From mboxrd@z Thu Jan 1 00:00:00 1970 From: Aleksandr Aleksandrov Date: Fri, 5 Oct 2018 15:55:59 +0300 Subject: [U-Boot] [PATCH v3 1/2] arm: new board - Emlid Neutis N5 support In-Reply-To: <1538744160-12064-1-git-send-email-aleksandr.aleksandrov@emlid.com> References: <1538744160-12064-1-git-send-email-aleksandr.aleksandrov@emlid.com> Message-ID: <1538744160-12064-2-git-send-email-aleksandr.aleksandrov@emlid.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de Emlid Neutis N5 is a SoM based on Allwinner H5, has a WiFi & BT module, DDR3 RAM and eMMC. - add neutis-devboard target to dtb makefile - add dtsi file for Neutis N5 needs - add config file for Neutis N5 Dev board Signed-off-by: Aleksandr Aleksandrov Cc: Jagan Teki Cc: Maxime Ripard --- arch/arm/dts/Makefile | 1 + .../arm/dts/sun50i-h5-emlid-neutis-n5-devboard.dts | 184 +++++++++++++++++++++ arch/arm/dts/sun50i-h5-emlid-neutis-n5.dtsi | 96 +++++++++++ configs/emlid_neutis_n5_devboard_defconfig | 13 ++ 4 files changed, 294 insertions(+) create mode 100644 arch/arm/dts/sun50i-h5-emlid-neutis-n5-devboard.dts create mode 100644 arch/arm/dts/sun50i-h5-emlid-neutis-n5.dtsi create mode 100644 configs/emlid_neutis_n5_devboard_defconfig diff --git a/arch/arm/dts/Makefile b/arch/arm/dts/Makefile index 44ebc50..0a5e93e 100644 --- a/arch/arm/dts/Makefile +++ b/arch/arm/dts/Makefile @@ -385,6 +385,7 @@ dtb-$(CONFIG_MACH_SUN8I_R40) += \ dtb-$(CONFIG_MACH_SUN8I_V3S) += \ sun8i-v3s-licheepi-zero.dtb dtb-$(CONFIG_MACH_SUN50I_H5) += \ + sun50i-h5-emlid-neutis-n5-devboard.dtb \ sun50i-h5-libretech-all-h3-cc.dtb \ sun50i-h5-nanopi-neo2.dtb \ sun50i-h5-nanopi-neo-plus2.dtb \ diff --git a/arch/arm/dts/sun50i-h5-emlid-neutis-n5-devboard.dts b/arch/arm/dts/sun50i-h5-emlid-neutis-n5-devboard.dts new file mode 100644 index 0000000..493947c --- /dev/null +++ b/arch/arm/dts/sun50i-h5-emlid-neutis-n5-devboard.dts @@ -0,0 +1,184 @@ +/* + * Copyright (C) 2018 Aleksandr Aleksandrov + * + * This file is dual-licensed: you can use it either under the terms + * of the GPL or the X11 license, at your option. Note that this dual + * licensing only applies to this file, and not this project as a + * whole. + * + * a) This library is free software; you can redistribute it and/or + * modify it under the terms of the GNU General Public License as + * published by the Free Software Foundation; either version 2 of the + * License, or (at your option) any later version. + * + * This library is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * Or, alternatively, + * + * b) Permission is hereby granted, free of charge, to any person + * obtaining a copy of this software and associated documentation + * files (the "Software"), to deal in the Software without + * restriction, including without limitation the rights to use, + * copy, modify, merge, publish, distribute, sublicense, and/or + * sell copies of the Software, and to permit persons to whom the + * Software is furnished to do so, subject to the following + * conditions: + * + * The above copyright notice and this permission notice shall be + * included in all copies or substantial portions of the Software. + * + * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, + * EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES + * OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND + * NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT + * HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, + * WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING + * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR + * OTHER DEALINGS IN THE SOFTWARE. + */ + +/dts-v1/; + +#include "sun50i-h5-emlid-neutis-n5.dtsi" + +/ { + model = "Emlid Neutis N5 Developer board"; + compatible = "emlid,emlid-neutis-n5-devboard", + "emlid,emlid-neutis-n5", + "allwinner,sun50i-h5"; + + aliases { + serial0 = &uart0; + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; + + connector { + compatible = "hdmi-connector"; + type = "a"; + + port { + hdmi_con_in: endpoint { + remote-endpoint = <&hdmi_out_con>; + }; + }; + }; + + reg_usb0_vbus: usb0-vbus { + compatible = "regulator-fixed"; + regulator-name = "usb0-vbus"; + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + enable-active-high; + gpio = <&r_pio 0 9 GPIO_ACTIVE_HIGH>; /* PL9 */ + status = "okay"; + }; + + vdd_cpux: gpio-regulator { + compatible = "regulator-gpio"; + pinctrl-names = "default"; + regulator-name = "vdd-cpux"; + regulator-type = "voltage"; + regulator-boot-on; + regulator-always-on; + regulator-min-microvolt = <1100000>; + regulator-max-microvolt = <1300000>; + regulator-ramp-delay = <50>; /* 4ms */ + gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */ + gpios-states = <0x1>; + states = <1100000 0x0 + 1300000 0x1>; + }; +}; + +&codec { + allwinner,audio-routing = + "Line Out", "LINEOUT", + "LINEIN", "Line In", + "MIC1", "Mic", + "MIC2", "Mic", + "Mic", "MBIAS"; + status = "okay"; +}; + +&de { + status = "okay"; +}; + +&ehci0 { + status = "okay"; +}; + +&ehci1 { + status = "okay"; +}; + +&ehci2 { + status = "okay"; +}; + +&ehci3 { + status = "okay"; +}; + +&ohci0 { + status = "okay"; +}; + +&ohci1 { + status = "okay"; +}; + +&ohci2 { + status = "okay"; +}; + +&ohci3 { + status = "okay"; +}; + +&emac { + phy-handle = <&int_mii_phy>; + phy-mode = "mii"; + allwinner,leds-active-low; + status = "okay"; +}; + +&hdmi { + status = "okay"; +}; + +&hdmi_out { + hdmi_out_con: endpoint { + remote-endpoint = <&hdmi_con_in>; + }; +}; + +&mmc0 { + vmmc-supply = <®_vcc3v3>; + bus-width = <4>; + cd-gpios = <&pio 5 6 GPIO_ACTIVE_LOW>; /* PF6 */ + status = "okay"; +}; + +&uart0 { + pinctrl-names = "default"; + pinctrl-0 = <&uart0_pins_a>; + status = "okay"; +}; + +&usb_otg { + dr_mode = "otg"; + status = "okay"; +}; + +&usbphy { + usb0_id_det-gpios = <&r_pio 0 8 GPIO_ACTIVE_HIGH>; /* PL8 */ + usb0_vbus-supply = <®_usb0_vbus>; + status = "okay"; +}; diff --git a/arch/arm/dts/sun50i-h5-emlid-neutis-n5.dtsi b/arch/arm/dts/sun50i-h5-emlid-neutis-n5.dtsi new file mode 100644 index 0000000..8e1e37d --- /dev/null +++ b/arch/arm/dts/sun50i-h5-emlid-neutis-n5.dtsi @@ -0,0 +1,96 @@ +/* + * Copyright (C) 2018 Aleksandr Aleksandrov + * + * This file is dual-licensed: you can use it either under the terms + * of the GPL or the X11 license, at your option. Note that this dual + * licensing only applies to this file, and not this project as a + * whole. + * + * a) This library is free software; you can redistribute it and/or + * modify it under the terms of the GNU General Public License as + * published by the Free Software Foundation; either version 2 of the + * License, or (at your option) any later version. + * + * This library is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + * GNU General Public License for more details. + * + * Or, alternatively, + * + * b) Permission is hereby granted, free of charge, to any person + * obtaining a copy of this software and associated documentation + * files (the "Software"), to deal in the Software without + * restriction, including without limitation the rights to use, + * copy, modify, merge, publish, distribute, sublicense, and/or + * sell copies of the Software, and to permit persons to whom the + * Software is furnished to do so, subject to the following + * conditions: + * + * The above copyright notice and this permission notice shall be + * included in all copies or substantial portions of the Software. + * + * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, + * EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES + * OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND + * NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT + * HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, + * WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING + * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR + * OTHER DEALINGS IN THE SOFTWARE. + */ + +/dts-v1/; + +#include "sun50i-h5.dtsi" + +#include + +/ { + reg_vcc3v3: vcc3v3 { + compatible = "regulator-fixed"; + regulator-name = "vcc3v3"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + }; + + wifi_pwrseq: wifi_pwrseq { + compatible = "mmc-pwrseq-simple"; + pinctrl-names = "default"; + reset-gpios = <&pio 2 7 GPIO_ACTIVE_LOW>; /* PC7 */ + post-power-on-delay-ms = <200>; + }; +}; + +&mmc1 { + vmmc-supply = <®_vcc3v3>; + vqmmc-supply = <®_vcc3v3>; + mmc-pwrseq = <&wifi_pwrseq>; + bus-width = <4>; + non-removable; + status = "okay"; + + brcmf: wifi at 1 { + reg = <1>; + compatible = "brcm,bcm4329-fmac"; + interrupt-parent = <&r_pio>; + interrupts = <0 5 IRQ_TYPE_LEVEL_LOW>; /* PL5 */ + interrupt-names = "host-wake"; + }; +}; + +&mmc2 { + pinctrl-names = "default"; + pinctrl-0 = <&mmc2_8bit_pins>; + vmmc-supply = <®_vcc3v3>; + bus-width = <8>; + non-removable; + cap-mmc-hw-reset; + status = "okay"; +}; + +&uart1 { + pinctrl-names = "default"; + pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>; + status = "okay"; +}; diff --git a/configs/emlid_neutis_n5_devboard_defconfig b/configs/emlid_neutis_n5_devboard_defconfig new file mode 100644 index 0000000..3df0ca1 --- /dev/null +++ b/configs/emlid_neutis_n5_devboard_defconfig @@ -0,0 +1,13 @@ +CONFIG_ARM=y +CONFIG_ARCH_SUNXI=y +CONFIG_SPL=y +CONFIG_MACH_SUN50I_H5=y +CONFIG_DRAM_CLK=408 +CONFIG_DRAM_ZQ=3881977 +CONFIG_MMC_SUNXI_SLOT_EXTRA=2 +CONFIG_NR_DRAM_BANKS=1 +# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set +# CONFIG_CMD_FLASH is not set +# CONFIG_SPL_DOS_PARTITION is not set +# CONFIG_SPL_EFI_PARTITION is not set +CONFIG_DEFAULT_DEVICE_TREE="sun50i-h5-emlid-neutis-n5-devboard" -- 2.7.4