Re: [PATCH v2 0/4] I2C0/3/5 pin control for H3 and M3-W

From: Geert Uytterhoeven <geert@linux-m68k.org>
To: uli+renesas@fpond.eu
Cc: Linux-Renesas <linux-renesas-soc@vger.kernel.org>,
	Wolfram Sang <wsa@the-dreams.de>
Subject: Re: [PATCH v2 0/4] I2C0/3/5 pin control for H3 and M3-W
Date: Fri, 16 Nov 2018 09:30:46 +0100	[thread overview]
Message-ID: <CAMuHMdVTowMnS5YFgMOe+sC__zhhWp_MPtctDtCGAiYdoea7+w@mail.gmail.com> (raw)
In-Reply-To: <1542352851-25393-1-git-send-email-uli+renesas@fpond.eu>

Hi Uli,

On Fri, Nov 16, 2018 at 8:21 AM Ulrich Hecht <uli+renesas@fpond.eu> wrote:
> This is an up-port from the BSP. Unfortunately I could not test these
> because none of those pins seem to be accessible on Salvator boards (not on
> ULCB either, AFAICT), so the best thing I can say is that they don't seem to
> break anything.

I think I replied before...

For Salvator-X(S):
  1. If you set SW5 and SW6 to their center positions, you can access I2C3 on
     EXIO Connector D.
  2. I2C5 is available on test points CP45/46.

> This revision incorporates the suggestions made by Geert; see below for
> details.

Thanks for the update!

Gr{oetje,eeting}s,

                        Geert

-- 
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds