From: David Miller <davem@davemloft.net>
To: bhutchings@solarflare.com
Cc: netdev@vger.kernel.org, linux-net-drivers@solarflare.com
Subject: Re: [PATCH 22/33] sfc: Add support for Solarflare 10Xpress SFT9001
Date: Fri, 12 Dec 2008 22:00:25 -0800 (PST) [thread overview]
Message-ID: <20081212.220025.80883644.davem@davemloft.net> (raw)
In-Reply-To: <20081212125605.GV10372@solarflare.com>
From: Ben Hutchings <bhutchings@solarflare.com>
Date: Fri, 12 Dec 2008 12:56:06 +0000
> Add type codes for the new PHY and rename the SFX7101 type code.
>
> Add definition of clause 22 extension MMD.
>
> Adapt the 10Xpress SFX7101 code to support the SFT9001 as well.
> Clean up register definitions.
>
> Signed-off-by: Ben Hutchings <bhutchings@solarflare.com>
Applied.
next prev parent reply other threads:[~2008-12-13 6:00 UTC|newest]
Thread overview: 74+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <cover.1229085672.git.bhutchings@solarflare.com>
2008-12-12 12:46 ` [PATCH 00/33] sfc version 2.3 Ben Hutchings
2008-12-12 12:48 ` [PATCH 01/33] sfc: Board support fixes Ben Hutchings
2008-12-13 5:29 ` David Miller
2008-12-12 12:48 ` [PATCH 02/33] sfc: Change SPI lengths to type size_t Ben Hutchings
2008-12-13 5:30 ` David Miller
2008-12-13 5:53 ` David Miller
2008-12-13 6:30 ` Ben Hutchings
2008-12-12 12:49 ` [PATCH 03/33] sfc: Do not use pci_disable_device() to disable bus mastering Ben Hutchings
2008-12-13 5:31 ` David Miller
2008-12-13 6:27 ` Ben Hutchings
2008-12-12 12:49 ` [PATCH 04/33] sfc: Remove unneeded register write Ben Hutchings
2008-12-13 5:31 ` David Miller
2008-12-12 12:49 ` [PATCH 05/33] sfc: Correct interpretation of second param to ethtool phys_id() Ben Hutchings
2008-12-13 5:32 ` David Miller
2008-12-12 12:50 ` [PATCH 06/33] sfc: Make reset_workqueue driver-global rather than per-NIC Ben Hutchings
2008-12-13 5:33 ` David Miller
2008-12-12 12:51 ` [PATCH 07/33] sfc: Clean up waits for flash/EEPROM operations Ben Hutchings
2008-12-13 5:33 ` David Miller
2008-12-12 12:51 ` [PATCH 08/33] sfc: Work around unreliable strap pins Ben Hutchings
2008-12-13 5:34 ` David Miller
2008-12-12 12:51 ` [PATCH 09/33] sfc: Restore phy_flash_cfg module parameter Ben Hutchings
2008-12-13 5:35 ` David Miller
2008-12-12 12:53 ` [PATCH 13/33] sfc: Don't count RX checksum errors during loopback self-test Ben Hutchings
2008-12-13 5:42 ` David Miller
2008-12-12 12:53 ` [PATCH 14/33] sfc: Remove MII extension cruft Ben Hutchings
2008-12-13 5:43 ` David Miller
2008-12-12 12:53 ` [PATCH 15/33] sfc: Add support for MMDs numbered >15 Ben Hutchings
2008-12-13 5:44 ` David Miller
2008-12-12 12:54 ` [PATCH 16/33] sfc: Add phy_type device attribute Ben Hutchings
2008-12-13 5:47 ` David Miller
2008-12-12 12:54 ` [PATCH 17/33] sfc: Clean up board identification Ben Hutchings
2008-12-13 5:48 ` David Miller
2008-12-12 12:54 ` [PATCH 18/33] sfc: Clean up MDIO flag setting Ben Hutchings
2008-12-13 5:49 ` David Miller
2008-12-12 12:54 ` [PATCH 19/33] sfc: Add support for sub-10G speeds Ben Hutchings
2008-12-13 5:50 ` David Miller
2008-12-12 12:55 ` [PATCH 20/33] sfc: Implement auto-negotiation Ben Hutchings
2008-12-13 5:50 ` David Miller
2008-12-12 12:55 ` [PATCH 21/33] sfc: Rework MAC, PHY and board event handling Ben Hutchings
2008-12-13 5:59 ` David Miller
2008-12-12 12:56 ` [PATCH 22/33] sfc: Add support for Solarflare 10Xpress SFT9001 Ben Hutchings
2008-12-13 6:00 ` David Miller [this message]
2008-12-12 12:56 ` [PATCH 23/33] sfc: Add support for SFN4111T Ben Hutchings
2008-12-13 6:01 ` David Miller
2008-12-12 12:56 ` [PATCH 25/33] sfc: Generate unique names for per-NIC workqueues Ben Hutchings
2008-12-13 6:04 ` David Miller
2008-12-13 6:23 ` Ben Hutchings
2008-12-13 6:29 ` David Miller
2008-12-13 14:01 ` Ben Hutchings
2008-12-12 12:57 ` [PATCH 26/33] sfc: Remove leading spaces Ben Hutchings
2008-12-13 6:05 ` David Miller
2008-12-12 12:57 ` [PATCH 27/33] sfc: Specify a meaningful component for loopback RX-side and PHY tests Ben Hutchings
2008-12-13 6:05 ` David Miller
2008-12-12 12:59 ` [PATCH 28/33] sfc: Use mutex_lock_interruptible() for ethtool EEPROM access Ben Hutchings
2008-12-13 6:06 ` David Miller
2008-12-12 12:59 ` [PATCH 29/33] sfc: Use model numbers for PHY type names Ben Hutchings
2008-12-13 6:07 ` David Miller
2008-12-12 13:00 ` [PATCH 30/33] sfc: Treat probe as unsuccessful if it scheduled a reset Ben Hutchings
2008-12-13 6:08 ` David Miller
2008-12-12 13:00 ` [PATCH 31/33] sfc: Use kzalloc() to ensure struct efx_spi_device is fully initialised Ben Hutchings
2008-12-13 6:09 ` David Miller
2008-12-12 12:52 ` [PATCH 10/33] sfc: Add option to use a separate channel for TX completions Ben Hutchings
2008-12-13 5:36 ` David Miller
2008-12-12 12:52 ` [PATCH 11/33] sfc: Provide hints to irqbalance daemon Ben Hutchings
2008-12-13 5:37 ` David Miller
2008-12-12 12:52 ` [PATCH 12/33] sfc: Abbreviate self-test names so they are not truncated Ben Hutchings
2008-12-13 5:42 ` David Miller
2008-12-12 12:56 ` [PATCH 24/33] sfc: Fix format arguments for warning about MSI-X allocation Ben Hutchings
2008-12-12 20:34 ` Ben Hutchings
2008-12-13 5:25 ` David Miller
2008-12-12 13:00 ` [PATCH 32/33] sfc: Fix synchronisation of efx_mtd_{probe,rename,remove} Ben Hutchings
2008-12-13 6:09 ` David Miller
2008-12-12 13:01 ` [PATCH 33/33] sfc: Version 2.3 Ben Hutchings
2008-12-13 6:10 ` David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20081212.220025.80883644.davem@davemloft.net \
--to=davem@davemloft.net \
--cc=bhutchings@solarflare.com \
--cc=linux-net-drivers@solarflare.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.