All of lore.kernel.org
 help / color / mirror / Atom feed
From: Kurt Miller <kurt@intricatesoftware.com>
To: u-boot@lists.denx.de
Subject: [PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board
Date: Fri, 27 Mar 2020 11:07:35 -0400	[thread overview]
Message-ID: <1585321655.5148.23.camel@intricatesoftware.com> (raw)
In-Reply-To: <20200327044130.8763-1-wens@kernel.org>

On Fri, 2020-03-27 at 12:41 +0800, Chen-Yu Tsai wrote:
> From: Chen-Yu Tsai <wens@csie.org>
> 
> Hi everyone,
> 
> This series adds proper support for Firefly / Libre Computer ROC-RK3328-CC
> single board computer.
> 
> The ROC-RK3328-CC from Firefly and Libre Computer Project is a credit
> card size development board based on the Rockchip RK3328 SoC, with:
> 
> ? - 1/2/4 GB DDR4 DRAM
> ? - eMMC connector for optional module
> ? - micro SD card slot
> ? - 1 x USB 3.0 host port
> ? - 2 x USB 2.0 host port
> ? - 1 x USB 2.0 OTG port
> ? - HDMI video output
> ? - TRRS connector with audio and composite video output
> ? - gigabit Ethernet
> ? - consumer IR receiver
> ? - debug UART pins
> 
> Originally I started with Loic's patches, and syncing the device tree
> files from Linux. That didn't get very far, with SPL failing to detect
> the SD card. Examining the schematics and internal state of GRF and
> GPIOs, I realized that the logic for the SD card power enable switch
> is opposite that of what the SD card controller's SDMMC0_PWREN pin
> would use. Instead, directly using the GPIO is required.
> 
> Thus this series creates a special target for this board to handle
> muxing this specific pin to GPIO state. The GPIO is left in input mode,
> letting the external pull-down work its magic.
> 
> Along the way, there are some clean-ups of existing dts files, moving
> U-boot only features to -u-boot.dtsi files, and then a wholesale sync
> from Linux. Only boards already existing in U-boot are synced. DT
> binding header files are synced separately as there is already one
> patch floating around. The DT sync also includes clean-up changes only
> recently posted, and likely won't make it in for at least a few weeks.
> 
> Please have a look, and test if possible. I cc-ed a couple people that
> showed interest in this board on mailing lists recently.
> 

Thank you for updating the dts for rk3328. I have Rock64 v2 and v3
boards and have tested your patchset with OpenBSD-current. The v2 board
is working and I have not noticed any regressions. The v3 board prior
to your patchset was not booting and continues to not boot.

U-Boot TPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24)
LPDDR3, 800MHz
BW=32 Col=11 Bk=8 CS0 Row=15 CS1 Row=15 CS=2 Die BW=16 Size=4096MB
Trying to boot from BOOTROM
Returning to boot ROM...

U-Boot SPL 2020.04-rc3-00172-gaf827140e5-dirty (Mar 27 2020 - 09:44:24 -0400)
Trying to boot from MMC1
Card did not respond to voltage select!
spl: mmc init failed with error: -95
Trying to boot from MMC2
Card did not respond to voltage select!
spl: mmc init failed with error: -95
SPL: failed to boot from all boot devices
### ERROR ### Please RESET the board ###

The Rock64 v3 board issues are unrelated to your patch set, but I
believe it needs a similar approach as?ROC-RK3328-CC. Here is some
info previously posted regarding this:

