On Fri, Nov 11, 2016 at 10:44:53AM +0800, Chen-Yu Tsai wrote:
> According to pinconf-generic.h, the argument for
> PIN_CONFIG_BIAS_PULL_{DOWN,UP} is non-zero if the bias is enabled
> with a pull up/down resistor, zero if it is directly connected
> to VDD or ground.
> 
> Since Allwinner hardware uses a weak pull resistor internally,
> the argument should be 1.
> 
> Signed-off-by: Chen-Yu Tsai <wens@csie.org>

Acked-by: Maxime Ripard <maxime.ripard@free-electrons.com>

Thanks!
Maxime

-- 
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com