All of lore.kernel.org
 help / color / mirror / Atom feed
From: Taniya Das <tdas@codeaurora.org>
To: Stephen Boyd <sboyd@codeaurora.org>,
	Michael Turquette <mturquette@baylibre.com>
Cc: Andy Gross <andy.gross@linaro.org>,
	David Brown <david.brown@linaro.org>,
	Rajendra Nayak <rnayak@codeaurora.org>,
	Odelu Kukatla <okukatla@codeaurora.org>,
	Amit Nischal <anischal@codeaurora.org>,
	linux-arm-msm@vger.kernel.org, linux-soc@vger.kernel.org,
	linux-clk@vger.kernel.org, linux-kernel@vger.kernel.org,
	Taniya Das <tdas@codeaurora.org>
Subject: [PATCH v1] clk: qcom: gdsc: Add support to poll CFG register to check GDSC state
Date: Tue,  1 May 2018 10:33:33 +0530	[thread overview]
Message-ID: <1525151013-28291-1-git-send-email-tdas@codeaurora.org> (raw)

From: Amit Nischal <anischal@codeaurora.org>

The default behavior of the GDSC enable/disable sequence is to
poll the status bits of either the actual GDSCR or the
corresponding HW_CTRL registers.

On targets which have support for a CFG_GDSCR register, the
status bits might not show the correct state of the GDSC,
especially in the disable sequence, where the status bit
will be cleared even before the core is completely power
collapsed. On targets with this issue, poll the power on/off
bits in the CFG_GDSCR register instead to correctly determine
the GDSC state.

Signed-off-by: Amit Nischal <anischal@codeaurora.org>
Signed-off-by: Taniya Das <tdas@codeaurora.org>
---
 drivers/clk/qcom/gdsc.c | 42 ++++++++++++++++++++++++++----------------
 drivers/clk/qcom/gdsc.h |  1 +
 2 files changed, 27 insertions(+), 16 deletions(-)

diff --git a/drivers/clk/qcom/gdsc.c b/drivers/clk/qcom/gdsc.c
index cb61c15..2a6b0ff 100644
--- a/drivers/clk/qcom/gdsc.c
+++ b/drivers/clk/qcom/gdsc.c
@@ -33,6 +33,11 @@
 #define GMEM_CLAMP_IO_MASK	BIT(0)
 #define GMEM_RESET_MASK		BIT(4)

+/* CFG_GDSCR */
+#define GDSC_POWER_UP_COMPLETE		BIT(16)
+#define GDSC_POWER_DOWN_COMPLETE	BIT(15)
+#define CFG_GDSCR_OFFSET		0x4
+
 /* Wait 2^n CXO cycles between all states. Here, n=2 (4 cycles). */
 #define EN_REST_WAIT_VAL	(0x2 << 20)
 #define EN_FEW_WAIT_VAL		(0x8 << 16)
@@ -45,15 +50,28 @@

 #define domain_to_gdsc(domain) container_of(domain, struct gdsc, pd)

-static int gdsc_is_enabled(struct gdsc *sc, unsigned int reg)
+static int gdsc_is_enabled(struct gdsc *sc, bool en)
 {
+	unsigned int reg;
 	u32 val;
 	int ret;

+	if (sc->flags & POLL_CFG_GDSCR)
+		reg = sc->gdscr + CFG_GDSCR_OFFSET;
+	else
+		reg = sc->gds_hw_ctrl ? sc->gds_hw_ctrl : sc->gdscr;
+
 	ret = regmap_read(sc->regmap, reg, &val);
 	if (ret)
 		return ret;

+	if (sc->flags & POLL_CFG_GDSCR) {
+		if (en)
+			return !!(val & GDSC_POWER_UP_COMPLETE);
+		else
+			return !(val & GDSC_POWER_DOWN_COMPLETE);
+	}
+
 	return !!(val & PWR_ON_MASK);
 }

@@ -64,17 +82,17 @@ static int gdsc_hwctrl(struct gdsc *sc, bool en)
 	return regmap_update_bits(sc->regmap, sc->gdscr, HW_CONTROL_MASK, val);
 }

-static int gdsc_poll_status(struct gdsc *sc, unsigned int reg, bool en)
+static int gdsc_poll_status(struct gdsc *sc, bool en)
 {
 	ktime_t start;

 	start = ktime_get();
 	do {
-		if (gdsc_is_enabled(sc, reg) == en)
+		if (gdsc_is_enabled(sc, en) == en)
 			return 0;
 	} while (ktime_us_delta(ktime_get(), start) < TIMEOUT_US);

