On Wednesday, 13 April 2022 09:01:49 CEST Kalle Valo wrote: > Sven Eckelmann writes: > > > On Friday, 26 November 2021 15:48:17 CET Sven Eckelmann wrote: > > [...] > >> * 8devices Pineapple > >> - 2GHz: 160 (0xa0) > >> - 5GHz: 161 (0xa1) > >> - 6GHz: 162 (0xa2) > >> * Compex WLE3000H5 > >> * (maybe there is not a single one which works?) > >> > >> If I would use these boards in one with a devicetree then I could just > >> overwrite it using qcom,board_id (and/or qcom,ath11k-calibration-variant). But > >> this isn't the case when I want to use a couple of these cards in a simple x86 > >> system. All off them (even when they are significantly different) are reported > >> as > >> > >> ath11k_pci 0000:03:00.0: chip_id 0x0 chip_family 0x0 board_id 0xff soc_id 0xffffffff > > > > I've send my 6GHz modules back to 8devices. They told me that this problem was > > identified and fixed in their calibration process. I've just got them back > > from them and now I see following reported by ath11k: > > > > ath11k_pci 0000:03:00.0: chip_id 0x0 chip_family 0x0 board_id 0xa2 soc_id 0xffffffff > > > > So it is definitely not a firmware problem and it should be fixed by the > > manufacturers (similar to what 8devices did). > > So the device is working fine now? 8devices Pineapple (after RMA) - yes. For Compex WLE3000H5 - not that I would know about any fixed HW revision. And for the EmWicon WMX7205/jjPlus WMX7205, it seems like the vendor=17cb,device=1103,subsystem-vendor=17cb,subsystem-device=0108 is used for identification of the actual vendor/product [0] (and not the board_id like on other devices). But as you can see, they say that it is a QCA product while it actually isn't actually one And the manufacturer is also not able to provide a BDF which is compatible (signed? [1]) for the usage with ath11k's firmware blob. Kind regards, Sven [0] https://lore.kernel.org/all/CACT4oud4hmkjrAPkOr0sG1DNNgcgQaKT2JNJzcivZey9b5Hpiw@mail.gmail.com/ [1] https://lore.kernel.org/all/DM6PR02MB69248F37B55ACCC868F8B82BE0769@DM6PR02MB6924.namprd02.prod.outlook.com/