[PATCH v3 4/4] ARM: tegra: dalmore: add thermal zones for nct1008

[Wei Ni <wni@nvidia.com>]

From: lightning314 <wni@nvidia.com>

Add dt node to describe the thermal zone for the nct1008.

Signed-off-by: Wei Ni <wni@nvidia.com>
---
 arch/arm/boot/dts/tegra114-dalmore.dts | 20 +++++++++++++++++++-
 1 file changed, 19 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/tegra114-dalmore.dts b/arch/arm/boot/dts/tegra114-dalmore.dts
index 5c21d21..94a1b5d 100644
--- a/arch/arm/boot/dts/tegra114-dalmore.dts
+++ b/arch/arm/boot/dts/tegra114-dalmore.dts
@@ -779,12 +779,14 @@
 				<&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
 		};
 
-		temperature-sensor@4c {
+		nct1008: temperature-sensor@4c {
 			compatible = "onnn,nct1008";
 			reg = <0x4c>;
 			vcc-supply = <&palmas_ldo6_reg>;
 			interrupt-parent = <&gpio>;
 			interrupts = <TEGRA_GPIO(O, 4) IRQ_TYPE_LEVEL_LOW>;
+
+			#thermal-sensor-cells = <1>;
 		};
 	};
 
@@ -1283,4 +1285,20 @@
 			 <&tegra_car TEGRA114_CLK_EXTERN1>;
 		clock-names = "pll_a", "pll_a_out0", "mclk";
 	};
+
+	thermal-zones {
+		nct1008-local {
+			polling-delay-passive = <2000>; /* milliseconds */
+			polling-delay = <0>; /* milliseconds */
+
+			thermal-sensors = <&nct1008 0>;
+		};
+
+		nct1008-remote {
+			polling-delay-passive = <1000>; /* milliseconds */
+			polling-delay = <0>; /* milliseconds */
+
+			thermal-sensors = <&nct1008 1>;
+		};
+	};
 };
-- 
1.8.1.5