Re: [PATCH 02/15] firmware: arm_scmi: Skip scmi mbox channel setup for addtional devices

[Cristian Marussi <cristian.marussi@arm.com>]

On 10/12/2019 14:53, Sudeep Holla wrote:
> Now that the scmi bus supports adding multiple devices per protocol,
> and since scmi_create_protocol_device calls scmi_mbox_chan_setup,
> we must avoid allocating and initialising the mbox channel if it is
> already initialised.
> 
> Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>
> ---
>  drivers/firmware/arm_scmi/driver.c | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
> index dee7ce3bd815..2952fcd8dd8a 100644
> --- a/drivers/firmware/arm_scmi/driver.c
> +++ b/drivers/firmware/arm_scmi/driver.c
> @@ -735,6 +735,11 @@ static int scmi_mbox_chan_setup(struct scmi_info *info, struct device *dev,
>  	idx = tx ? 0 : 1;
>  	idr = tx ? &info->tx_idr : &info->rx_idr;
> 
> +	/* check if already allocated, used for multiple device per protocol */
> +	cinfo = idr_find(idr, prot_id);
> +	if (cinfo)
> +		return 0;
> +
>  	if (scmi_mailbox_check(np, idx)) {
>  		cinfo = idr_find(idr, SCMI_PROTOCOL_BASE);
>  		if (unlikely(!cinfo)) /* Possible only if platform has no Rx */
> --
> 2.17.1
> 

Fine for me.

Reviewed-by: Cristian Marussi <cristian.marussi@arm.com>


Cristian