All of lore.kernel.org
 help / color / mirror / Atom feed
From: mchristi@redhat.com
To: linux-fsdevel@vger.kernel.org, dm-devel@redhat.com,
	linux-raid@vger.kernel.org, linux-kernel@vger.kernel.org,
	linux-scsi@vger.kernel.org, drbd-dev@lists.linbit.com
Subject: [RESEND RFC PATCH 00/32] separate operations from flags in the bio/request structs
Date: Wed,  4 Nov 2015 16:07:57 -0600	[thread overview]
Message-ID: <1446674909-5371-1-git-send-email-mchristi@redhat.com> (raw)

This is just a resend of the patchset from earlier today. There was
a error in the middle of sending the set, so it looks like 10 - 32 got
dropped.

There are a couple new block layer commands we are trying to add support
for in the near term:

compare and write
http://www.spinics.net/lists/target-devel/msg07826.html

copy offload/extended copy/xcopy
https://www.redhat.com/archives/dm-devel/2014-July/msg00070.html

The problem is if we contine to add more commands we will have to one day
extend the cmd_flags/bi_rw fields again. To prevent that, this patchset
separates the operation (REQ_WRITE, REQ_DISCARD, REQ_WRITE_SAME, etc) from
the flags (REQ_SYNC, REQ_QUIET, etc) in the bio and request structs. In the
end of this set, we will have two fields bio->bi_op/request->op and
bio->bi_rw/request->cmd_flags.

The patches were made against Jens's linux-block tree's for-linus branch:
https://git.kernel.org/cgit/linux/kernel/git/axboe/linux-block.git/log/?h=for-linus
(last commit a22c4d7e34402ccdf3414f64c50365436eba7b93).

I have done some basic testing for a lot of the drivers and filesystems,
but I wanted to get comments before trying to track down more hardware/
systems for testing.


Known issues:
- REQ_FLUSH is still a flag, but should probably be a operation.
 For lower level drivers like SCSI where we only get a flush, it makes
more sense to be a operation. However, upper layers like filesystems
can send down flushes with writes, so it is more of a flag for them.
I am still working on this.

- There is a regression with the dm flakey target. It currently
cannot corrupt the operation values.

- The patchset is a little awkward. It touches so much code,
but I wanted to maintain git bisectibility, so there is lots of compat code
left around until the last patches where everyting is cleaned up.

             reply	other threads:[~2015-11-04 22:07 UTC|newest]

Thread overview: 51+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-11-04 22:07 mchristi [this message]
2015-11-04 22:07 ` [PATCH 01/32] block/fs: add REQ_OP definitions mchristi
2015-11-04 22:07 ` [PATCH 02/32] block/fs/mm: prepare submit_bio_wait users for bi_rw split mchristi
2015-11-05  7:14   ` Hannes Reinecke
2015-11-04 22:08 ` [PATCH 03/32] dio/btrfs: prep dio->submit_bio " mchristi
2015-11-04 22:08 ` [PATCH 04/32] block: prepare blkdev_issue_discard " mchristi
2015-11-04 22:08 ` [PATCH 05/32] drbd: prepare drbd " mchristi
2015-11-04 22:08 ` [PATCH 06/32] xen blkback: prepare " mchristi
     [not found]   ` <1446674909-5371-7-git-send-email-mchristi-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2015-11-07 10:17     ` Christoph Hellwig
2015-11-07 10:17       ` Christoph Hellwig
2015-11-07 14:04       ` Konrad Rzeszutek Wilk
2015-11-07 14:04         ` Konrad Rzeszutek Wilk
2015-11-09  4:00       ` Bob Liu
2015-11-09  4:00         ` Bob Liu
2015-11-07 10:17   ` Christoph Hellwig
2015-11-04 22:08 ` [PATCH 07/32] dm: " mchristi
2015-11-04 22:08 ` [PATCH 08/32] target: " mchristi
2015-11-04 22:08 ` [PATCH 09/32] btrfs: " mchristi
2015-11-04 22:08 ` [PATCH 10/32] f2fs: " mchristi
2015-11-04 22:08 ` [PATCH 11/32] gfs2: " mchristi
2015-11-04 22:08 ` [PATCH 12/32] xfs: " mchristi
2015-11-04 22:08 ` [PATCH 13/32] mm: " mchristi
2015-11-04 22:08 ` [PATCH 14/32] block/fs/mm: pass in op and flags to submit_bio mchristi
2015-11-04 22:08 ` [PATCH 15/32] btrfs: prepare for bi_rw split mchristi
2015-11-04 22:08 ` [PATCH 16/32] block/fs/md: pass in op and flags to submit_bh mchristi
2015-11-04 22:08 ` [PATCH 17/32] block: add operation field to bio struct mchristi
2015-11-04 22:08 ` [PATCH 18/32] drbd: set bio bi_op to REQ_OP mchristi
2015-11-04 22:08 ` [PATCH 19/32] block: add helper to get data dir from op mchristi
     [not found]   ` <1446674909-5371-20-git-send-email-mchristi-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2015-11-04 22:44     ` [dm-devel] " Bart Van Assche
2015-11-04 22:44       ` Bart Van Assche
2015-11-04 22:44       ` Bart Van Assche
2015-11-05 17:34       ` Mike Christie
     [not found]         ` <563B930F.7040705-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2015-11-07 10:19           ` Christoph Hellwig
2015-11-07 10:19             ` Christoph Hellwig
2015-11-04 22:08 ` [PATCH 20/32] md: set bi_op to REQ_OP mchristi
2015-11-04 22:08 ` [PATCH 21/32] bcache: " mchristi
2015-11-04 22:08 ` [PATCH 22/32] block/fs/drivers: " mchristi
2015-11-04 22:08 ` [PATCH 23/32] block/fs: pass in op and flags to ll_rw_block mchristi
2015-11-04 22:08 ` [PATCH 24/32] dm: pass dm stats data dir instead of bi_rw mchristi
2015-11-04 22:08 ` [PATCH 25/32] block: add operation field to request struct mchristi
2015-11-04 22:08 ` [PATCH 26/32] ide cd: do not set REQ_WRITE on requests mchristi
2015-11-04 22:08 ` [PATCH 27/32] cfq/cgroup: pass operation and flags seperately mchristi
2015-11-04 22:08 ` [PATCH 28/32] block/fs/drivers: use bio/rq_data_dir helpers mchristi
2015-11-04 22:08 ` [PATCH 29/32] block/drivers: rm request cmd_flags REQ_OP use mchristi
2015-11-04 22:08 ` [PATCH 30/32] drbd: don't use bi_rw for operations mchristi
2015-11-04 22:08 ` [PATCH 31/32] block/fs/driver: rm bio bi_rw REQ_OP use mchristi
2015-11-04 22:08 ` [PATCH 32/32] block: remove __REQ op defs and reduce bi_op/bi_rw sizes mchristi
     [not found]   ` <1446674909-5371-33-git-send-email-mchristi-H+wXaHxf7aLQT0dZR+AlfA@public.gmane.org>
2015-11-07 10:21     ` Christoph Hellwig
2015-11-07 10:21       ` Christoph Hellwig
2015-11-05 16:44 ` [RESEND RFC PATCH 00/32] separate operations from flags in the bio/request structs Bob Peterson
2015-11-07 10:10 ` Christoph Hellwig

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1446674909-5371-1-git-send-email-mchristi@redhat.com \
    --to=mchristi@redhat.com \
    --cc=dm-devel@redhat.com \
    --cc=drbd-dev@lists.linbit.com \
    --cc=linux-fsdevel@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-raid@vger.kernel.org \
    --cc=linux-scsi@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.