On Fri, Feb 26, 2021 at 10:08:30AM +0100, Oleksij Rempel wrote: > Add simple IRQ or GPIO base counter. This device is used to measure > rotation speed of some agricultural devices, so no high frequency on the > counter pin is expected. > > The maximal measurement frequency depends on the CPU and system load. On > the idle iMX6S I was able to measure up to 20kHz without count drops. > > Signed-off-by: Oleksij Rempel > Reviewed-by: Ahmad Fatoum Hi Oleksij, We're almost there, but I spotted a couple of mistakes below. > --- > MAINTAINERS | 7 + > drivers/counter/Kconfig | 10 ++ > drivers/counter/Makefile | 1 + > drivers/counter/interrupt-cnt.c | 243 ++++++++++++++++++++++++++++++++ > 4 files changed, 261 insertions(+) > create mode 100644 drivers/counter/interrupt-cnt.c > > diff --git a/MAINTAINERS b/MAINTAINERS > index a50a543e3c81..ad0a4455afec 100644 > --- a/MAINTAINERS > +++ b/MAINTAINERS > @@ -9217,6 +9217,13 @@ F: include/dt-bindings/interconnect/ > F: include/linux/interconnect-provider.h > F: include/linux/interconnect.h > > +INTERRUPT COUNTER DRIVER > +M: Oleksij Rempel > +R: Pengutronix Kernel Team > +L: linux-iio@vger.kernel.org > +F: Documentation/devicetree/bindings/counter/interrupt-counter.yaml > +F: drivers/counter/interrupt-cnt.c > + > INVENSENSE ICM-426xx IMU DRIVER > M: Jean-Baptiste Maneyrol > L: linux-iio@vger.kernel.org > diff --git a/drivers/counter/Kconfig b/drivers/counter/Kconfig > index 2de53ab0dd25..dcad13229134 100644 > --- a/drivers/counter/Kconfig > +++ b/drivers/counter/Kconfig > @@ -29,6 +29,16 @@ config 104_QUAD_8 > The base port addresses for the devices may be configured via the base > array module parameter. > > +config INTERRUPT_CNT > + tristate "Interrupt counter driver" > + depends on GPIOLIB > + help > + Select this option to enable interrupt counter driver. Any interrupt > + source can be used by this driver as the event source. > + > + To compile this driver as a module, choose M here: the > + module will be called interrupt-cnt. > + > config STM32_TIMER_CNT > tristate "STM32 Timer encoder counter driver" > depends on MFD_STM32_TIMERS || COMPILE_TEST > diff --git a/drivers/counter/Makefile b/drivers/counter/Makefile > index 0a393f71e481..cb646ed2f039 100644 > --- a/drivers/counter/Makefile > +++ b/drivers/counter/Makefile > @@ -6,6 +6,7 @@ > obj-$(CONFIG_COUNTER) += counter.o > > obj-$(CONFIG_104_QUAD_8) += 104-quad-8.o > +obj-$(CONFIG_INTERRUPT_CNT) += interrupt-cnt.o > obj-$(CONFIG_STM32_TIMER_CNT) += stm32-timer-cnt.o > obj-$(CONFIG_STM32_LPTIMER_CNT) += stm32-lptimer-cnt.o > obj-$(CONFIG_TI_EQEP) += ti-eqep.o > diff --git a/drivers/counter/interrupt-cnt.c b/drivers/counter/interrupt-cnt.c > new file mode 100644 > index 000000000000..550383b6b591 > --- /dev/null > +++ b/drivers/counter/interrupt-cnt.c > @@ -0,0 +1,243 @@ > +// SPDX-License-Identifier: GPL-2.0 > +/* > + * Copyright (c) 2021 Pengutronix, Oleksij Rempel > + */ > + > +#include > +#include > +#include > +#include > +#include > +#include > +#include > + > +#define INTERRUPT_CNT_NAME "interrupt-cnt" > + > +struct interrupt_cnt_priv { > + atomic_t count; > + struct counter_device counter; > + struct gpio_desc *gpio; > + int irq; > + bool