[PATCH 2/2] spi: spi-geni-qcom: Add SPI SLAVE mode support for GENI based QuPv3

From: Praveen Talari <quic_ptalari@quicinc.com>
To: <agross@kernel.org>, <andersson@kernel.org>,
	<konrad.dybcio@linaro.org>, <broonie@kernel.org>,
	<linux-arm-msm@vger.kernel.org>, <linux-spi@vger.kernel.org>,
	<linux-kernel@vger.kernel.org>
Cc: <quic_msavaliy@quicinc.com>, <quic_vtanuku@quicinc.com>,
	<quic_vnivarth@quicinc.com>, <quic_arandive@quicinc.com>,
	Praveen Talari <quic_ptalari@quicinc.com>
Subject: [PATCH 2/2] spi: spi-geni-qcom: Add SPI SLAVE mode support for GENI based QuPv3
Date: Tue, 13 Jun 2023 12:22:29 +0530	[thread overview]
Message-ID: <20230613065229.5619-3-quic_ptalari@quicinc.com> (raw)
In-Reply-To: <20230613065229.5619-1-quic_ptalari@quicinc.com>

Add SPI SLAVE mode support for GENI based QuPv3.

Signed-off-by: Praveen Talari <quic_ptalari@quicinc.com>
---
 drivers/spi/spi-geni-qcom.c | 55 +++++++++++++++++++++++++++++++++----
 1 file changed, 49 insertions(+), 6 deletions(-)

diff --git a/drivers/spi/spi-geni-qcom.c b/drivers/spi/spi-geni-qcom.c
index 206cc04bb1ed..2e3ae29e79e0 100644
--- a/drivers/spi/spi-geni-qcom.c
+++ b/drivers/spi/spi-geni-qcom.c
@@ -12,6 +12,7 @@
 #include <linux/platform_device.h>
 #include <linux/pm_opp.h>
 #include <linux/pm_runtime.h>
+#include <linux/property.h>
 #include <linux/soc/qcom/geni-se.h>
 #include <linux/spi/spi.h>
 #include <linux/spinlock.h>
@@ -52,6 +53,9 @@
 #define SPI_CS_CLK_DELAY_MSK		GENMASK(19, 10)
 #define SPI_CS_CLK_DELAY_SHFT		10
 
+#define SE_SPI_SLAVE_EN				(0x2BC)
+#define SPI_SLAVE_EN				BIT(0)
+
 /* M_CMD OP codes for SPI */
 #define SPI_TX_ONLY		1
 #define SPI_RX_ONLY		2
@@ -99,6 +103,24 @@ struct spi_geni_master {
 	int cur_xfer_mode;
 };
 
+static struct spi_master *get_spi_master(struct device *dev)
+{
+	struct platform_device *pdev = to_platform_device(dev);
+	struct spi_master *spi = platform_get_drvdata(pdev);
+
+	return spi;
+}
+
+static void spi_slv_setup(struct spi_geni_master *mas)
+{
+	struct geni_se *se = &mas->se;
+
+	writel(SPI_SLAVE_EN, se->base + SE_SPI_SLAVE_EN);
+	writel(GENI_IO_MUX_0_EN, se->base + GENI_OUTPUT_CTRL);
+	writel(START_TRIGGER, se->base + SE_GENI_CFG_SEQ_START);
+	dev_info(mas->dev, "spi slave setup done\n");
+}
+
 static int get_spi_clk_cfg(unsigned int speed_hz,
 			struct spi_geni_master *mas,
 			unsigned int *clk_idx,
@@ -140,12 +162,18 @@ static void handle_se_timeout(struct spi_master *spi,
 	const struct spi_transfer *xfer;
 
 	spin_lock_irq(&mas->lock);
-	reinit_completion(&mas->cancel_done);
 	if (mas->cur_xfer_mode == GENI_SE_FIFO)
 		writel(0, se->base + SE_GENI_TX_WATERMARK_REG);
 
 	xfer = mas->cur_xfer;
 	mas->cur_xfer = NULL;
+
+	if (spi->slave) {
+		spin_unlock_irq(&mas->lock);
+		goto unmap_if_dma;
+	}
+
+	reinit_completion(&mas->cancel_done);
 	geni_se_cancel_m_cmd(se);
 	spin_unlock_irq(&mas->lock);
 
@@ -541,6 +569,8 @@ static bool geni_can_dma(struct spi_controller *ctlr,
 
 	if (mas->cur_xfer_mode == GENI_GPI_DMA)
 		return true;
+	if (ctlr->slave)
+		return true;
 
 	len = get_xfer_len_in_words(xfer, mas);
 	fifo_size = mas->tx_fifo_depth * mas->fifo_width_bits / mas->cur_bits_per_word;
@@ -619,6 +649,7 @@ static void spi_geni_release_dma_chan(struct spi_geni_master *mas)
 
 static int spi_geni_init(struct spi_geni_master *mas)
 {
+	struct spi_master *spi = get_spi_master(mas->dev);
 	struct geni_se *se = &mas->se;
 	unsigned int proto, major, minor, ver;
 	u32 spi_tx_cfg, fifo_disable;
@@ -627,7 +658,14 @@ static int spi_geni_init(struct spi_geni_master *mas)
 	pm_runtime_get_sync(mas->dev);
 
 	proto = geni_se_read_proto(se);
-	if (proto != GENI_SE_SPI) {
+
+	if (spi->slave) {
+		if (proto != GENI_SE_SPI_SLAVE) {
+			dev_err(mas->dev, "Invalid proto %d\n", proto);
+			goto out_pm;
+		}
+		spi_slv_setup(mas);
+	} else if (proto != GENI_SE_SPI) {
 		dev_err(mas->dev, "Invalid proto %d\n", proto);
 		goto out_pm;
 	}
@@ -677,9 +715,11 @@ static int spi_geni_init(struct spi_geni_master *mas)
 	}
 
 	/* We always control CS manually */
-	spi_tx_cfg = readl(se->base + SE_SPI_TRANS_CFG);
-	spi_tx_cfg &= ~CS_TOGGLE;
-	writel(spi_tx_cfg, se->base + SE_SPI_TRANS_CFG);
+	if (!spi->slave) {
+		spi_tx_cfg = readl(se->base + SE_SPI_TRANS_CFG);
+		spi_tx_cfg &= ~CS_TOGGLE;
+		writel(spi_tx_cfg, se->base + SE_SPI_TRANS_CFG);
+	}
 
 out_pm:
 	pm_runtime_put(mas->dev);
@@ -1072,6 +1112,9 @@ static int spi_geni_probe(struct platform_device *pdev)
 	pm_runtime_set_autosuspend_delay(&pdev->dev, 250);
 	pm_runtime_enable(dev);
 
+	if (device_property_read_bool(&pdev->dev, "qcom,slv-ctrl"))
+		spi->slave = true;
+
 	ret = geni_icc_get(&mas->se, NULL);
 	if (ret)
 		goto spi_geni_probe_runtime_disable;
@@ -1092,7 +1135,7 @@ static int spi_geni_probe(struct platform_device *pdev)
 	 * for dma (gsi) mode, the gsi will set cs based on params passed in
 	 * TRE
 	 */
-	if (mas->cur_xfer_mode == GENI_SE_FIFO)
+	if (!spi->slave && mas->cur_xfer_mode == GENI_SE_FIFO)
 		spi->set_cs = spi_geni_set_cs;
 
 	ret = request_irq(mas->irq, geni_spi_isr, 0, dev_name(dev), spi);
-- 
2.17.1

