Re: [PATCH v1 1/1] vfio/migration: Correct device state from vmstate change for savevm case.

[Kirti Wankhede <kwankhede@nvidia.com>]

CCing more Nvidia folks who are testing this patch.

Gentle Ping for review.

Thanks,
Kirti


On 6/9/2021 12:07 AM, Kirti Wankhede wrote:
> Set _SAVING flag for device state from vmstate change handler when it gets
> called from savevm.
> 
> Currently State transition savevm/suspend is seen as:
>      _RUNNING -> _STOP -> Stop-and-copy -> _STOP
> 
> State transition savevm/suspend should be:
>      _RUNNING -> Stop-and-copy -> _STOP
> 
> State transition from _RUNNING to _STOP occurs from vfio_vmstate_change()
> where when vmstate changes from running to !running, _RUNNING flag is reset
> but at the same time when vfio_vmstate_change() is called for
> RUN_STATE_SAVE_VM, _SAVING bit should be set.
> 
> Reported by: Yishai Hadas <yishaih@nvidia.com>
> Signed-off-by: Kirti Wankhede <kwankhede@nvidia.com>
> ---
>   hw/vfio/migration.c | 11 ++++++++++-
>   1 file changed, 10 insertions(+), 1 deletion(-)
> 
> diff --git a/hw/vfio/migration.c b/hw/vfio/migration.c
> index 384576cfc051..33242b2313b9 100644
> --- a/hw/vfio/migration.c
> +++ b/hw/vfio/migration.c
> @@ -725,7 +725,16 @@ static void vfio_vmstate_change(void *opaque, bool running, RunState state)
>            * _RUNNING bit
>            */
>           mask = ~VFIO_DEVICE_STATE_RUNNING;
> -        value = 0;
> +
> +        /*
> +         * When VM state transition to stop for savevm command, device should
> +         * start saving data.
> +         */
> +        if (state == RUN_STATE_SAVE_VM) {
> +            value = VFIO_DEVICE_STATE_SAVING;
> +        } else {
> +            value = 0;
> +        }
>       }
>   
>       ret = vfio_migration_set_state(vbasedev, mask, value);
>