Re: [PATCH v2 2/2] net: macb: Kconfig: Rename Atmel to Cadence

[<Nicolas.Ferre@microchip.com>]

On 25/06/2019 at 10:48, Palmer Dabbelt wrote:
> The help text makes it look like NET_VENDOR_CADENCE enables support for
> Atmel devices, when in reality it's a driver written by Atmel that
> supports Cadence devices.  This may confuse users that have this device
> on a non-Atmel SoC.
> 
> The fix is just s/Atmel/Cadence/, but I did go and re-wrap the Kconfig
> help text as that change caused it to go over 80 characters.
> 
> Signed-off-by: Palmer Dabbelt <palmer@sifive.com>

Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com>

> ---
>   drivers/net/ethernet/cadence/Kconfig | 6 +++---
>   1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/ethernet/cadence/Kconfig b/drivers/net/ethernet/cadence/Kconfig
> index 64d8d6ee7739..f4b3bd85dfe3 100644
> --- a/drivers/net/ethernet/cadence/Kconfig
> +++ b/drivers/net/ethernet/cadence/Kconfig
> @@ -1,6 +1,6 @@
>   # SPDX-License-Identifier: GPL-2.0-only
>   #
> -# Atmel device configuration
> +# Cadence device configuration
>   #
>   
>   config NET_VENDOR_CADENCE
> @@ -13,8 +13,8 @@ config NET_VENDOR_CADENCE
>   	  If unsure, say Y.
>   
>   	  Note that the answer to this question doesn't directly affect the
> -	  kernel: saying N will just cause the configurator to skip all
> -	  the remaining Atmel network card questions. If you say Y, you will be
> +	  kernel: saying N will just cause the configurator to skip all the
> +	  remaining Cadence network card questions. If you say Y, you will be
>   	  asked for your specific card in the following questions.
>   
>   if NET_VENDOR_CADENCE
> 


-- 
Nicolas Ferre