From: Steven Rostedt <srostedt@redhat.com>

Ingo Molnar suggested that the streamline_config.pl should enable
CONFIG_IKCONFIG to keep the current config in the kernel.
Then we can use scripts/extract-ikconfig to find the current
modules.

This patch changes streamline_config.pl to check if CONFIG_IKCONFIG
is not set, and if it is not, it enables it to be a module.

[ Impact: make current config options easier to find ]

Reported-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>
---
 scripts/kconfig/streamline_config.pl |   33 +++++++++++++++++++++++----------
 1 files changed, 23 insertions(+), 10 deletions(-)

diff --git a/scripts/kconfig/streamline_config.pl b/scripts/kconfig/streamline_config.pl
index caac952..2334641 100644
--- a/scripts/kconfig/streamline_config.pl
+++ b/scripts/kconfig/streamline_config.pl
@@ -256,18 +256,31 @@ my %setconfigs;
 # Finally, read the .config file and turn off any module enabled that
 # we could not find a reason to keep enabled.
 while(<CIN>) {
-	if (/^(CONFIG.*)=(m|y)/) {
-		if (defined($configs{$1})) {
-		    $setconfigs{$1} = $2;
-		    print;
-		} elsif ($2 eq "m") {
-		    print "# $1 is not set\n";
-		} else {
-		    print;
-		}
+
+    if (/CONFIG_IKCONFIG/) {
+	if (/# CONFIG_IKCONFIG is not set/) {
+	    # enable IKCONFIG at least as a module
+	    print "CONFIG_IKCONFIG=m\n";
+	    # don't ask about PROC
+	    print "# CONFIG_IKCONFIG is not set\n";
+	} else {
+	    print;
+	}
+	next;
+    }
+
+    if (/^(CONFIG.*)=(m|y)/) {
+	if (defined($configs{$1})) {
+	    $setconfigs{$1} = $2;
+	    print;
+	} elsif ($2 eq "m") {
+	    print "# $1 is not set\n";
 	} else {
-		print;
+	    print;
 	}
+    } else {
+	print;
+    }
 }
 close(CIN);
 
-- 
1.6.2.1

--