On Thu 2020-06-04 15:43:35, Álvaro Fernández Rojas wrote:
> Hi Pavel,
> 
> > El 4 jun 2020, a las 15:40, Pavel Machek <pavel@ucw.cz> escribió:
> > 
> > On Thu 2020-06-04 15:35:06, Álvaro Fernández Rojas wrote:
> >> HI Pavel,
> >> 
> >> Right now, only one hw blinking interval is supported, but up to two hw blinking intervals can be configured in the controller.
> >> This patch just adds support for the second hw blinking interval.
> >> 
> >> BTW, I will send v4 which should clarify that each LED can be configured in 4 modes:
> >> 0: On
> >> 1: HW Blinking (Interval 1)
> >> 2: HW Blinking (Interval 2)
> >> 3: Off
> >> 
> >> Until now we were only using 3 modes:
> >> 0: On
> >> 1: HW Blinking (Interval 1)
> >> 3: Off
> > 
> > So the issue is .... there are like 5 LEDs and they can be on or off
> > or blinking with at most 2 different intervals?
> > 								Pavel
> 
> Yes, the controller supports two different blinking delays (intervals), and LEDs can either be on, off or assigned to one of the two blinking delays.
> However, the current upstream controller only supports one blinking delay. This patch just adds support for both blinking delays instead of just one.
>

Ok. Please put this kind of summary in comment somewhere.

Best regards,
									Pavel

-- 
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html