linux-kernel.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: "Sven Peter" <sven@svenpeter.dev>
To: "Heikki Krogerus" <heikki.krogerus@linux.intel.com>
Cc: "Greg Kroah-Hartman" <gregkh@linuxfoundation.org>,
	"Guido Günther" <agx@sigxcpu.org>,
	"Bryan O'Donoghue" <bryan.odonoghue@linaro.org>,
	linux-usb@vger.kernel.org, linux-kernel@vger.kernel.org,
	"Hector Martin" <marcan@marcan.st>,
	"Mohamed Mediouni" <mohamed.mediouni@caramail.com>,
	"Stan Skowronek" <stan@corellium.com>,
	"Mark Kettenis" <mark.kettenis@xs4all.nl>,
	"Alexander Graf" <graf@amazon.com>,
	"Alyssa Rosenzweig" <alyssa@rosenzweig.io>
Subject: Re: [RFT PATCH 8/9] usb: typec: tipd: Switch power state to S0 for Apple variant
Date: Wed, 22 Sep 2021 17:00:31 +0200	[thread overview]
Message-ID: <d8024591-0142-442e-98e9-0c92a7679768@www.fastmail.com> (raw)
In-Reply-To: <YUniTtc/DwGYPD+c@kuha.fi.intel.com>



On Tue, Sep 21, 2021, at 15:46, Heikki Krogerus wrote:
> On Sat, Sep 18, 2021 at 02:09:33PM +0200, Sven Peter wrote:
>> The Apple CD321x comes up in a low-power state after boot. Usually, the
>> bootloader will already power it up to S0 but let's do it here as well
>> in case that didn't happen.
>> 
>> Suggested-by: Stan Skowronek <stan@corellium.com>
>> Signed-off-by: Sven Peter <sven@svenpeter.dev>
>> ---
>>  drivers/usb/typec/tipd/core.c     | 44 +++++++++++++++++++++++++++++++
>>  drivers/usb/typec/tipd/tps6598x.h |  6 +++++
>>  2 files changed, 50 insertions(+)
>> 
>> diff --git a/drivers/usb/typec/tipd/core.c b/drivers/usb/typec/tipd/core.c
>> index e96b17fe6af6..26807c050662 100644
>> --- a/drivers/usb/typec/tipd/core.c
>> +++ b/drivers/usb/typec/tipd/core.c
>> @@ -30,6 +30,7 @@
>>  #define TPS_REG_INT_MASK2		0x17
>>  #define TPS_REG_INT_CLEAR1		0x18
>>  #define TPS_REG_INT_CLEAR2		0x19
>> +#define TPS_REG_SYSTEM_POWER_STATE	0x20
>>  #define TPS_REG_STATUS			0x1a
>>  #define TPS_REG_SYSTEM_CONF		0x28
>>  #define TPS_REG_CTRL_CONF		0x29
>> @@ -84,6 +85,8 @@ struct tps6598x_hw {
>>  	unsigned int irq_data_status_update;
>>  	unsigned int irq_plug_event;
>>  	void (*irq_trace)(u64 event1, u64 event2);
>> +
>> +	bool supports_spss;
>>  };
[...]
>>  static int devm_tps6598_psy_register(struct tps6598x *tps)
>>  {
>>  	struct power_supply_config psy_cfg = {};
>> @@ -648,6 +685,11 @@ static int tps6598x_probe(struct i2c_client *client)
>>  	if (ret)
>>  		return ret;
>>  
>> +	/* Switch Apple chips to the correct system power state */
>> +	ret = cd321x_switch_power_state(tps, TPS_SYSTEM_POWER_STATE_S0);
>> +	if (ret)
>> +		return ret;
>
> If you call this from the same quirk where you set the mask for your
> board, you don't need that supports_spss flag at all, right?

Yup, that one will also disappear then.

Thanks,

Sven

  reply	other threads:[~2021-09-22 15:00 UTC|newest]

Thread overview: 31+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-09-18 12:09 [RFT PATCH 0/9] usb: typec: tipd: Add Apple M1 support Sven Peter
2021-09-18 12:09 ` [RFT PATCH 1/9] dt-bindings: usb: tps6598x: Add Apple CD321x compatible Sven Peter
2021-09-19 11:25   ` Alyssa Rosenzweig
2021-09-22 20:38   ` Rob Herring
2021-09-18 12:09 ` [RFT PATCH 2/9] usb: typec: tipd: Prepare supporting different variants Sven Peter
2021-09-19 11:27   ` Alyssa Rosenzweig
2021-09-21 13:10   ` Heikki Krogerus
2021-09-22 14:55     ` Sven Peter
2021-09-18 12:09 ` [RFT PATCH 3/9] usb: typec: tipd: Allow irq controller selection Sven Peter
2021-09-19 11:28   ` Alyssa Rosenzweig
2021-09-21 13:21   ` Heikki Krogerus
2021-09-22 14:56     ` Sven Peter
2021-09-18 12:09 ` [RFT PATCH 4/9] usb: typec: tipd: Add short-circuit for no irqs Sven Peter
2021-09-21 13:23   ` Heikki Krogerus
2021-09-18 12:09 ` [RFT PATCH 5/9] usb: typec: tipd: Allow to configure irq bits Sven Peter
2021-09-21 13:34   ` Heikki Krogerus
2021-09-22 14:58     ` Sven Peter
2021-09-18 12:09 ` [RFT PATCH 6/9] usb: typec: tipd: Setup IntMask explicitly Sven Peter
2021-09-19 11:31   ` Alyssa Rosenzweig
2021-09-21 13:40   ` Heikki Krogerus
2021-09-22 14:58     ` Sven Peter
2021-09-18 12:09 ` [RFT PATCH 7/9] usb: typec: tipd: Add support for apple,cd321x Sven Peter
2021-09-19 11:32   ` Alyssa Rosenzweig
2021-09-18 12:09 ` [RFT PATCH 8/9] usb: typec: tipd: Switch power state to S0 for Apple variant Sven Peter
2021-09-19 11:33   ` Alyssa Rosenzweig
2021-09-21 13:46   ` Heikki Krogerus
2021-09-22 15:00     ` Sven Peter [this message]
2021-09-18 12:09 ` [RFT PATCH 9/9] usb: typec: tipd: Remove FIXME about testing with I2C_FUNC_I2C Sven Peter
2021-09-19 11:33   ` Alyssa Rosenzweig
2021-09-21 13:41   ` Heikki Krogerus
2021-09-19 11:35 ` [RFT PATCH 0/9] usb: typec: tipd: Add Apple M1 support Alyssa Rosenzweig

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=d8024591-0142-442e-98e9-0c92a7679768@www.fastmail.com \
    --to=sven@svenpeter.dev \
    --cc=agx@sigxcpu.org \
    --cc=alyssa@rosenzweig.io \
    --cc=bryan.odonoghue@linaro.org \
    --cc=graf@amazon.com \
    --cc=gregkh@linuxfoundation.org \
    --cc=heikki.krogerus@linux.intel.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-usb@vger.kernel.org \
    --cc=marcan@marcan.st \
    --cc=mark.kettenis@xs4all.nl \
    --cc=mohamed.mediouni@caramail.com \
    --cc=stan@corellium.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).