-	if (gdsc_is_enabled(sc, reg) == en)
+	if (gdsc_is_enabled(sc, en) == en)
 		return 0;

 	return -ETIMEDOUT;
@@ -84,7 +102,6 @@ static int gdsc_toggle_logic(struct gdsc *sc, bool en)
 {
 	int ret;
 	u32 val = en ? 0 : SW_COLLAPSE_MASK;
-	unsigned int status_reg = sc->gdscr;

 	ret = regmap_update_bits(sc->regmap, sc->gdscr, SW_COLLAPSE_MASK, val);
 	if (ret)
@@ -101,8 +118,7 @@ static int gdsc_toggle_logic(struct gdsc *sc, bool en)
 		return 0;
 	}

-	if (sc->gds_hw_ctrl) {
-		status_reg = sc->gds_hw_ctrl;
+	if (sc->gds_hw_ctrl)
 		/*
 		 * The gds hw controller asserts/de-asserts the status bit soon
 		 * after it receives a power on/off request from a master.
@@ -114,9 +130,8 @@ static int gdsc_toggle_logic(struct gdsc *sc, bool en)
 		 * and polling the status bit.
 		 */
 		udelay(1);
-	}

-	return gdsc_poll_status(sc, status_reg, en);
+	return gdsc_poll_status(sc, en);
 }

 static inline int gdsc_deassert_reset(struct gdsc *sc)
@@ -240,8 +255,6 @@ static int gdsc_disable(struct generic_pm_domain *domain)

 	/* Turn off HW trigger mode if supported */
 	if (sc->flags & HW_CTRL) {
-		unsigned int reg;
-
 		ret = gdsc_hwctrl(sc, false);
 		if (ret < 0)
 			return ret;
@@ -253,8 +266,7 @@ static int gdsc_disable(struct generic_pm_domain *domain)
 		 */
 		udelay(1);

-		reg = sc->gds_hw_ctrl ? sc->gds_hw_ctrl : sc->gdscr;
-		ret = gdsc_poll_status(sc, reg, true);
+		ret = gdsc_poll_status(sc, true);
 		if (ret)
 			return ret;
 	}
@@ -276,7 +288,6 @@ static int gdsc_init(struct gdsc *sc)
 {
 	u32 mask, val;
 	int on, ret;
-	unsigned int reg;

 	/*
 	 * Disable HW trigger: collapse/restore occur based on registers writes.
@@ -297,8 +308,7 @@ static int gdsc_init(struct gdsc *sc)
 			return ret;
 	}

-	reg = sc->gds_hw_ctrl ? sc->gds_hw_ctrl : sc->gdscr;
-	on = gdsc_is_enabled(sc, reg);
+	on = gdsc_is_enabled(sc, true);
 	if (on < 0)
 		return on;

diff --git a/drivers/clk/qcom/gdsc.h b/drivers/clk/qcom/gdsc.h
index 9279278..b0cbb87 100644
--- a/drivers/clk/qcom/gdsc.h
+++ b/drivers/clk/qcom/gdsc.h
@@ -55,6 +55,7 @@ struct gdsc {
 #define HW_CTRL		BIT(2)
 #define SW_RESET	BIT(3)
 #define AON_RESET	BIT(4)
+#define POLL_CFG_GDSCR	BIT(5)
 	struct reset_controller_dev	*rcdev;
 	unsigned int			*resets;
 	unsigned int			reset_count;
--
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc.is a member
of the Code Aurora Forum, hosted by the  Linux Foundation.

             reply	other threads:[~2018-05-01  5:03 UTC|newest]

Thread overview: 8+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-05-01  5:03 Taniya Das [this message]
2018-05-02  6:57 ` [PATCH v1] clk: qcom: gdsc: Add support to poll CFG register to check GDSC state Stephen Boyd
2018-05-02  6:57   ` Stephen Boyd
2018-05-02  6:57   ` Stephen Boyd
2018-05-03  9:09   ` Taniya Das
2018-05-05  2:51     ` Stephen Boyd
2018-05-05  2:51       ` Stephen Boyd
2018-05-05  3:48       ` Taniya Das

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1525151013-28291-1-git-send-email-tdas@codeaurora.org \
    --to=tdas@codeaurora.org \
    --cc=andy.gross@linaro.org \
    --cc=anischal@codeaurora.org \
    --cc=david.brown@linaro.org \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-clk@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-soc@vger.kernel.org \
    --cc=mturquette@baylibre.com \
    --cc=okukatla@codeaurora.org \
    --cc=rnayak@codeaurora.org \
    --cc=sboyd@codeaurora.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.