From mboxrd@z Thu Jan 1 00:00:00 1970 From: Valentin Longchamp Date: Fri, 13 Nov 2015 15:59:26 +0100 Subject: [U-Boot] [PATCH 15/17] km8309: change the default QE_FW address In-Reply-To: <1447426768-23226-1-git-send-email-valentin.longchamp@keymile.com> References: <1447426768-23226-1-git-send-email-valentin.longchamp@keymile.com> Message-ID: <1447426768-23226-16-git-send-email-valentin.longchamp@keymile.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de It should be after the u-boot reserved sectors and before the env sectors, since the solution used for kmvect1 (tell the linker to put the firmware into the u-boot produced binary, at the end of the area) should be the exception. The #define is only "conditional" so that we can still support kmvect1. Signed-off-by: Valentin Longchamp --- include/configs/km/km8309-common.h | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/include/configs/km/km8309-common.h b/include/configs/km/km8309-common.h index d7f6cb1..a69fdf1 100644 --- a/include/configs/km/km8309-common.h +++ b/include/configs/km/km8309-common.h @@ -29,8 +29,10 @@ /* QE microcode/firmware address */ #define CONFIG_SYS_QE_FMAN_FW_IN_NOR -/* at end of uboot partition, before env */ -#define CONFIG_SYS_QE_FW_ADDR 0xF00B0000 +/* between the u-boot partition and env */ +#ifndef CONFIG_SYS_QE_FW_ADDR +#define CONFIG_SYS_QE_FW_ADDR 0xF00C0000 +#endif /* * System IO Config -- 1.8.3.1