https://marc.info/?t=155751506500001&r=1&w=2

Regards,
-Kurt


> Regards
> ChenYu
> 
> 
> Chen-Yu Tsai (6):
> ? rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi
> ? rockchip: dts: rk3328-evb: Move gmac2io related nodes to -u-boot.dtsi
> ? dt-bindings: clock: rk3328: sync from upstream Linux kernel
> ? dt-bindings: power: rk3328-power: sync from upstream Linux kernel
> ? rockchip: dts: rk3328: Sync device tree files from Linux
> ? rockchip: rk3328: Add support for ROC-RK3328-CC board
> 
> ?arch/arm/dts/Makefile?????????????????????????|????1 +
> ?arch/arm/dts/rk3328-evb-u-boot.dtsi???????????|???39 +
> ?arch/arm/dts/rk3328-evb.dts???????????????????|??220 +--
> ?arch/arm/dts/rk3328-roc-cc-u-boot.dtsi????????|???17 +
> ?.../{rk3328-rock64.dts => rk3328-roc-cc.dts}??|??135 +-
> ?arch/arm/dts/rk3328-rock64.dts????????????????|??132 +-
> ?arch/arm/dts/rk3328.dtsi??????????????????????| 1420 +++++++++++------
> ?arch/arm/mach-rockchip/rk3328/Kconfig?????????|????8 +
> ?board/firefly/roc-cc-rk3328/Kconfig???????????|???24 +
> ?board/firefly/roc-cc-rk3328/MAINTAINERS???????|????7 +
> ?board/firefly/roc-cc-rk3328/Makefile??????????|????1 +
> ?board/firefly/roc-cc-rk3328/board.c???????????|???38 +
> ?configs/roc-cc-rk3328_defconfig???????????????|???97 ++
> ?doc/README.rockchip???????????????????????????|????4 +-
> ?include/dt-bindings/clock/rk3328-cru.h????????|??212 +--
> ?include/dt-bindings/power/rk3328-power.h??????|???19 +
> ?16 files changed, 1622 insertions(+), 752 deletions(-)
> ?create mode 100644 arch/arm/dts/rk3328-roc-cc-u-boot.dtsi
> ?copy arch/arm/dts/{rk3328-rock64.dts => rk3328-roc-cc.dts} (68%)
> ?create mode 100644 board/firefly/roc-cc-rk3328/Kconfig
> ?create mode 100644 board/firefly/roc-cc-rk3328/MAINTAINERS
> ?create mode 100644 board/firefly/roc-cc-rk3328/Makefile
> ?create mode 100644 board/firefly/roc-cc-rk3328/board.c
> ?create mode 100644 configs/roc-cc-rk3328_defconfig
> ?create mode 100644 include/dt-bindings/power/rk3328-power.h
> 

  parent reply	other threads:[~2020-03-27 15:07 UTC|newest]

Thread overview: 24+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-03-27  4:41 [PATCH 0/6] rockchip: rk3328: sync dts and add ROC-RK3328-CC board Chen-Yu Tsai
2020-03-27  4:41 ` [PATCH 1/6] rockchip: dts: rk3328-evb: Move vcc5v0-host-xhci-drv to -u-boot.dtsi Chen-Yu Tsai
2020-03-27  6:38   ` Kever Yang
2020-03-27  4:41 ` [PATCH 2/6] rockchip: dts: rk3328-evb: Move gmac2io related nodes " Chen-Yu Tsai
2020-03-27  6:38   ` Kever Yang
2020-03-27  4:41 ` [PATCH 3/6] dt-bindings: clock: rk3328: sync from upstream Linux kernel Chen-Yu Tsai
2020-03-27  6:39   ` Kever Yang
2020-03-27  4:41 ` [PATCH 4/6] dt-bindings: power: rk3328-power: " Chen-Yu Tsai
2020-03-27  6:39   ` Kever Yang
2020-03-27  4:41 ` [PATCH 5/6] rockchip: dts: rk3328: Sync device tree files from Linux Chen-Yu Tsai
2020-03-27  6:39   ` Kever Yang
2020-03-27  4:41 ` [PATCH 6/6] rockchip: rk3328: Add support for ROC-RK3328-CC board Chen-Yu Tsai
2020-03-27  6:41   ` Kever Yang
2020-03-30 17:44   ` Jagan Teki
2020-03-30 18:24     ` Chen-Yu Tsai
2020-03-31 10:57       ` Jagan Teki
2020-03-31 11:46         ` Chen-Yu Tsai
2020-03-31 12:37           ` Jagan Teki
2020-04-01 10:09             ` Chen-Yu Tsai
2020-04-01 19:15               ` Kurt Miller
2020-03-27 15:07 ` Kurt Miller [this message]
2020-03-27 17:44   ` [PATCH 0/6] rockchip: rk3328: sync dts and add " Chen-Yu Tsai
2020-03-27 22:03     ` Kurt Miller
2020-03-30  4:45       ` Chen-Yu Tsai

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=1585321655.5148.23.camel@intricatesoftware.com \
    --to=kurt@intricatesoftware.com \
    --cc=u-boot@lists.denx.de \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.