[PATCH 38/39] bebob: Send a cue to load firmware for M-Audio Firewire series

From: Takashi Sakamoto <o-takashi@sakamocchi.jp>
To: clemens@ladisch.de, tiwai@suse.de, perex@perex.cz
Cc: alsa-devel@alsa-project.org, ffado-devel@lists.sf.net
Subject: [PATCH 38/39] bebob: Send a cue to load firmware for M-Audio Firewire series
Date: Fri, 28 Feb 2014 12:27:51 +0900	[thread overview]
Message-ID: <1393558072-25926-39-git-send-email-o-takashi@sakamocchi.jp> (raw)
In-Reply-To: <1393558072-25926-1-git-send-email-o-takashi@sakamocchi.jp>

Just powering on, these devices below wait to download firmware.
 - Firewire Audiophile
 - Firewire 410

But firmware version 5058 or later, flash memory in the device stores the
firmware. So this driver can enable these devices by sending a certain cue to
load the firmware.

Signed-off-by: Takashi Sakamoto <o-takashi@sakamocchi.jp>
---
 sound/firewire/bebob/bebob.c        | 22 +++++++-----
 sound/firewire/bebob/bebob.h        |  2 ++
 sound/firewire/bebob/bebob_maudio.c | 69 +++++++++++++++++++++++++++++++++++++
 3 files changed, 84 insertions(+), 9 deletions(-)

diff --git a/sound/firewire/bebob/bebob.c b/sound/firewire/bebob/bebob.c
index 21de883..a2104c7 100644
--- a/sound/firewire/bebob/bebob.c
+++ b/sound/firewire/bebob/bebob.c
@@ -175,18 +175,21 @@ bebob_probe(struct fw_unit *unit,
 	}
 
 	if ((entry->vendor_id == VEN_FOCUSRITE) &&
-	    (entry->model_id == MODEL_FOCUSRITE_SAFFIRE_BOTH)) {
+	    (entry->model_id == MODEL_FOCUSRITE_SAFFIRE_BOTH))
 		spec = get_saffire_spec(unit);
-	} else if ((entry->vendor_id == VEN_MAUDIO1) &&
-		   (entry->model_id == MODEL_MAUDIO_AUDIOPHILE_BOTH) &&
-		   !check_audiophile_booted(unit)) {
-			err = 0;
-			goto end;
-	} else {
+	else if ((entry->vendor_id == VEN_MAUDIO1) &&
+		 (entry->model_id == MODEL_MAUDIO_AUDIOPHILE_BOTH) &&
+		 !check_audiophile_booted(unit))
+		spec = NULL;
+	else
 		spec = (const struct snd_bebob_spec *)entry->driver_data;
-	}
+
 	if (spec == NULL) {
-		err = -ENOSYS;
+		if ((entry->vendor_id == VEN_MAUDIO1) ||
+		    (entry->vendor_id == VEN_MAUDIO2))
+			err = snd_bebob_maudio_load_firmware(unit);
+		else
+			err = -ENOSYS;
 		goto end;
 	}
 
@@ -364,6 +367,7 @@ static const struct ieee1394_device_id bebob_id_table[] = {
 	SND_BEBOB_DEV_ENTRY(VEN_FOCUSRITE, MODEL_FOCUSRITE_SAFFIRE_BOTH,
 			    &saffire_spec),
 	/* M-Audio, Firewire 410 */
+	SND_BEBOB_DEV_ENTRY(VEN_MAUDIO2, 0x00010058, NULL),	/* bootloader */
 	SND_BEBOB_DEV_ENTRY(VEN_MAUDIO2, 0x00010046, &maudio_fw410_spec),
 	/* M-Audio, Firewire Audiophile */
 	SND_BEBOB_DEV_ENTRY(VEN_MAUDIO1, MODEL_MAUDIO_AUDIOPHILE_BOTH,
diff --git a/sound/firewire/bebob/bebob.h b/sound/firewire/bebob/bebob.h
index 1e9af0e..b08cbbb 100644
--- a/sound/firewire/bebob/bebob.h
+++ b/sound/firewire/bebob/bebob.h
@@ -242,6 +242,8 @@ extern struct snd_bebob_spec maudio_solo_spec;
 extern struct snd_bebob_spec maudio_ozonic_spec;
 extern struct snd_bebob_spec maudio_nrv10_spec;
 
