Re: [PATCH V5 1/4] arm64: dts: qcom: sc7180: Improve the pin config settings for CTS and TX

[skakit@codeaurora.org]

Hi Doug,

On 2020-09-10 20:10, Doug Anderson wrote:
> Hi,
> 
> On Thu, Sep 10, 2020 at 5:55 AM satya priya <skakit@codeaurora.org> 
> wrote:
>> 
>> Remove output-high from CTS and TX as this is not really required. 
>> During
>> bringup to fix transfer failures this was added to match with console 
>> uart
>> settings. Probably some boot loader config was missing then. As it is
>> working fine now, remove it.
>> 
>> Signed-off-by: satya priya <skakit@codeaurora.org>
>> Reviewed-by: Akash Asthana <akashast@codeaurora.org>
>> Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
>> ---
>> Changes in V4:
>>  - This is newly added in V4 to separate the improvements in pin 
>> settings
>>    and wakeup related changes.
>> 
>> Changes in V5:
>>  - As per Doug's comment configured pull-down for CTS pin as earlier.
>> 
>>  arch/arm64/boot/dts/qcom/sc7180-idp.dts | 10 ++++------
>>  1 file changed, 4 insertions(+), 6 deletions(-)
> 
> Looks fine to me.  Slight nit that this only applies to the IDP board
> but ${SUBJECT} makes it sound as if this applies to all sc7180.  I
> wouldn't spin just for that, though.  If Bjorn agrees, he can always
> adjust the subject when applying.
> 
> Reviewed-by: Douglas Anderson <dianders@chromium.org>

Thanks for reviewing the patches, i will correct this nit in my next 
version.

Thanks,
Satya Priya