linux-clk.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Chris Brandt <chris.brandt@renesas.com>
To: Ulf Hansson <ulf.hansson@linaro.org>,
	Rob Herring <robh+dt@kernel.org>,
	Mark Rutland <mark.rutland@arm.com>,
	Geert Uytterhoeven <geert+renesas@glider.be>,
	Michael Turquette <mturquette@baylibre.com>,
	Stephen Boyd <sboyd@kernel.org>
Cc: Wolfram Sang <wsa+renesas@sang-engineering.com>,
	linux-clk@vger.kernel.org, linux-mmc@vger.kernel.org,
	devicetree@vger.kernel.org, linux-renesas-soc@vger.kernel.org,
	Chris Brandt <chris.brandt@renesas.com>
Subject: [PATCH v4 2/3] mmc: renesas_sdhi_internal_dmac: Add R7S9210 support
Date: Fri, 12 Oct 2018 07:29:23 -0500	[thread overview]
Message-ID: <20181012122924.5543-3-chris.brandt@renesas.com> (raw)
In-Reply-To: <20181012122924.5543-1-chris.brandt@renesas.com>

The SDHI/MMC controller in the RZ/A2 is almost the same as R-Car gen3, but
with some minor differences.

Signed-off-by: Chris Brandt <chris.brandt@renesas.com>
---
v4:
 * Fixed spelling in #define
v3:
 * Removed extra space in Kconfig
 * Removed unneeded parentheses
v2:
 * Made comment clearer
---
 drivers/mmc/host/Kconfig                      |  5 +++--
 drivers/mmc/host/renesas_sdhi_internal_dmac.c | 28 +++++++++++++++++++++++++--
 2 files changed, 29 insertions(+), 4 deletions(-)

diff --git a/drivers/mmc/host/Kconfig b/drivers/mmc/host/Kconfig
index cf984f0f0246..b69d5cd45d0f 100644
--- a/drivers/mmc/host/Kconfig
+++ b/drivers/mmc/host/Kconfig
@@ -636,13 +636,14 @@ config MMC_SDHI_SYS_DMAC
 
 config MMC_SDHI_INTERNAL_DMAC
 	tristate "DMA for SDHI SD/SDIO controllers using on-chip bus mastering"
-	depends on ARM64 || COMPILE_TEST
+	depends on ARM64 || ARCH_R7S9210 || COMPILE_TEST
 	depends on MMC_SDHI
 	default MMC_SDHI if ARM64
 	help
 	  This provides DMA support for SDHI SD/SDIO controllers
 	  using on-chip bus mastering. This supports the controllers
-	  found in arm64 based SoCs.
+	  found in arm64 based SoCs. This controller is also found in
+	  RZ/A2 series SoCs.
 
 config MMC_UNIPHIER
 	tristate "UniPhier SD/eMMC Host Controller support"
diff --git a/drivers/mmc/host/renesas_sdhi_internal_dmac.c b/drivers/mmc/host/renesas_sdhi_internal_dmac.c
index e5e5015ca680..065dc527291c 100644
--- a/drivers/mmc/host/renesas_sdhi_internal_dmac.c
+++ b/drivers/mmc/host/renesas_sdhi_internal_dmac.c
@@ -34,7 +34,7 @@
 #define DTRAN_MODE_CH_NUM_CH0	0	/* "downstream" = for write commands */
 #define DTRAN_MODE_CH_NUM_CH1	BIT(16)	/* "upstream" = for read commands */
 #define DTRAN_MODE_BUS_WIDTH	(BIT(5) | BIT(4))
-#define DTRAN_MODE_ADDR_MODE	BIT(0)	/* 1 = Increment address */
+#define DTRAN_MODE_ADDR_MODE	BIT(0)	/* 1 = Increment address, 0 = Fixed */
 
 /* DM_CM_DTRAN_CTRL */
 #define DTRAN_CTRL_DM_START	BIT(0)
@@ -73,6 +73,9 @@ static unsigned long global_flags;
 #define SDHI_INTERNAL_DMAC_ONE_RX_ONLY	0
 #define SDHI_INTERNAL_DMAC_RX_IN_USE	1
 
+/* RZ/A2 does not have the ADRR_MODE bit */
+#define SDHI_INTERNAL_DMAC_ADDR_MODE_FIXED_ONLY 2
+
 /* Definitions for sampling clocks */
 static struct renesas_sdhi_scc rcar_gen3_scc_taps[] = {
 	{
@@ -81,6 +84,21 @@ static struct renesas_sdhi_scc rcar_gen3_scc_taps[] = {
 	},
 };
 
