N900 contains front and back camera, with a switch between the two. This adds support for the switch component, and it is now possible to select between front and back cameras during runtime. This adds documentation for the devicetree binding. Signed-off-by: Sebastian Reichel Signed-off-by: Ivaylo Dimitrov Signed-off-by: Pavel Machek diff --git a/Documentation/devicetree/bindings/media/video-bus-switch.txt b/Documentation/devicetree/bindings/media/video-bus-switch.txt new file mode 100644 index 0000000..1b9f8e0 --- /dev/null +++ b/Documentation/devicetree/bindings/media/video-bus-switch.txt @@ -0,0 +1,63 @@ +Video Bus Switch Binding +======================== + +This is a binding for a gpio controlled switch for camera interfaces. Such a +device is used on some embedded devices to connect two cameras to the same +interface of a image signal processor. + +Required properties +=================== + +compatible : must contain "video-bus-switch" +switch-gpios : GPIO specifier for the gpio, which can toggle the + selected camera. The GPIO should be configured, so + that a disabled GPIO means, that the first port is + selected. + +Required Port nodes +=================== + +More documentation on these bindings is available in +video-interfaces.txt in the same directory. + +reg : The interface: + 0 - port for image signal processor + 1 - port for first camera sensor + 2 - port for second camera sensor + +Example +======= + +video-bus-switch { + compatible = "video-bus-switch" + switch-gpios = <&gpio1 1 GPIO_ACTIVE_HIGH>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + + csi_switch_in: endpoint { + remote-endpoint = <&csi_isp>; + }; + }; + + port@1 { + reg = <1>; + + csi_switch_out1: endpoint { + remote-endpoint = <&csi_cam1>; + }; + }; + + port@2 { + reg = <2>; + + csi_switch_out2: endpoint { + remote-endpoint = <&csi_cam2>; + }; + }; + }; +}; -- (english) http://www.livejournal.com/~pavelmachek (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html