From mboxrd@z Thu Jan 1 00:00:00 1970 From: Timur Tabi Date: Tue, 6 Sep 2011 09:36:06 -0500 Subject: [U-Boot] [PATCH 1/2] powerpc/85xx: CONFIG_ENABLE_36BIT_PHYS does not depend on CONFIG_PHYS_64BIT Message-ID: <1315319767-26906-1-git-send-email-timur@freescale.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is capable of 36-bit physical addresses, even if such large addresses are not used. On two boards, this macro was enabled only when building a 36-bit image. Signed-off-by: Timur Tabi --- include/configs/P1022DS.h | 3 ++- include/configs/p1_p2_rdb_pc.h | 3 +-- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h index a3cccf4..28848bd 100644 --- a/include/configs/P1022DS.h +++ b/include/configs/P1022DS.h @@ -43,8 +43,9 @@ #define CONFIG_FSL_PCIE_RESET /* need PCIe reset errata */ #define CONFIG_SYS_PCI_64BIT /* enable 64-bit PCI resources */ -#ifdef CONFIG_PHYS_64BIT #define CONFIG_ENABLE_36BIT_PHYS + +#ifdef CONFIG_PHYS_64BIT #define CONFIG_ADDR_MAP #define CONFIG_SYS_NUM_ADDR_MAP 16 /* number of TLB1 entries */ #endif diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h index b9b89cf..df1925f 100644 --- a/include/configs/p1_p2_rdb_pc.h +++ b/include/configs/p1_p2_rdb_pc.h @@ -204,9 +204,8 @@ #define CONFIG_BTB #define CONFIG_BOARD_EARLY_INIT_F /* Call board_pre_init */ -#ifdef CONFIG_PHYS_64BIT + #define CONFIG_ENABLE_36BIT_PHYS -#endif #ifdef CONFIG_PHYS_64BIT #define CONFIG_ADDR_MAP 1 -- 1.7.3.4