linux-samsung-soc.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Sylwester Nawrocki <s.nawrocki@samsung.com>
To: georgi.djakov@linaro.org, cw00.choi@samsung.com, krzk@kernel.org
Cc: a.swigon@samsung.com, myungjoo.ham@samsung.com,
	inki.dae@samsung.com, sw0312.kim@samsung.com,
	b.zolnierkie@samsung.com, m.szyprowski@samsung.com,
	s.nawrocki@samsung.com, linux-kernel@vger.kernel.org,
	linux-samsung-soc@vger.kernel.org,
	dri-devel@lists.freedesktop.org,
	linux-arm-kernel@lists.infradead.org
Subject: [RFC PATCH v5 1/6] dt-bindings: exynos-bus: Add documentation for interconnect properties
Date: Fri, 29 May 2020 18:31:55 +0200	[thread overview]
Message-ID: <20200529163200.18031-2-s.nawrocki@samsung.com> (raw)
In-Reply-To: <20200529163200.18031-1-s.nawrocki@samsung.com>

Add documentation for new optional properties in the exynos bus nodes:
samsung,interconnect-parent, #interconnect-cells.
These properties allow to specify the SoC interconnect structure which
then allows the interconnect consumer devices to request specific
bandwidth requirements.

Signed-off-by: Artur Świgoń <a.swigon@samsung.com>
Signed-off-by: Sylwester Nawrocki <s.nawrocki@samsung.com>
---
Changes for v5:
 - exynos,interconnect-parent-node renamed to samsung,interconnect-parent
---
 Documentation/devicetree/bindings/devfreq/exynos-bus.txt | 15 +++++++++++++--
 1 file changed, 13 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
index e71f752..e0d2daa 100644
--- a/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
+++ b/Documentation/devicetree/bindings/devfreq/exynos-bus.txt
@@ -51,6 +51,11 @@ Optional properties only for parent bus device:
 - exynos,saturation-ratio: the percentage value which is used to calibrate
 			the performance count against total cycle count.

+Optional properties for interconnect functionality (QoS frequency constraints):
+- samsung,interconnect-parent: phandle to the parent interconnect node; for
+  passive devices should point to same node as the exynos,parent-bus property.
+- #interconnect-cells: should be 0
+
 Detailed correlation between sub-blocks and power line according to Exynos SoC:
 - In case of Exynos3250, there are two power line as following:
 	VDD_MIF |--- DMC
@@ -185,8 +190,9 @@ Example1:
 	----------------------------------------------------------

 Example2 :
-	The bus of DMC (Dynamic Memory Controller) block in exynos3250.dtsi
-	is listed below:
+	The bus of DMC (Dynamic Memory Controller) block in exynos3250.dtsi is
+	listed below. An interconnect path "bus_lcd0 -- bus_leftbus -- bus_dmc"
+	is defined for demonstration purposes.

 	bus_dmc: bus_dmc {
 		compatible = "samsung,exynos-bus";
@@ -376,12 +382,15 @@ Example2 :
 	&bus_dmc {
 		devfreq-events = <&ppmu_dmc0_3>, <&ppmu_dmc1_3>;
 		vdd-supply = <&buck1_reg>;	/* VDD_MIF */
+		#interconnect-cells = <0>;
 		status = "okay";
 	};

 	&bus_leftbus {
 		devfreq-events = <&ppmu_leftbus_3>, <&ppmu_rightbus_3>;
 		vdd-supply = <&buck3_reg>;
+		samsung,interconnect-parent = <&bus_dmc>;
+		#interconnect-cells = <0>;
 		status = "okay";
 	};

@@ -392,6 +401,8 @@ Example2 :

 	&bus_lcd0 {
 		devfreq = <&bus_leftbus>;
+		samsung,interconnect-parent = <&bus_leftbus>;
+		#interconnect-cells = <0>;
 		status = "okay";
 	};

--
2.7.4


  parent reply	other threads:[~2020-05-29 16:32 UTC|newest]

