The documentation for limits used at protection level setting did not mention the units. Fix the units in documentation to match values passed in from device-tree (uV, uA, Kelvin) to avoid confusion. Signed-off-by: Matti Vaittinen --- include/linux/regulator/driver.h | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h index f9d1115627e5..cf87f435d7ca 100644 --- a/include/linux/regulator/driver.h +++ b/include/linux/regulator/driver.h @@ -101,11 +101,13 @@ enum regulator_detection_severity { * is requested. * @set_over_voltage_protection: Support enabling of and setting limits for over * voltage situation detection. Detection can be configured for same - * severities as over current protection. + * severities as over current protection. Units of uV. * @set_under_voltage_protection: Support enabling of and setting limits for - * under situation detection. + * under voltage situation detection. Detection can be configured for same + * severities as over current protection. Units of uV. * @set_thermal_protection: Support enabling of and setting limits for over - * temperature situation detection. + * temperature situation detection.Detection can be configured for same + * severities as over current protection. Units of degree Kelvin. * * @set_active_discharge: Set active discharge enable/disable of regulators. * -- 2.31.1 -- Matti Vaittinen, Linux device drivers ROHM Semiconductors, Finland SWDC Kiviharjunlenkki 1E 90220 OULU FINLAND ~~~ "I don't think so," said Rene Descartes. Just then he vanished ~~~ Simon says - in Latin please. ~~~ "non cogito me" dixit Rene Descarte, deinde evanescavit ~~~ Thanks to Simon Glass for the translation =]