Hi Marcel,

On Fri, Aug 30, 2019 at 09:53:16AM +0200, Marcel Holtmann wrote:
> > (Resend to add missing lists, sorry for the noise.)
> >
> > This series implements bluetooth support for Xunlong Orange Pi 3 board.
> >
> > The board uses AP6256 WiFi/BT 5.0 chip.
> >
> > Summary of changes:
> >
> > - add more delay to let initialize the chip
> > - let the kernel detect firmware file path
> > - add new compatible and update dt-bindings
> > - update Orange Pi 3 / H6 DTS
> >
> > Please take a look.
> >
> > thank you and regards,
> >  Ondrej Jirman
> >
> > Ondrej Jirman (5):
> >  dt-bindings: net: Add compatible for BCM4345C5 bluetooth device
> >  bluetooth: bcm: Add support for loading firmware for BCM4345C5
> >  bluetooth: hci_bcm: Give more time to come out of reset
> >  arm64: dts: allwinner: h6: Add pin configs for uart1
> >  arm64: dts: allwinner: orange-pi-3: Enable UART1 / Bluetooth
> >
> > .../bindings/net/broadcom-bluetooth.txt       |  1 +
> > .../dts/allwinner/sun50i-h6-orangepi-3.dts    | 19 +++++++++++++++++++
> > arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi  | 10 ++++++++++
> > drivers/bluetooth/btbcm.c                     |  3 +++
> > drivers/bluetooth/hci_bcm.c                   |  3 ++-
> > 5 files changed, 35 insertions(+), 1 deletion(-)
>
> all 5 patches have been applied to bluetooth-next tree.

The DTS patches (last 2) should go through the arm-soc tree, can you
drop them?

Thanks!
Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com