+int snd_bebob_maudio_load_firmware(struct fw_unit *unit);
+
 #define SND_BEBOB_DEV_ENTRY(vendor, model, data) \
 { \
 	.match_flags	= IEEE1394_MATCH_VENDOR_ID | \
diff --git a/sound/firewire/bebob/bebob_maudio.c b/sound/firewire/bebob/bebob_maudio.c
index 7c8f5c1..e3ab42c 100644
--- a/sound/firewire/bebob/bebob_maudio.c
+++ b/sound/firewire/bebob/bebob_maudio.c
@@ -15,6 +15,15 @@
  * settings when completing uploading. Then these devices generate bus reset
  * and are recognized as new devices with the firmware.
  *
+ * But with firmware version 5058 or later, the firmware is stored to flash
+ * memory in the device and drivers can tell DM1000 to load the firmware by
+ * sending a cue. This cue must be sent one time.
+ *
+ * If the firmware blobs are in alsa-firmware package, this driver can support
+ * these devices with any firmware versions. (Then this driver need codes to
+ * upload the firmware blob.) But for this, the license of firmware blob needs
+ * to be considered.
+ *
  * For streaming, both of output and input streams are needed for Firewire 410
  * and Ozonic. The single stream is OK for the other devices even if the clock
  * source is not SYT-Match (I note no devices use SYT-Match).
@@ -24,6 +33,20 @@
  * mixer.
  */
 
+/* Offset from information register */
+#define INFO_OFFSET_SW_DATE	0x20
+
+/* Bootloader Protocol Version 1 */
+#define MAUDIO_BOOTLOADER_CUE1	0x00000001
+/*
+ * Initializing configuration to factory settings (= 0x1101), (swapped in line),
+ * Command code is zero (= 0x00),
+ * the number of operands is zero (= 0x00)(at least significant byte)
+ */
+#define MAUDIO_BOOTLOADER_CUE2	0x01110000
+/* padding */
+#define MAUDIO_BOOTLOADER_CUE3	0x00000000
+
 #define MAUDIO_SPECIFIC_ADDRESS	0xffc700000000
 
 #define METER_OFFSET		0x00600000
@@ -50,6 +73,52 @@
 /* for NRV */
 #define UNKNOWN_METER	"Unknown"
 
+/*
+ * For some M-Audio devices, this module just send cue to load firmware. After
+ * loading, the device generates bus reset and newly detected.
+ *
+ * If we make any transactions to load firmware, the operation may failed.
+ */
+int snd_bebob_maudio_load_firmware(struct fw_unit *unit)
+{
+	struct fw_device *device = fw_parent_device(unit);
+	int err, rcode;
+	u64 date;
+	__be32 cues[3] = {
+		MAUDIO_BOOTLOADER_CUE1,
+		MAUDIO_BOOTLOADER_CUE2,
+		MAUDIO_BOOTLOADER_CUE3
+	};
+
+	/* check date of software used to build */
+	err = snd_bebob_read_block(unit, INFO_OFFSET_SW_DATE,
+				   &date, sizeof(u64));
+	if (err < 0)
+		goto end;
+	/*
+	 * firmware version 5058 or later has date later than "20070401", but
+	 * 'date' is not null-terminated.
+	 */
+	if (date < 0x3230303730343031) {
+		dev_err(&unit->device,
+			"Use firmware version 5058 or later\n");
+		err = -ENOSYS;
+		goto end;
+	}
+
+	rcode = fw_run_transaction(device->card, TCODE_WRITE_BLOCK_REQUEST,
+				   device->node_id, device->generation,
+				   device->max_speed, BEBOB_ADDR_REG_REQ,
+				   cues, sizeof(cues));
+	if (rcode != RCODE_COMPLETE) {
+		dev_err(&unit->device,
+			"Failed to send a cue to load firmware\n");
+		err = -EIO;
+	}
+end:
+	return err;
+}
+
 static inline int
 get_meter(struct snd_bebob *bebob, void *buf, unsigned int size)
 {
-- 
1.8.3.2
