linux-next: manual merge of the usb tree with Linus' tree

[Stephen Rothwell <sfr@canb.auug.org.au>]

Hi Greg,

Today's linux-next merge of the usb tree got a conflict in
drivers/usb/musb/blackfin.c between commit
1e393c6eece048052d4131ec4dad3b98e35a98e2 ("USB: musb: blackfin: pm: make
it work") from Linus' tree and commit
ea65df57c2eea803535a071752efb030c46a11f5 ("usb: musb: remove board_data
parameter from musb_platform_init()") from the usb tree.

I fixed it up (see below) and can carry the fix as necessary.
-- 
Cheers,
Stephen Rothwell                    sfr@canb.auug.org.au

diff --cc drivers/usb/musb/blackfin.c
index fcb5206,e8cbcc5..0000000
--- a/drivers/usb/musb/blackfin.c
+++ b/drivers/usb/musb/blackfin.c
@@@ -360,33 -380,6 +360,33 @@@ static void musb_platform_reg_init(stru
  				EP2_RX_ENA | EP3_RX_ENA | EP4_RX_ENA |
  				EP5_RX_ENA | EP6_RX_ENA | EP7_RX_ENA);
  	SSYNC();
 +}
 +
- int __init musb_platform_init(struct musb *musb, void *board_data)
++int __init musb_platform_init(struct musb *musb)
 +{
 +
 +	/*
 +	 * Rev 1.0 BF549 EZ-KITs require PE7 to be high for both DEVICE
 +	 * and OTG HOST modes, while rev 1.1 and greater require PE7 to
 +	 * be low for DEVICE mode and high for HOST mode. We set it high
 +	 * here because we are in host mode
 +	 */
 +
 +	if (gpio_request(musb->config->gpio_vrsel, "USB_VRSEL")) {
 +		printk(KERN_ERR "Failed ro request USB_VRSEL GPIO_%d\n",
 +			musb->config->gpio_vrsel);
 +		return -ENODEV;
 +	}
 +	gpio_direction_output(musb->config->gpio_vrsel, 0);
 +
 +	usb_nop_xceiv_register();
 +	musb->xceiv = otg_get_transceiver();
 +	if (!musb->xceiv) {
 +		gpio_free(musb->config->gpio_vrsel);
 +		return -ENODEV;
 +	}
 +
 +	musb_platform_reg_init(musb);
  
  	if (is_host_enabled(musb)) {
  		musb->board_set_vbus = bfin_set_vbus;