[PATCH v3] Documentation: admin-guide: correct "it's" to possessive "its"

[Randy Dunlap <rdunlap@infradead.org>]

Correct 2 uses of "it's" to the possessive "its" as needed.

Signed-off-by: Randy Dunlap <rdunlap@infradead.org>
Cc: Darrick J. Wong <djwong@kernel.org>
Cc: linux-xfs@vger.kernel.org
Cc: linux-mm@kvack.org
Cc: Jonathan Corbet <corbet@lwn.net>
Reviewed-by: Darrick J. Wong <djwong@kernel.org>
---
v2: add Rev-by: Darrick
v3: rebase/resend

 Documentation/admin-guide/mm/numa_memory_policy.rst |    2 +-
 Documentation/admin-guide/xfs.rst                   |    2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff -- a/Documentation/admin-guide/mm/numa_memory_policy.rst b/Documentation/admin-guide/mm/numa_memory_policy.rst
--- a/Documentation/admin-guide/mm/numa_memory_policy.rst
+++ b/Documentation/admin-guide/mm/numa_memory_policy.rst
@@ -109,7 +109,7 @@ VMA Policy
 	* A task may install a new VMA policy on a sub-range of a
 	  previously mmap()ed region.  When this happens, Linux splits
 	  the existing virtual memory area into 2 or 3 VMAs, each with
-	  it's own policy.
+	  its own policy.
 
 	* By default, VMA policy applies only to pages allocated after
 	  the policy is installed.  Any pages already faulted into the
diff -- a/Documentation/admin-guide/xfs.rst b/Documentation/admin-guide/xfs.rst
--- a/Documentation/admin-guide/xfs.rst
+++ b/Documentation/admin-guide/xfs.rst
@@ -192,7 +192,7 @@ When mounting an XFS filesystem, the fol
 	are any integer multiple of a valid ``sunit`` value.
 
 	Typically the only time these mount options are necessary if
-	after an underlying RAID device has had it's geometry
+	after an underlying RAID device has had its geometry
 	modified, such as adding a new disk to a RAID5 lun and
 	reshaping it.