... > > > > > treat the absence of DT information as an error, and a call to > > > > > syscon_regmap_lookup_by_compatible or syscon_regmap_lookup_by_phandle > > > > > will always return the syscon device that was registered first, or > > > > > -EPROBE_DEFER for any error. > > > > > > > > The initial idea is search desired syscon device from drivers only by one function > > > > (i.e. search syscon device by compatible string or by specific alias) and no depend > > > > on DT or non-DT. I.e. define syscon device always at machine start (even if we run > > > > machine from DTS), because device should be always present in system. > > > > > > I don't understand yet what the advantage for clps711x is over just a single > > > register area that would get registered at boot time and replace all the > > > clps_readl/clps_writel calls. > > > > This cause a serious perfomance impact. Only SYSCON and SYSFLG is used > > in several places and should be protected by spinlocks. Other registers > > can be used without locks. And, as say before, clps_read/write will be replaced with > > read/write when registers will passed as resource. First example of this change I > > sent to you before (patchset for serial driver). > > Yes, that makes sense. I have no fundamental objections then. I'll wait > for the next version of your patch and then comment on any details I still > find sticking out. OK. Next version will be sent in few minutes. I am leave search by id_entry and extend it with variant from first patch version. This will allow to search syscon device with id_entry record in the driver, and without last one by specifying generic name with id (for example "syscon.0"). Thanks. --- {.n++%ݶw{.n+{G{ayʇڙ,jfhz_(階ݢj"mG?&~iOzv^m ?I