xen-devel.lists.xenproject.org archive mirror
 help / color / mirror / Atom feed
From: "Jan Beulich" <JBeulich@suse.com>
To: David Vrabel <david.vrabel@citrix.com>,
	Boris Ostrovsky <boris.ostrovsky@oracle.com>,
	Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>,
	Juergen Gross <JGross@suse.com>
Cc: xen-devel <xen-devel@lists.xenproject.org>, linux-kernel@vger.kernel.org
Subject: [PATCH v2 1/2] xen-pciback: return proper values during BAR sizing
Date: Tue, 07 Jun 2016 00:30:57 -0600	[thread overview]
Message-ID: <5756864102000078000F269A__42665.0695190348$1465281130$gmane$org@prv-mh.provo.novell.com> (raw)
In-Reply-To: <5756857802000078000F268D@prv-mh.provo.novell.com>

Reads following writes with all address bits set to 1 should return all
changeable address bits as one, not the BAR size (nor, as was the case
for the upper half of 64-bit BARs, the high half of the region's end
address). Presumably this didn't cause any problems so far because
consumers use the value to calculate the size (usually via val & -val),
and do nothing else with it.

But also consider the exception here: Unimplemented BARs should always
return all zeroes.

And finally, the check for whether to return the sizing address on read
for the ROM BAR should ignore all non-address bits, not just the ROM
Enable one.

Signed-off-by: Jan Beulich <jbeulich@suse.com>
Reviewed-by: Boris Ostrovsky <boris.ostrovsky@oracle.com>
---
 drivers/xen/xen-pciback/conf_space_header.c |   18 +++++++++++-------
 1 file changed, 11 insertions(+), 7 deletions(-)

--- 4.7-rc2-xen-pciback-BAR.orig/drivers/xen/xen-pciback/conf_space_header.c
+++ 4.7-rc2-xen-pciback-BAR/drivers/xen/xen-pciback/conf_space_header.c
@@ -145,7 +145,7 @@ static int rom_write(struct pci_dev *dev
 	/* A write to obtain the length must happen as a 32-bit write.
 	 * This does not (yet) support writing individual bytes
 	 */
-	if (value == ~PCI_ROM_ADDRESS_ENABLE)
+	if ((value | ~PCI_ROM_ADDRESS_MASK) == ~0)
 		bar->which = 1;
 	else {
 		u32 tmpval;
@@ -225,38 +225,42 @@ static inline void read_dev_bar(struct p
 			   (PCI_BASE_ADDRESS_SPACE_MEMORY |
 				PCI_BASE_ADDRESS_MEM_TYPE_64))) {
 			bar_info->val = res[pos - 1].start >> 32;
-			bar_info->len_val = res[pos - 1].end >> 32;
+			bar_info->len_val = -resource_size(&res[pos - 1]) >> 32;
 			return;
 		}
 	}
 
+	if (!res[pos].flags ||
+	    (res[pos].flags & (IORESOURCE_DISABLED | IORESOURCE_UNSET |
+			       IORESOURCE_BUSY)))
+		return;
+
 	bar_info->val = res[pos].start |
 			(res[pos].flags & PCI_REGION_FLAG_MASK);
-	bar_info->len_val = resource_size(&res[pos]);
+	bar_info->len_val = -resource_size(&res[pos]) |
+			    (res[pos].flags & PCI_REGION_FLAG_MASK);
 }
 
 static void *bar_init(struct pci_dev *dev, int offset)
 {
-	struct pci_bar_info *bar = kmalloc(sizeof(*bar), GFP_KERNEL);
+	struct pci_bar_info *bar = kzalloc(sizeof(*bar), GFP_KERNEL);
 
 	if (!bar)
 		return ERR_PTR(-ENOMEM);
 
 	read_dev_bar(dev, bar, offset, ~0);
-	bar->which = 0;
 
 	return bar;
 }
 
 static void *rom_init(struct pci_dev *dev, int offset)
 {
-	struct pci_bar_info *bar = kmalloc(sizeof(*bar), GFP_KERNEL);
+	struct pci_bar_info *bar = kzalloc(sizeof(*bar), GFP_KERNEL);
 
 	if (!bar)
 		return ERR_PTR(-ENOMEM);
 
 	read_dev_bar(dev, bar, offset, ~PCI_ROM_ADDRESS_ENABLE);
-	bar->which = 0;
 
 	return bar;
 }




_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xen.org
http://lists.xen.org/xen-devel

       reply	other threads:[~2016-06-07  6:31 UTC|newest]

Thread overview: 10+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
     [not found] <5756857802000078000F268D@prv-mh.provo.novell.com>
2016-06-07  6:30 ` Jan Beulich [this message]
2016-06-07  6:31 ` [PATCH v2 2/2] xen-pciback: clean up {bar,rom}_init() Jan Beulich
     [not found] ` <5756864102000078000F269A@prv-mh.provo.novell.com>
2016-06-07 14:06   ` [PATCH v2 1/2] xen-pciback: return proper values during BAR sizing Boris Ostrovsky
     [not found]   ` <5756D4F4.7070802@oracle.com>
2016-06-07 14:14     ` Jan Beulich
2016-06-24  9:13   ` [PATCH v3 " Jan Beulich
     [not found]   ` <576D15DE02000078000F8678@prv-mh.provo.novell.com>
2016-06-24 14:08     ` David Vrabel
     [not found] ` <5756866F02000078000F269D@prv-mh.provo.novell.com>
2016-06-07 14:06   ` [PATCH v2 2/2] xen-pciback: clean up {bar, rom}_init() Boris Ostrovsky
2016-06-24 15:01   ` David Vrabel
     [not found]   ` <576D4B59.9070906@citrix.com>
2016-06-27  7:24     ` Jan Beulich
     [not found]     ` <5770F0CF02000078000F8DD3@prv-mh.provo.novell.com>
2016-06-29 12:42       ` David Vrabel

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to='5756864102000078000F269A__42665.0695190348$1465281130$gmane$org@prv-mh.provo.novell.com' \
    --to=jbeulich@suse.com \
    --cc=JGross@suse.com \
    --cc=boris.ostrovsky@oracle.com \
    --cc=david.vrabel@citrix.com \
    --cc=konrad.wilk@oracle.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=xen-devel@lists.xenproject.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).