enabled; > + struct counter_signal signals; > + struct counter_synapse synapses; > + struct counter_count cnts; > +}; > + > +static irqreturn_t interrupt_cnt_isr(int irq, void *dev_id) > +{ > + struct interrupt_cnt_priv *priv = dev_id; > + > + atomic_inc(&priv->count); > + > + return IRQ_HANDLED; > +} > + > +static ssize_t interrupt_cnt_enable_read(struct counter_device *counter, > + struct counter_count *count, > + void *private, char *buf) > +{ > + struct interrupt_cnt_priv *priv = counter->priv; > + > + return sysfs_emit(buf, "%d\n", priv->enabled); > +} > + > +static ssize_t interrupt_cnt_enable_write(struct counter_device *counter, > + struct counter_count *count, > + void *private, const char *buf, > + size_t len) > +{ > + struct interrupt_cnt_priv *priv = counter->priv; > + bool enable; > + ssize_t ret; > + > + ret = kstrtobool(buf, &enable); > + if (ret) > + return ret; > + > + if (priv->enabled == enable) > + return len; > + > + if (enable) { > + priv->enabled = true; > + enable_irq(priv->irq); > + } else { > + disable_irq(priv->irq); > + priv->enabled = false; > + } > + > + return len; > +} > + > +static const struct counter_count_ext interrupt_cnt_ext[] = { > + { > + .name = "enable", > + .read = interrupt_cnt_enable_read, > + .write = interrupt_cnt_enable_write, > + }, > +}; > + > +static enum counter_synapse_action interrupt_cnt_synapse_actionss[] = { > + COUNTER_SYNAPSE_ACTION_RISING_EDGE, > +}; > + > +static int interrupt_cnt_action_get(struct counter_device *counter, > + struct counter_count *count, > + struct counter_synapse *synapse, > + size_t *action) > +{ > + *action = interrupt_cnt_synapse_actionss[0]; This needs to be set to the index of the element, not the value: *action = 0; > + > + return 0; > +} > + > +static int interrupt_cnt_read(struct counter_device *counter, > + struct counter_count *count, unsigned long *val) > +{ > + struct interrupt_cnt_priv *priv = counter->priv; > + > + *val = atomic_read(&priv->count); > + > + return 0; > +} > + > +static int interrupt_cnt_write(struct counter_device *counter, > + struct counter_count *count, > + const unsigned long val) > +{ > + struct interrupt_cnt_priv *priv = counter->priv; > + > + atomic_set(&priv->count, val); > + > + return 0; > +} > + > +static enum counter_count_function interrupt_cnt_functions[] = { > + COUNTER_COUNT_FUNCTION_INCREASE, > +}; > + > +static int interrupt_cnt_function_get(struct counter_device *counter, > + struct counter_count *count, > + size_t *function) > +{ > + *function = interrupt_cnt_functions[0]; Same problem as action_get(); needs to be index, not value: *function = 0; > + > + return 0; > +} > + > +static int interrupt_cnt_signal_read(struct counter_device *counter, > + struct counter_signal *signal, > + enum counter_signal_value *val) > +{ > + struct interrupt_cnt_priv *priv = counter->priv; > + int ret; > + > + ret = gpiod_get_value(priv->gpio); > + if (ret < 0) > + return ret; > + > + *val = ret ? COUNTER_SIGNAL_HIGH : COUNTER_SIGNAL_LOW; > + > + return 0; > +} > + > +static const struct counter_ops interrupt_cnt_ops = { > + .action_get = interrupt_cnt_action_get, > + .count_read = interrupt_cnt_read, > + .count_write = interrupt_cnt_write, > + .function_get = interrupt_cnt_function_get, > + .signal_read = interrupt_cnt_signal_read, > +}; > + > +static int interrupt_cnt_probe(struct platform_device *pdev) > +{ > + struct device *dev = &pdev->dev; > + struct interrupt_cnt_priv *priv; > + int ret; > + > + priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL); > + if (!priv) > + return -ENOMEM; > + > + priv->irq = platform_get_irq_optional(pdev, 0); > + if (priv->irq == -ENXIO) > + priv->irq = 0; > + else if (priv->irq < 0) > + return dev_err_probe(dev, priv->irq, "failed to get IRQ\n"); > + > + priv->gpio = devm_gpiod_get_optional(dev, NULL, GPIOD_IN); > + if (IS_ERR(priv->gpio)) > + return dev_err_probe(dev, PTR_ERR(priv->gpio), "failed to get GPIO\n"); > + > + if (!priv->irq && !priv->gpio) { > + dev_err(dev, "IRQ and GPIO are not found. At least one source should be provided\n"); > + return -ENODEV; > + } > + > + if (!priv->irq) { > + int irq = gpiod_to_irq(priv->gpio); > + > + if (irq < 0) > + return dev_err_probe(dev, irq, "failed to get IRQ from GPIO\n"); > + > + priv->irq = irq; > + } > + > + if (priv->gpio) { This if statement can be removed. There's no need to restrict this to just GPIO because we're always dealing with an IRQ, so allocate the "IRQ #" name unconditionally and set signals/num_signals. William Breathitt Gray > + priv->signals.name = devm_kasprintf(dev, GFP_KERNEL, "IRQ %d", > + priv->irq); > + if (!priv->signals.name) > + return -ENOMEM; > + > + priv->counter.signals = &priv->signals; > + priv->counter.num_signals = 1; > + } > + > + priv->synapses.actions_list = interrupt_cnt_synapse_actionss; > + priv->synapses.num_actions = ARRAY_SIZE(interrupt_cnt_synapse_actionss); > + priv->synapses.signal = &priv->signals; > + > + priv->cnts.name = "Channel 0 Count"; > + priv->cnts.functions_list = interrupt_cnt_functions; > + priv->cnts.num_functions = ARRAY_SIZE(interrupt_cnt_functions); > + priv->cnts.synapses = &priv->synapses; > + priv->cnts.num_synapses = 1; > + priv->cnts.ext = interrupt_cnt_ext; > + priv->cnts.num_ext = ARRAY_SIZE(interrupt_cnt_ext); > + > + priv->counter.priv = priv; > + priv->counter.name = dev_name(dev); > + priv->counter.parent = dev; > + priv->counter.ops = &interrupt_cnt_ops; > + priv->counter.counts = &priv->cnts; > + priv->counter.num_counts = 1; > + > + irq_set_status_flags(priv->irq, IRQ_NOAUTOEN); > + ret = devm_request_irq(dev, priv->irq, interrupt_cnt_isr, > + IRQF_TRIGGER_RISING | IRQF_NO_THREAD, > + dev_name(dev), priv); > + if (ret) > + return ret; > + > + return devm_counter_register(dev, &priv->counter); > +} > + > +static const struct of_device_id interrupt_cnt_of_match[] = { > + { .compatible = "interrupt-counter", }, > + {} > +}; > +MODULE_DEVICE_TABLE(of, interrupt_cnt_of_match); > + > +static struct platform_driver interrupt_cnt_driver = { > + .probe = interrupt_cnt_probe, > + .driver = { > + .name = INTERRUPT_CNT_NAME, > + .of_match_table = interrupt_cnt_of_match, > + }, > +}; > +module_platform_driver(interrupt_cnt_driver); > + > +MODULE_ALIAS("platform:interrupt-counter"); > +MODULE_AUTHOR("Oleksij Rempel "); > +MODULE_DESCRIPTION("Interrupt counter driver"); > +MODULE_LICENSE("GPL v2"); > -- > 2.29.2 >