[PATCH v3 2/3] arm64: dts: qcom: trogdor: Add brightness-levels

[Alexandru Stan <amstan@chromium.org>]

We want userspace to represent the human perceived brightness.
Since the led drivers and the leds themselves don't have a
linear response to the value we give them in terms of perceived
brightness, we'll bake the curve into the dts.

The panel also doesn't have a good response under 5%, so we'll avoid
sending it anything lower than that.

Note: Ideally this patch should be coupled with the driver change from
"backlight: pwm_bl: Fix interpolation", but it can work without it,
without looking too ugly.

Signed-off-by: Alexandru Stan <amstan@chromium.org>
---

 arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
index bf875589d364..ccdabc6c4994 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor.dtsi
@@ -179,6 +179,15 @@ pp3300_fp_tp: pp3300-fp-tp-regulator {
 	backlight: backlight {
 		compatible = "pwm-backlight";
 
+		/* The panels don't seem to like anything below ~ 5% */
+		brightness-levels = <
+			196 256 324 400 484 576 676 784 900 1024 1156 1296
+			1444 1600 1764 1936 2116 2304 2500 2704 2916 3136
+			3364 3600 3844 4096
+		>;
+		num-interpolated-steps = <64>;
+		default-brightness-level = <951>;
+
 		pwms = <&cros_ec_pwm 1>;
 		enable-gpios = <&tlmm 12 GPIO_ACTIVE_HIGH>;
 		power-supply = <&ppvar_sys>;
-- 
2.28.0