[PATCH v2 09/17] thermal: qoriq: enable+check sensor after its setup is finished

From: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
To: Zhang Rui <rui.zhang@intel.com>, Eduardo Valentin <edubezval@gmail.com>
Cc: Amit kucheria <amit.kucheria@linaro.org>,
	Eric Anholt <eric@anholt.net>,
	Stefan Wahren <stefan.wahren@i2se.com>,
	Markus Mayer <mmayer@broadcom.com>,
	bcm-kernel-feedback-list@broadcom.com,
	Heiko Stuebner <heiko@sntech.de>,
	Thierry Reding <thierry.reding@gmail.com>,
	Jonathan Hunter <jonathanh@nvidia.com>,
	Keerthy <j-keerthy@ti.com>,
	Masahiro Yamada <yamada.masahiro@socionext.com>,
	Jun Nie <jun.nie@linaro.org>, Baoyou Xie <baoyou.xie@linaro.org>,
	Shawn Guo <shawnguo@kernel.org>,
	linux-pm@vger.kernel.org, linux-kernel@vger.kernel.org,
	b.zolnierkie@samsung.com
Subject: [PATCH v2 09/17] thermal: qoriq: enable+check sensor after its setup is finished
Date: Wed, 17 Oct 2018 17:52:35 +0200	[thread overview]
Message-ID: <1539791563-5959-10-git-send-email-b.zolnierkie@samsung.com> (raw)
In-Reply-To: <1539791563-5959-1-git-send-email-b.zolnierkie@samsung.com>

Enable+check sensor after enabling monitoring.

Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnierkie@samsung.com>
---
 drivers/thermal/qoriq_thermal.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/qoriq_thermal.c b/drivers/thermal/qoriq_thermal.c
index d8a80448..fb1750f 100644
--- a/drivers/thermal/qoriq_thermal.c
+++ b/drivers/thermal/qoriq_thermal.c
@@ -233,13 +233,13 @@ static int qoriq_tmu_probe(struct platform_device *pdev)
 		goto err_tmu;
 	}
 
-	thermal_zone_set_mode(data->tz, THERMAL_DEVICE_ENABLED);
-	thermal_zone_device_check(data->tz);
-
 	/* Enable monitoring */
 	site = 0x1 << (15 - data->sensor_id);
 	tmu_write(data, site | TMR_ME | TMR_ALPF, &data->regs->tmr);
 
+	thermal_zone_set_mode(data->tz, THERMAL_DEVICE_ENABLED);
+	thermal_zone_device_check(data->tz);
+
 	return 0;
 
 err_tmu:
-- 
1.9.1

