Re: [PATCH v2 2/3] dt-bindings: media: i2c: add galaxycore,gc2145 dt-bindings

From: Sakari Ailus <sakari.ailus@iki.fi>
To: Alain Volmat <alain.volmat@foss.st.com>
Cc: Mauro Carvalho Chehab <mchehab@kernel.org>,
	Rob Herring <robh+dt@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Jacopo Mondi <jacopo.mondi@ideasonboard.com>,
	Kieran Bingham <kieran.bingham@ideasonboard.com>,
	Rob Herring <robh@kernel.org>,
	linux-media@vger.kernel.org, devicetree@vger.kernel.org,
	linux-kernel@vger.kernel.org
Subject: Re: [PATCH v2 2/3] dt-bindings: media: i2c: add galaxycore,gc2145 dt-bindings
Date: Wed, 1 Nov 2023 13:23:56 +0000	[thread overview]
Message-ID: <ZUJRbI9ff83gH6Ng@valkosipuli.retiisi.eu> (raw)
In-Reply-To: <20231011175735.1824782-3-alain.volmat@foss.st.com>

Hi Alain,

On Wed, Oct 11, 2023 at 07:57:29PM +0200, Alain Volmat wrote:
> Introduction of the Galaxy Core GC2145 XVGA CMOS camera sensor.
> 
> Signed-off-by: Alain Volmat <alain.volmat@foss.st.com>
> ---
>  .../bindings/media/i2c/galaxycore,gc2145.yaml | 104 ++++++++++++++++++
>  1 file changed, 104 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml
> 
> diff --git a/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml b/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml
> new file mode 100644
> index 000000000000..94d194cf5452
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/i2c/galaxycore,gc2145.yaml
> @@ -0,0 +1,104 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/media/i2c/galaxycore,gc2145.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: Galaxy Core 1/5'' UXGA CMOS Image Sensor
> +
> +maintainers:
> +  - Alain Volmat <alain.volmat@foss.st.com>
> +
> +description:
> +  The Galaxy Core GC2145 is a high quality 2 Mega CMOS image sensor, for mobile
> +  phone camera applications and digital camera products. GC2145 incorporates a
> +  1616V x 1232H active pixel array, on-chip 10-bit ADC, and image signal
> +  processor. It is programmable through an I2C interface. Image data is sent
> +  either through a parallel interface or through MIPI CSI-2.
> +
> +allOf:
> +  - $ref: ../video-interface-devices.yaml#
> +
> +properties:
> +  compatible:
> +    const: galaxycore,gc2145
> +
> +  reg:
> +    const: 0x3c
> +
> +  clocks:
> +    maxItems: 1
> +
> +  powerdown-gpios:
> +    maxItems: 1
> +
> +  reset-gpios:
> +    maxItems: 1
> +
> +  iovdd-supply:
> +    description: Power Supply for I/O circuits (1.7 - 3V).
> +
> +  avdd-supply:
> +    description: Power for analog circuit/sensor array (2.7 - 3V).
> +
> +  dvdd-supply:
> +    description: Power for digital core (1.7 - 1.9V).
> +
> +  orientation: true
> +
> +  rotation: true
> +
> +  port:
> +    $ref: /schemas/graph.yaml#/$defs/port-base
> +
> +    properties:
> +      endpoint:
> +        $ref: /schemas/media/video-interfaces.yaml#
> +        unevaluatedProperties: false
> +
> +    required:
> +      - endpoint

Could you add link-frequencies here, too?

> +
> +    additionalProperties: false
> +
> +required:
> +  - compatible
> +  - reg
> +  - clocks
> +  - powerdown-gpios
> +  - reset-gpios
> +  - iovdd-supply
> +  - avdd-supply
> +  - dvdd-supply
> +  - port
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/gpio/gpio.h>
> +
> +    i2c {
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        camera@3c {
> +            compatible = "galaxycore,gc2145";
> +            reg = <0x3c>;
> +            clocks = <&clk_ext_camera>;
> +            iovdd-supply = <&scmi_v3v3_sw>;
> +            avdd-supply = <&scmi_v3v3_sw>;
> +            dvdd-supply = <&scmi_v3v3_sw>;
> +            powerdown-gpios = <&mcp23017 3 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
> +            reset-gpios = <&mcp23017 4 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
> +
> +            port {
> +                endpoint {
> +                    remote-endpoint = <&mipid02_0>;
> +                    data-lanes = <1 2>;
> +                };
> +            };
> +        };
> +    };
> +
> +...

-- 
Kind regards,

Sakari Ailus