Re: [PATCH net-next 2/2] net: dsa: mv88e6xxx: implement egress tbf qdisc for 6393x family

[Andrew Lunn <andrew@lunn.ch>]

> +int mv88e6393x_tbf_add(struct mv88e6xxx_chip *chip, int port,
> +		       struct tc_tbf_qopt_offload_replace_params *replace_params)
> +{
> +	int rate_kbps = DIV_ROUND_UP(replace_params->rate.rate_bytes_ps * 8, 1000);
> +	int overhead = DIV_ROUND_UP(replace_params->rate.overhead, 4);
> +	int rate_step, decrement_rate, err;
> +	u16 val;
> +
> +	if (rate_kbps < MV88E6393X_PORT_EGRESS_RATE_MIN_KBPS ||
> +	    rate_kbps >= MV88E6393X_PORT_EGRESS_RATE_MAX_KBPS)
> +		return -EOPNOTSUPP;
> +
> +	if (replace_params->rate.overhead > MV88E6393X_PORT_EGRESS_MAX_OVERHEAD)
> +		return -EOPNOTSUPP;
> +
> +	/* Switch supports only max rate configuration. There is no
> +	 * configurable burst/max size nor latency.

Can you return -EOPNOTSUPP if these values are not 0? That should make
it clear to the user they are not supported.

>  /* Offset 0x09: Egress Rate Control */
> -#define MV88E6XXX_PORT_EGRESS_RATE_CTL1		0x09
> +#define MV88E6XXX_PORT_EGRESS_RATE_CTL1				0x09
> +#define MV88E6XXX_PORT_EGRESS_RATE_CTL1_STEP_64_KBPS		0x1E84
> +#define MV88E6XXX_PORT_EGRESS_RATE_CTL1_STEP_1_MBPS		0x01F4
> +#define MV88E6XXX_PORT_EGRESS_RATE_CTL1_STEP_10_MBPS		0x0032
> +#define MV88E6XXX_PORT_EGRESS_RATE_CTL1_STEP_100_MBPS		0x0005
> +#define MV88E6XXXw_PORT_EGRESS_RATE_CTL1_FRAME_OVERHEAD_SHIFT	8

Are they above values specific to the 6393? Or will they also work for
other families? You use the MV88E6XXX prefix which means they should
be generic across all devices.

	Andrew