From: <Tudor.Ambarus@microchip.com>
To: <vigneshr@ti.com>, <boris.brezillon@collabora.com>
Cc: richard@nod.at, linux-mtd@lists.infradead.org,
linux-kernel@vger.kernel.org, miquel.raynal@bootlin.com
Subject: Re: [PATCH v4 12/20] mtd: spi-nor: Print debug message when the read back test fails
Date: Wed, 6 Nov 2019 07:24:31 +0000 [thread overview]
Message-ID: <5abf94c6-f2bb-b317-4796-3f9ea1fbf55e@microchip.com> (raw)
In-Reply-To: <9474c875-94a1-3d19-ddab-b90d352967a9@ti.com>
On 11/05/2019 02:37 PM, Vignesh Raghavendra wrote:
> On 02/11/19 4:53 PM, Tudor.Ambarus@microchip.com wrote:
>> From: Tudor Ambarus <tudor.ambarus@microchip.com>
>>
>> Demystify where the EIO error occurs.
>>
>> Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
>> ---
> I think this is a small enough change that can be squashed into previous
> patch itself
>
I made separate patches because this is a separate logical change. The previous
patch extends the check on all bits of the Status Register, while this one
prints a debug message in case of EIO. Thus I tried to have a single logical
change contained in a single patch. I'm clearly no expert in this (Boris asked
me in v3 to split patches because I did too many things in one patch :) ), so I
would keep this as is, but if you still feel that it should be squashed, then
I'll do it. Please let me know.
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next prev parent reply other threads:[~2019-11-06 7:24 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-11-02 11:23 [PATCH v4 00/20] mtd: spi-nor: Quad Enable and (un)lock methods Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 01/20] mtd: spi-nor: Use dev_dbg insted of dev_err for low level info Tudor.Ambarus
2019-11-05 12:12 ` Vignesh Raghavendra
2019-11-06 7:07 ` Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 02/20] mtd: spi-nor: Print debug info inside Reg Ops methods Tudor.Ambarus
2019-11-05 12:13 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 03/20] mtd: spi-nor: Check for errors after each Register Operation Tudor.Ambarus
2019-11-06 9:19 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 04/20] mtd: spi-nor: Rename label as it is no longer generic Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 05/20] mtd: spi-nor: Void return type for spi_nor_clear_sr/fsr() Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 06/20] mtd: spi-nor: Move the WE and wait calls inside Write SR methods Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 07/20] mtd: spi-nor: Merge spi_nor_write_sr() and spi_nor_write_sr_cr() Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 08/20] mtd: spi-nor: Describe all the Reg Ops Tudor.Ambarus
2019-11-05 12:21 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 09/20] mtd: spi-nor: Drop spansion_quad_enable() Tudor.Ambarus
2019-11-05 12:35 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 10/20] mtd: spi-nor: Fix errno on Quad Enable methods Tudor.Ambarus
2019-11-05 12:36 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 11/20] mtd: spi-nor: Check all the bits written, not just the BP ones Tudor.Ambarus
2019-11-05 12:21 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 12/20] mtd: spi-nor: Print debug message when the read back test fails Tudor.Ambarus
2019-11-05 12:37 ` Vignesh Raghavendra
2019-11-06 7:24 ` Tudor.Ambarus [this message]
2019-11-06 7:39 ` Vignesh Raghavendra
2019-11-07 5:58 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 13/20] mtd: spi-nor: Fix clearing of QE bit on lock()/unlock() Tudor.Ambarus
2019-11-05 17:07 ` Vignesh Raghavendra
2019-11-06 8:33 ` Tudor.Ambarus
2019-11-06 16:26 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 14/20] mtd: spi-nor: Extend the QE Read Back test to the entire SR byte Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 15/20] mtd: spi-nor: Extend the QE Read Back test to both SR1 and SR2 Tudor.Ambarus
2019-11-05 16:06 ` Vignesh Raghavendra
2019-11-06 8:41 ` Tudor.Ambarus
2019-11-02 11:23 ` [PATCH v4 16/20] mtd: spi-nor: Rename CR_QUAD_EN_SPAN to SR2_QUAD_EN_BIT1 Tudor.Ambarus
2019-11-06 5:45 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 17/20] mtd: spi-nor: Merge spansion Quad Enable methods Tudor.Ambarus
2019-11-06 5:46 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 18/20] mtd: spi-nor: Rename macronix_quad_enable to spi_nor_sr1_bit6_quad_enable Tudor.Ambarus
2019-11-06 6:00 ` Vignesh Raghavendra
2019-11-02 11:23 ` [PATCH v4 19/20] mtd: spi-nor: Prepend "spi_nor_" to "sr2_bit7_quad_enable" Tudor.Ambarus
2019-11-02 11:24 ` [PATCH v4 20/20] mtd: spi-nor: Rework the disabling of block write protection Tudor.Ambarus
2019-11-07 6:27 ` [PATCH v4 00/20] mtd: spi-nor: Quad Enable and (un)lock methods Tudor.Ambarus
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=5abf94c6-f2bb-b317-4796-3f9ea1fbf55e@microchip.com \
--to=tudor.ambarus@microchip.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=richard@nod.at \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).