATCH 08/14] media: wl128x-radio: use device managed memory allocation Sebastian Reichel
2018-12-22 19:20 ` Pavel Machek
2018-12-21 1:17 ` [PATCH 09/14] media: wl128x-radio: load firmware from ti-connectivity/ Sebastian Reichel
2018-12-21 1:17 ` [PATCH 10/14] media: wl128x-radio: simplify fmc_prepare/fmc_release Sebastian Reichel
2018-12-22 19:29 ` Pavel Machek
2019-01-09 18:17 ` Sebastian Reichel
2018-12-21 1:17 ` [PATCH 11/14] media: wl128x-radio: fix skb debug printing Sebastian Reichel
2018-12-22 19:30 ` Pavel Machek
2018-12-21 1:17 ` [PATCH 12/14] media: wl128x-radio: move from TI_ST to hci_ll driver Sebastian Reichel
2018-12-23 15:56 ` Marcel Holtmann
2019-01-09 18:11 ` Sebastian Reichel
2019-01-09 19:24 ` Marcel Holtmann
2019-01-10 1:23 ` Rob Herring
2018-12-21 1:17 ` [PATCH 13/14] Bluetooth: btwilink: drop superseded driver Sebastian Reichel
2018-12-21 1:17 ` [PATCH 14/14] misc: ti-st: Drop " Sebastian Reichel
2018-12-21 21:10 ` Adam Ford
2018-12-21 18:02 ` Tony Lindgren [this message]
2018-12-22 2:47 ` [PATCH 00/14] Add support for FM radio in hcill and kill TI_ST Sebastian Reichel
2018-12-23 16:15 ` Tony Lindgren
2018-12-22 20:36 ` Adam Ford
2018-12-23 16:22 ` Tony Lindgren
2018-12-22 20:08 ` Pavel Machek
2018-12-22 22:40 ` Pavel Machek
2019-01-10 17:42 ` Sebastian Reichel
2019-03-14 8:20 ` Hans Verkuil
2019-03-14 12:18 ` Adam Ford
2019-03-19 13:31 ` Sebastian Reichel
2019-05-07 17:26 ` Adam Ford
2019-05-07 18:34 ` Adam Ford
2019-05-08 20:58 ` Marcel Holtmann
2019-05-10 13:28 ` Adam Ford
2019-05-10 15:38 ` Marcel Holtmann
2019-09-30 23:42 ` Adam Ford
2019-10-02 19:03 ` Adam Ford
2019-10-03 13:42 ` Sebastian Reichel
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20181221180205.GH6707@atomide.com \
--to=tony@atomide.com \
--cc=gregkh@linuxfoundation.org \
--cc=linux-bluetooth@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=marcel@holtmann.org \
--cc=mchehab@kernel.org \
--cc=pavel@ucw.cz \
--cc=robh@kernel.org \
--cc=sre@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).