[PATCH 2/2] PCI: rockchip: Add 100ms delay before enabling training

[Shawn Lin <shawn.lin@rock-chips.com>]

According to PCI Express Card Electromechanical Specification
Revision 3.0, Table 2-4, power stable and reference clk stable
before PERST# inactive should be at least 100ms and 100us
respectively. Otherwise we do see some failures for link training.

Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
---

 drivers/pci/controller/pcie-rockchip-host.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/pci/controller/pcie-rockchip-host.c b/drivers/pci/controller/pcie-rockchip-host.c
index 94af6f5..2f4d909 100644
--- a/drivers/pci/controller/pcie-rockchip-host.c
+++ b/drivers/pci/controller/pcie-rockchip-host.c
@@ -331,6 +331,14 @@ static int rockchip_pcie_host_init_port(struct rockchip_pcie *rockchip)
 	rockchip_pcie_write(rockchip, PCIE_CLIENT_LINK_TRAIN_ENABLE,
 			    PCIE_CLIENT_CONFIG);
 
+	/*
+	 * According to PCI Express Card Electromechanical Specification
+	 * Revision 3.0, Table 2-4, power stable and reference clk stable
+	 * before PERST# inactive should be at least 100ms and 100us
+	 * respectively. Otherwise we do see some failures for link training.
+	 */
+	msleep(100);
+
 	gpiod_set_value_cansleep(rockchip->ep_gpio, 1);
 
 	/* 500ms timeout value should be enough for Gen1/2 training */
-- 
2.7.4