On Tue, Mar 23, 2021 at 01:57:25PM +0100, BALATON Zoltan wrote:
> On Tue, 23 Mar 2021, David Gibson wrote:
> > On Wed, Mar 17, 2021 at 02:17:51AM +0100, BALATON Zoltan wrote:
> > > Hello,
> > > 
> > > This is adding a new PPC board called pegasos2. More info on it can be
> > > found at:
> > > 
> > > https://osdn.net/projects/qmiga/wiki/SubprojectPegasos2
> > > 
> > > Currently it needs a firmware ROM image that I cannot include due to
> > > original copyright holder (bPlan) did not release it under a free
> > > licence but I have plans to write a replacement in the future. With
> > > the original board firmware it can boot MorphOS now as:
> > > 
> > > qemu-system-ppc -M pegasos2 -cdrom morphos.iso -device ati-vga,romfile="" -serial stdio
> > > 
> > > then enter "boot cd boot.img" at the firmware "ok" prompt as described
> > > in the MorphOS.readme. To boot Linux use same command line with e.g.
> > > -cdrom debian-8.11.0-powerpc-netinst.iso then enter
> > > "boot cd install/pegasos"
> > > 
> > > The last patch adds the actual board code after previous patches
> > > adding VT8231 and MV64361 system controller chip emulation.
> > 
> > I've applied 1..5 to a new ppc-for-6.1 branch.  Sorry it didn't make
> > it for 6.0, I just didn't have time to look this over until too late.
> 
> Thanks but maybe you should wait if the dropped original first patch can be
> reviewed now and brought back. It would be easier for me to resubmit whole
> series rebased than port the dropped patch on top of a partly applied
> series. Also first patches without the last two is not much useful as the
> vt8231 model these add would not be used by anything else.

Ok, I've dropped your patches from ppc-for-6.1 again, and I'll wait
for the next posting.

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson