[PATCH v2 2/2] tty: serial: uartlite: Add runtime pm support

[Shubhrajyoti Datta <shubhrajyoti.datta@xilinx.com>]

In the commit 07e5d4ff125a ("Revert serial-uartlite: Add runtime
support") the runtime pm support was reverted to aid reverting of
the other patches.

This patch adds the runtime PM support back.
The runtime pm calls are used to gate and enable the clocks.

Signed-off-by: Shubhrajyoti Datta <shubhrajyoti.datta@xilinx.com>
---
 drivers/tty/serial/uartlite.c | 60 ++++++++++++++++++++++++++++++-----
 1 file changed, 52 insertions(+), 8 deletions(-)

diff --git a/drivers/tty/serial/uartlite.c b/drivers/tty/serial/uartlite.c
index fd7a2f82c885..51d4a485f4a1 100644
--- a/drivers/tty/serial/uartlite.c
+++ b/drivers/tty/serial/uartlite.c
@@ -22,6 +22,7 @@
 #include <linux/of_device.h>
 #include <linux/of_platform.h>
 #include <linux/clk.h>
+#include <linux/pm_runtime.h>
 
 #define ULITE_NAME		"ttyUL"
 #define ULITE_MAJOR		204
@@ -54,6 +55,7 @@
 #define ULITE_CONTROL_RST_TX	0x01
 #define ULITE_CONTROL_RST_RX	0x02
 #define ULITE_CONTROL_IE	0x10
+#define UART_AUTOSUSPEND_TIMEOUT	3000	/* ms */
 
 /* Static pointer to console port */
 #ifdef CONFIG_SERIAL_UARTLITE_CONSOLE
@@ -390,12 +392,16 @@ static int ulite_verify_port(struct uart_port *port, struct serial_struct *ser)
 static void ulite_pm(struct uart_port *port, unsigned int state,
 		     unsigned int oldstate)
 {
-	struct uartlite_data *pdata = port->private_data;
+	int ret;
 
-	if (!state)
-		clk_enable(pdata->clk);
-	else
-		clk_disable(pdata->clk);
+	if (!state) {
+		ret = pm_runtime_get_sync(port->dev);
+		if (ret < 0)
+			dev_err(port->dev, "Failed to enable clocks\n");
+	} else {
+		pm_runtime_mark_last_busy(port->dev);
+		pm_runtime_put_autosuspend(port->dev);
+	}
 }
 
 #ifdef CONFIG_CONSOLE_POLL
@@ -734,11 +740,38 @@ static int __maybe_unused ulite_resume(struct device *dev)
 	return 0;
 }
 
+static int __maybe_unused ulite_runtime_suspend(struct device *dev)
+{
+	struct uart_port *port = dev_get_drvdata(dev);
+	struct uartlite_data *pdata = port->private_data;
+
+	clk_disable(pdata->clk);
+	return 0;
+};
+
+static int __maybe_unused ulite_runtime_resume(struct device *dev)
+{
+	struct uart_port *port = dev_get_drvdata(dev);
+	struct uartlite_data *pdata = port->private_data;
+	int ret;
+
+	ret = clk_enable(pdata->clk);
+	if (ret) {
+		dev_err(dev, "Cannot enable clock.\n");
+		return ret;
+	}
+	return 0;
+}
+
 /* ---------------------------------------------------------------------
  * Platform bus binding
  */
 
-static SIMPLE_DEV_PM_OPS(ulite_pm_ops, ulite_suspend, ulite_resume);
+static const struct dev_pm_ops ulite_pm_ops = {
+	SET_SYSTEM_SLEEP_PM_OPS(ulite_suspend, ulite_resume)
+	SET_RUNTIME_PM_OPS(ulite_runtime_suspend,
+			   ulite_runtime_resume, NULL)
+};
 
 #if defined(CONFIG_OF)
 /* Match table for of_platform binding */
@@ -794,6 +827,11 @@ static int ulite_probe(struct platform_device *pdev)
 		return ret;
 	}
 
+	pm_runtime_use_autosuspend(&pdev->dev);
+	pm_runtime_set_autosuspend_delay(&pdev->dev, UART_AUTOSUSPEND_TIMEOUT);
+	pm_runtime_set_active(&pdev->dev);
+	pm_runtime_enable(&pdev->dev);
+
 	if (!ulite_uart_driver.state) {
 		dev_dbg(&pdev->dev, "uartlite: calling uart_register_driver()\n");
 		ret = uart_register_driver(&ulite_uart_driver);
@@ -806,7 +844,8 @@ static int ulite_probe(struct platform_device *pdev)
 
 	ret = ulite_assign(&pdev->dev, id, res->start, irq, pdata);
 
-	clk_disable(pdata->clk);
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_put_autosuspend(&pdev->dev);
 
 	return ret;
 }
@@ -815,9 +854,14 @@ static int ulite_remove(struct platform_device *pdev)
 {
 	struct uart_port *port = dev_get_drvdata(&pdev->dev);
 	struct uartlite_data *pdata = port->private_data;
+	int rc;
 
 	clk_disable_unprepare(pdata->clk);
-	return ulite_release(&pdev->dev);
+	rc = ulite_release(&pdev->dev);
+	pm_runtime_disable(&pdev->dev);
+	pm_runtime_set_suspended(&pdev->dev);
+	pm_runtime_dont_use_autosuspend(&pdev->dev);
+	return rc;
 }
 
 /* work with hotplug and coldplug */
-- 
2.17.1