On Wed, 2020-10-14 at 14:44 +0200, Ard Biesheuvel wrote: > On Tue, 13 Oct 2020 at 16:42, Nicolas Saenz Julienne > wrote: > > On Mon, 2020-10-12 at 17:59 +0100, Catalin Marinas wrote: > > > On Mon, Oct 12, 2020 at 06:35:37PM +0200, Ard Biesheuvel wrote: > > > > On Mon, 12 Oct 2020 at 18:22, Catalin Marinas wrote: > > > > > On Mon, Oct 12, 2020 at 05:55:45PM +0200, Ard Biesheuvel wrote: > > > > > > On Mon, 12 Oct 2020 at 17:50, Catalin Marinas wrote: > > > > > > > > > On Mon, Oct 12, 2020 at 12:43:05PM +0200, Ard Biesheuvel wrote: > > > > > > > > > > Also, could someone give an executive summary of why it matters where > > > > > > > > > > the crashkernel is loaded? As far as I can tell, reserve_crashkernel() > > > > > > > > > > only allocates memory for the kernel's executable image itself, which > > > > > > > > > > can usually be loaded anywhere in memory. I could see how a > > > > > > > > > > crashkernel might need some DMA'able memory if it needs to use the > > > > > > > > > > hardware, but I don't think that is what is going on here. > > > > > [...] > > > > > > > However, the crashkernel=... range is meant for sufficiently large > > > > > > > reservation to be able to run the kdump kernel, not just load the image. > > > > > > > > > > > > Sure. But I was referring to the requirement that it is loaded low in > > > > > > memory. Unless I am misunderstanding something, all we need for the > > > > > > crashkernel to be able to operate is some ZONE_DMA memory in case it > > > > > > is needed by the hardware, and beyond that, it could happily live > > > > > > anywhere in memory. > > > > > > > > > > Yes, the crash kernel doesn't need to be loaded in the low memory. But > > > > > some low memory needs to end up in its perceived System RAM. That's what > > > > > Chen is trying to do with this series: > > > > > > > > > > https://lore.kernel.org/linux-arm-kernel/20200907134745.25732-1-chenzhou10@huawei.com/ > > > > > > > > > > It reserves the normal crashkernel memory at some high address range > > > > > with a small block (currently proposed as 256MB similar to x86) in the > > > > > "low" range. > > > > > > > > > > This "low" range for arm64 currently means below 1GB but it's only RPi4 > > > > > that needs it this low, all other platforms are fine with the full low > > > > > 32-bit range. > > > > > > > > > > If it's not doable in a nice way, we'll just leave with this permanent > > > > > 1GB ZONE_DMA and hope we won't get platforms requiring an even smaller > > > > > one. There's also the option of ignoring kdump on RPi4, make ZONE_DMA > > > > > depend on !CRASH_DUMP and the "low" reservations can use the full 32-bit > > > > > range since the kdump kernel won't need <30-bit addresses. > > > > > > > > Are you aware of any reason why we cannot defer the call to > > > > reserve_crashkernel() to the start of bootmem_init()? That way, we > > > > have access to the unflattened DT as well as the IORT, and so we can > > > > tweak the zone limits based on the h/w description, but before > > > > allocating the crashkernel. > > > > > > Not really, as long as memblock_reserve/alloc() still works. > > > > I had a look at this myself, and IIUC we're free to call reserve_crashkernel() > > anytime as long as it's before memblock_free_all(). > > > > So, should I add a patch in my series taking care of that? or you'd rather take > > care of it yourselves? > > > > Would you mind adopting this patch, and insert it into your series > where appropriate? (after dropping the Documentation/ change, and > moving the prototype declaration into linux/acpi_iort.h?) Then, you > can also include moving the reserve_crashkernel() into bootmem_init(). Yes, I'll take care of it.