Hi Javier, On Thu, 12 May 2011 10:22:20 -0700 Javier Cardona wrote: > > On Wed, May 11, 2011 at 9:56 PM, Stephen Rothwell wrote: > > On Wed, 11 May 2011 21:37:16 -0700 Javier Cardona wrote: > >> > >> On Wed, May 11, 2011 at 9:10 PM, Stephen Rothwell wrote: > >> > > >> > After merging the final tree, today's linux-next build (i386 defconfig) > >> > failed like this: > >> > > >> > net/mac80211/cfg.c: In function 'sta_apply_parameters': > >> > net/mac80211/cfg.c:746: error: 'struct sta_info' has no member named 'plink_state' > >> > >> Sorry, I just saw this.  My apologies.  The fixup is valid but I'm > >> trying to understand why it is needed. > >> ieee80211_vif_is_mesh(&sdata->vif) compiles to 'false' when > >> CONFIG_MAC80211_MESH is not defined... wouldn't the compiler remove > >> that dead code? (Obviously it did not...) > > > > The compiler will elide that code but only after compiling it, so the > > code still has to be correct. > > Thanks for the explanation. > > >> Anyway, given that this is necessary, it's probably cleaner to extend > >> the #ifdef block to the entire body of the outer if as follows: > > > > I think you have the #ifdef one line too low. > > My intent was to have the #endif one line above, but either way works. > That's the problem of preparing patches on pajamas. > How can I help at this point? Would resubmitting the patch help or > just add noise? Unless John has already fixed this, you need to send him a patch. This should be a fix patch as John doesn't normally rebase his tree (I think). -- Cheers, Stephen Rothwell sfr@canb.auug.org.au http://www.canb.auug.org.au/~sfr/