From: Kieran Bingham <kieran.bingham@ideasonboard.com>
To: Jacopo Mondi <jacopo+renesas@jmondi.org>,
laurent.pinchart@ideasonboard.com,
niklas.soderlund+renesas@ragnatech.se
Cc: linux-media@vger.kernel.org, linux-renesas-soc@vger.kernel.org
Subject: Re: [PATCH v2 2/6] media: adv748x: Rename reset procedures
Date: Mon, 7 Jan 2019 09:59:48 +0000 [thread overview]
Message-ID: <f196d999-4526-8d68-4d8b-b18883ed6c5f@ideasonboard.com> (raw)
In-Reply-To: <20190106155413.30666-3-jacopo+renesas@jmondi.org>
Hi Jacopo,
On 06/01/2019 15:54, Jacopo Mondi wrote:
> Rename the chip reset procedure as they configure the CP (HDMI) and SD
> (AFE) cores.
Reviewed-by: Kieran Bingham <kieran.bingham+renesas@ideasonboard.com>
> Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
> Signed-off-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
> ---
> drivers/media/i2c/adv748x/adv748x-core.c | 24 ++++++++++--------------
> 1 file changed, 10 insertions(+), 14 deletions(-)
>
> diff --git a/drivers/media/i2c/adv748x/adv748x-core.c b/drivers/media/i2c/adv748x/adv748x-core.c
> index d94c63cb6a2e..ad4e6424753a 100644
> --- a/drivers/media/i2c/adv748x/adv748x-core.c
> +++ b/drivers/media/i2c/adv748x/adv748x-core.c
> @@ -353,9 +353,8 @@ static const struct adv748x_reg_value adv748x_sw_reset[] = {
> {ADV748X_PAGE_EOR, 0xff, 0xff} /* End of register table */
> };
>
> -/* Supported Formats For Script Below */
> -/* - 01-29 HDMI to MIPI TxA CSI 4-Lane - RGB888: */
> -static const struct adv748x_reg_value adv748x_init_txa_4lane[] = {
> +/* Initialize CP Core with RGB888 format. */
> +static const struct adv748x_reg_value adv748x_init_hdmi[] = {
> /* Disable chip powerdown & Enable HDMI Rx block */
> {ADV748X_PAGE_IO, 0x00, 0x40},
>
> @@ -399,10 +398,8 @@ static const struct adv748x_reg_value adv748x_init_txa_4lane[] = {
> {ADV748X_PAGE_EOR, 0xff, 0xff} /* End of register table */
> };
>
> -/* 02-01 Analog CVBS to MIPI TX-B CSI 1-Lane - */
> -/* Autodetect CVBS Single Ended In Ain 1 - MIPI Out */
> -static const struct adv748x_reg_value adv748x_init_txb_1lane[] = {
> -
> +/* Initialize AFE core with YUV8 format. */
> +static const struct adv748x_reg_value adv748x_init_afe[] = {
> {ADV748X_PAGE_IO, 0x00, 0x30}, /* Disable chip powerdown Rx */
> {ADV748X_PAGE_IO, 0xf2, 0x01}, /* Enable I2C Read Auto-Increment */
>
> @@ -445,19 +442,18 @@ static int adv748x_reset(struct adv748x_state *state)
> if (ret < 0)
> return ret;
>
> - /* Init and power down TXA */
> - ret = adv748x_write_regs(state, adv748x_init_txa_4lane);
> + /* Initialize CP and AFE cores. */
> + ret = adv748x_write_regs(state, adv748x_init_hdmi);
> if (ret)
> return ret;
>
> - adv748x_tx_power(&state->txa, 1);
> - adv748x_tx_power(&state->txa, 0);
> -
> - /* Init and power down TXB */
> - ret = adv748x_write_regs(state, adv748x_init_txb_1lane);
> + ret = adv748x_write_regs(state, adv748x_init_afe);
> if (ret)
> return ret;
>
> + /* Reset TXA and TXB */
> + adv748x_tx_power(&state->txa, 1);
> + adv748x_tx_power(&state->txa, 0);
> adv748x_tx_power(&state->txb, 1);
> adv748x_tx_power(&state->txb, 0);
>
>
--
Regards
--
Kieran
next prev parent reply other threads:[~2019-01-07 9:59 UTC|newest]
Thread overview: 26+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-01-06 15:54 [PATCH v2 0/6] media: adv748x: Implement dynamic routing support Jacopo Mondi
2019-01-06 15:54 ` [PATCH v2 1/6] media: adv748x: Add is_txb() Jacopo Mondi
2019-01-07 9:49 ` Kieran Bingham
2019-01-07 10:05 ` Jacopo Mondi
2019-01-07 10:38 ` Kieran Bingham
2019-01-09 0:04 ` Laurent Pinchart
2019-01-06 15:54 ` [PATCH v2 2/6] media: adv748x: Rename reset procedures Jacopo Mondi
2019-01-07 9:59 ` Kieran Bingham [this message]
2019-01-06 15:54 ` [PATCH v2 3/6] media: adv748x: csi2: Link AFE with TXA and TXB Jacopo Mondi
2019-01-07 10:35 ` Kieran Bingham
2019-01-09 0:11 ` Laurent Pinchart
2019-01-06 15:54 ` [PATCH v2 4/6] media: adv748x: Store the source subdevice in TX Jacopo Mondi
2019-01-07 10:41 ` Kieran Bingham
2019-01-06 15:54 ` [PATCH v2 5/6] media: adv748x: Store the TX sink in HDMI/AFE Jacopo Mondi
2019-01-07 10:45 ` Kieran Bingham
2019-01-06 15:54 ` [PATCH v2 6/6] media: adv748x: Implement TX link_setup callback Jacopo Mondi
2019-01-07 12:36 ` Kieran Bingham
2019-01-09 0:15 ` Laurent Pinchart
2019-01-09 14:15 ` Kieran Bingham
2019-01-10 8:58 ` Jacopo Mondi
2019-01-10 10:05 ` Kieran Bingham
2019-01-10 8:51 ` Jacopo Mondi
2019-01-10 9:27 ` Laurent Pinchart
2019-01-09 14:17 ` Kieran Bingham
2019-01-10 10:01 ` Jacopo Mondi
2019-01-10 13:40 ` Jacopo Mondi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=f196d999-4526-8d68-4d8b-b18883ed6c5f@ideasonboard.com \
--to=kieran.bingham@ideasonboard.com \
--cc=jacopo+renesas@jmondi.org \
--cc=laurent.pinchart@ideasonboard.com \
--cc=linux-media@vger.kernel.org \
--cc=linux-renesas-soc@vger.kernel.org \
--cc=niklas.soderlund+renesas@ragnatech.se \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).