From mboxrd@z Thu Jan 1 00:00:00 1970 From: linus.walleij@linaro.org (Linus Walleij) Date: Sun, 19 May 2013 00:47:39 +0200 Subject: [PATCH] ARM: nomadik: fix IRQ assignment for SMC ethernet Message-ID: <1368917259-7883-1-git-send-email-linus.walleij@linaro.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org The assignment of IRQ for the SMC91x ethernet adapter had two problems making it non-working: - It was not put into the ethernet device node. Let's do this by using the board-specific overlay, so we can make other overlays on other Nomadik boards. - The IRQ number was actually completely wrong, this was the number for NHK8815, not S8815. After this ethernet starts working on the USB S8815. Signed-off-by: Linus Walleij --- ARM SoC folks: I would appreciate if you apply this patch directly for v3.10 fixes. --- arch/arm/boot/dts/ste-nomadik-s8815.dts | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) diff --git a/arch/arm/boot/dts/ste-nomadik-s8815.dts b/arch/arm/boot/dts/ste-nomadik-s8815.dts index b28fbf3..6f82d93 100644 --- a/arch/arm/boot/dts/ste-nomadik-s8815.dts +++ b/arch/arm/boot/dts/ste-nomadik-s8815.dts @@ -14,13 +14,19 @@ bootargs = "root=/dev/ram0 console=ttyAMA1,115200n8 earlyprintk"; }; + /* This is where the interrupt is routed on the S8815 board */ + external-bus at 34000000 { + ethernet at 300 { + interrupt-parent = <&gpio3>; + interrupts = <8 0x1>; + }; + }; + /* Custom board node with GPIO pins to active etc */ usb-s8815 { /* The S8815 is using this very GPIO pin for the SMSC91x IRQs */ ethernet-gpio { - gpios = <&gpio3 19 0x1>; - interrupts = <19 0x1>; - interrupt-parent = <&gpio3>; + gpios = <&gpio3 8 0x1>; }; /* This will bias the MMC/SD card detect line */ mmcsd-gpio { -- 1.8.1.4