Thread overview: 27+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <CGME20200529163213eucas1p1ac148f9238214ac84f3d0cc199c4398b@eucas1p1.samsung.com>
2020-05-29 16:31 ` [RFC PATCH v5 0/6] Exynos: Simple QoS for exynos-bus using interconnect Sylwester Nawrocki
     [not found]   ` <CGME20200529163219eucas1p2d127fe3936921f53f6fe7902e7d14a3e@eucas1p2.samsung.com>
2020-05-29 16:31     ` Sylwester Nawrocki [this message]
2020-05-31  0:01       ` [RFC PATCH v5 1/6] dt-bindings: exynos-bus: Add documentation for interconnect properties Chanwoo Choi
2020-06-01  9:40         ` Sylwester Nawrocki
2020-06-01  8:19       ` Sylwester Nawrocki
2020-06-02  8:05       ` Krzysztof Kozlowski
     [not found]   ` <CGME20200529163223eucas1p2f663280abb499b4114b2f2930b43a4e5@eucas1p2.samsung.com>
2020-05-29 16:31     ` [RFC PATCH v5 2/6] interconnect: Add generic interconnect driver for Exynos SoCs Sylwester Nawrocki
2020-05-31  0:13       ` Chanwoo Choi
2020-06-01  9:57         ` Sylwester Nawrocki
2020-06-02  8:21       ` Krzysztof Kozlowski
2020-06-03  9:24         ` Sylwester Nawrocki
2020-07-01 12:50       ` Georgi Djakov
2020-07-02 12:01         ` Sylwester Nawrocki
2020-07-02 12:33           ` Georgi Djakov
2020-07-02 14:24             ` Sylwester Nawrocki
     [not found]   ` <CGME20200529163225eucas1p1cfb2233c869dcc3dab84b754bbce17b6@eucas1p1.samsung.com>
2020-05-29 16:31     ` [RFC PATCH v5 3/6] PM / devfreq: exynos-bus: Add registration of interconnect child device Sylwester Nawrocki
2020-05-30 23:57       ` Chanwoo Choi
2020-06-01 10:04         ` Sylwester Nawrocki
2020-06-02  0:50           ` Chanwoo Choi
     [not found]   ` <CGME20200529163226eucas1p15bea74bed9cc5d22727c9ba732a5cbb9@eucas1p1.samsung.com>
2020-05-29 16:31     ` [RFC PATCH v5 4/6] ARM: dts: exynos: Add interconnect properties to Exynos4412 bus nodes Sylwester Nawrocki
2020-05-31  0:02       ` Chanwoo Choi
     [not found]   ` <CGME20200529163228eucas1p1d05340fef9ffc724f5d3d9f5709a600f@eucas1p1.samsung.com>
2020-05-29 16:31     ` [RFC PATCH v5 5/6] ARM: dts: exynos: Add interconnects to Exynos4412 mixer Sylwester Nawrocki
2020-05-31  0:07       ` Chanwoo Choi
     [not found]   ` <CGME20200529163229eucas1p2ee6394f184e5eba12599559f8a621fde@eucas1p2.samsung.com>
2020-05-29 16:32     ` [RFC PATCH v5 6/6] drm: exynos: mixer: Add interconnect support Sylwester Nawrocki
2020-06-01  7:58       ` Chanwoo Choi
2020-06-03 10:04         ` Sylwester Nawrocki
2020-06-01  8:17   ` [RFC PATCH v5 0/6] Exynos: Simple QoS for exynos-bus using interconnect Sylwester Nawrocki

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200529163200.18031-2-s.nawrocki@samsung.com \
    --to=s.nawrocki@samsung.com \
    --cc=a.swigon@samsung.com \
    --cc=b.zolnierkie@samsung.com \
    --cc=cw00.choi@samsung.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=georgi.djakov@linaro.org \
    --cc=inki.dae@samsung.com \
    --cc=krzk@kernel.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-samsung-soc@vger.kernel.org \
    --cc=m.szyprowski@samsung.com \
    --cc=myungjoo.ham@samsung.com \
    --cc=sw0312.kim@samsung.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).