+static const struct renesas_sdhi_of_data of_rza2_compatible = {
+	.tmio_flags	= TMIO_MMC_HAS_IDLE_WAIT | TMIO_MMC_CLK_ACTUAL |
+			  TMIO_MMC_HAVE_CBSY,
+	.tmio_ocr_mask	= MMC_VDD_32_33,
+	.capabilities	= MMC_CAP_SD_HIGHSPEED | MMC_CAP_SDIO_IRQ |
+			  MMC_CAP_CMD23,
+	.bus_shift	= 2,
+	.scc_offset	= 0 - 0x1000,
+	.taps		= rcar_gen3_scc_taps,
+	.taps_num	= ARRAY_SIZE(rcar_gen3_scc_taps),
+	/* DMAC can handle 0xffffffff blk count but only 1 segment */
+	.max_blk_count	= 0xffffffff,
+	.max_segs	= 1,
+};
+
 static const struct renesas_sdhi_of_data of_rcar_r8a7795_compatible = {
 	.tmio_flags	= TMIO_MMC_HAS_IDLE_WAIT | TMIO_MMC_CLK_ACTUAL |
 			  TMIO_MMC_HAVE_CBSY | TMIO_MMC_MIN_RCAR2 |
@@ -113,6 +131,7 @@ static const struct renesas_sdhi_of_data of_rcar_gen3_compatible = {
 };
 
 static const struct of_device_id renesas_sdhi_internal_dmac_of_match[] = {
+	{ .compatible = "renesas,sdhi-r7s9210", .data = &of_rza2_compatible, },
 	{ .compatible = "renesas,sdhi-r8a7795", .data = &of_rcar_r8a7795_compatible, },
 	{ .compatible = "renesas,sdhi-r8a7796", .data = &of_rcar_r8a7795_compatible, },
 	{ .compatible = "renesas,rcar-gen3-sdhi", .data = &of_rcar_gen3_compatible, },
@@ -171,7 +190,10 @@ renesas_sdhi_internal_dmac_start_dma(struct tmio_mmc_host *host,
 				     struct mmc_data *data)
 {
 	struct scatterlist *sg = host->sg_ptr;
-	u32 dtran_mode = DTRAN_MODE_BUS_WIDTH | DTRAN_MODE_ADDR_MODE;
+	u32 dtran_mode = DTRAN_MODE_BUS_WIDTH;
+
+	if (!test_bit(SDHI_INTERNAL_DMAC_ADDR_MODE_FIXED_ONLY, &global_flags))
+		dtran_mode |= DTRAN_MODE_ADDR_MODE;
 
 	if (!dma_map_sg(&host->pdev->dev, sg, host->sg_len,
 			mmc_get_dma_dir(data)))
@@ -290,6 +312,8 @@ static const struct tmio_mmc_dma_ops renesas_sdhi_internal_dmac_dma_ops = {
  */
 static const struct soc_device_attribute gen3_soc_whitelist[] = {
 	/* specific ones */
+	{ .soc_id = "r7s9210",
+	  .data = (void *)BIT(SDHI_INTERNAL_DMAC_ADDR_MODE_FIXED_ONLY) },
 	{ .soc_id = "r8a7795", .revision = "ES1.*",
 	  .data = (void *)BIT(SDHI_INTERNAL_DMAC_ONE_RX_ONLY) },
 	{ .soc_id = "r8a7796", .revision = "ES1.0",
-- 
2.16.1


  parent reply	other threads:[~2018-10-12 12:29 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-10-12 12:29 [PATCH v4 0/3] mmc: tmio_mmc: Add support for RZ/A2 Chris Brandt
2018-10-12 12:29 ` [PATCH v4 1/3] clk: renesas: r7s9210: Add SDHI clocks Chris Brandt
2018-10-12 12:29 ` Chris Brandt [this message]
2018-10-12 12:29 ` [PATCH v4 3/3] dt-bindings: mmc: tmio_mmc: Document Renesas R7S9210 Chris Brandt
2018-10-12 14:44   ` Rob Herring
2018-10-15 15:46   ` Simon Horman
2018-10-23 15:01 ` [PATCH v4 0/3] mmc: tmio_mmc: Add support for RZ/A2 Ulf Hansson
2018-10-23 22:28   ` Chris Brandt
2018-10-24 10:19     ` Ulf Hansson
2018-10-24  9:30   ` Geert Uytterhoeven

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20181012122924.5543-3-chris.brandt@renesas.com \
    --to=chris.brandt@renesas.com \
    --cc=devicetree@vger.kernel.org \
    --cc=geert+renesas@glider.be \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-mmc@vger.kernel.org \
    --cc=linux-renesas-soc@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=mturquette@baylibre.com \
    --cc=robh+dt@kernel.org \
    --cc=sboyd@kernel.org \
    --cc=ulf.hansson@linaro.org \
    --cc=wsa+renesas@sang-engineering.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).